02.1 Bisglycinate vs citrate

Calcium bisglycinate vs citrate: calcium content, fill weight and the label

Technical document 02.1 · Reviewed 2026-11-18 · Calcium Bisglycinate

On this page
  1. Two salts at the same calcium figure
  2. The calcium-to-salt conversion
  3. What the fill has to hold
  4. The label and the calcium declaration
  5. The rules that do not change
  6. When to choose which

Calcium bisglycinate and calcium citrate tetrahydrate both carry about 21% elemental calcium, so a 200 mg label claim needs roughly 0.9–1.0 g of either salt. The fill weight is therefore not the deciding difference. The declared ingredient, the ligand, the water the powder brings and the identity file are what change when a formula switches. The conversion still matters, because the bisglycinate catalog range is wider and the batch COA's calcium result sets the actual fill.

In one line

At about 21% calcium, the two salts need nearly the same mass for the same claim; the label and the file, not the fill weight, decide the switch.

Two salts at the same calcium figure

Calcium bisglycinate and calcium citrate tetrahydrate, compared
ItemCalcium bisglycinateCalcium citrate tetrahydrate
FormulaC4H8CaN2O4C12H10Ca3O14·4H2O
CAS number136-26-5813-94-5
Calcium, catalog range18.5–23.0% (EDTA)21.0–22.0% (EDTA)
Calcium, stoichiometric21.3%21.1%
Water of crystallisationNone in the formulaAbout 12.6%
Salt mass for 200 mg calcium870–1,081 mg909–952 mg
Label nameCalcium bisglycinateCalcium citrate
Identity testInfrared spectrum and glycine reactionCitrate reaction and infrared spectrum

The calcium-to-salt conversion

The arithmetic is a division: salt mass = calcium claim ÷ calcium fraction. For 200 mg calcium, the bisglycinate at its 21.3% stoichiometric figure needs 939 mg, and the citrate tetrahydrate at 21.1% needs 948 mg. The two are within 1% of each other, which is why a switch does not resize the capsule on its own.

The catalog ranges move the figure more than the choice of salt does. The bisglycinate range of 18.5–23.0% gives 870–1,081 mg for a 200 mg claim, a spread of about 24%. The citrate range of 21.0–22.0% gives 909–952 mg, a spread of about 5%. Use the batch COA's calcium result for the fill calculation, not the midpoint of the catalog range, and confirm the finished-product assay after compression or encapsulation.

At a 500 mg claim the masses are 2.17–2.70 g of bisglycinate or 2.27–2.38 g of citrate. That is a stick-pack or a tablet-weight decision, and it is the point at which the density difference starts to matter as much as the mass.

What the fill has to hold

A 500 mg capsule fill of the salt carries about 105 mg calcium at 21%, so a 200 mg claim needs two capsules and a 500 mg claim is not a single capsule. A 1,000 mg tablet fill carries about 210 mg calcium, so a 200 mg claim fits one tablet and a 500 mg claim needs two or three, before the excipients are counted. The salt mass is only one term in the fill; the excipient load and the tooling set the rest.

Bulk density separates the two powders in the package. The bisglycinate catalog density is 0.50–0.80 g/mL and the citrate is 0.60–0.95 g/mL, so the citrate tends to occupy less volume for the same mass. A stick pack or a capsule that was sized for one powder may not fit the other at the same fill weight, even though the calcium claim is unchanged. Confirm the density on the lot and trial the fill before the package is ordered.

The water load is the other fill difference. Calcium citrate tetrahydrate carries about 12.6% water in the crystal, which is why its loss-on-drying limit is 13.0%; the bisglycinate limit is 5.0%. In a gummy or a low-moisture tablet, that water changes the matrix and the drying step, and it is a reason to re-run the stability work after a switch.

The label and the calcium declaration

The declared ingredient is the first thing that changes. The EU list names calcium bisglycinate and calcium citrate; the label has to use the listed name, and the certificate has to show the identity test that belongs to that name. A calcium citrate certificate cannot support a bisglycinate label, and a bisglycinate certificate cannot support a citrate label, even when the calcium figures are the same.

The calcium declaration is arithmetic against the reference value. In the EU and the UK the calcium nutrient reference value is 800 mg, and the source-of condition for a calcium claim is 120 mg in the daily portion. In the US the Daily Value is 1,300 mg. The percentage changes with the salt only through the amount of calcium in the portion, not through the form; a 200 mg portion is 25% of the EU reference value and about 15% of the US Daily Value, whichever salt supplies it.

The rules that do not change

Both salts are permitted calcium sources for food supplements in the EU and Great Britain, and both can be sold as dietary ingredients in the US. The permission is form-specific: the form on the label has to be the form on the list or the form supported by the US ingredient file. A switch from citrate to bisglycinate is a change of ingredient, not a change of grade, and the file has to be rebuilt around the new identity test.

The contaminant limits do not change with the salt. Lead, cadmium and mercury are limited in the finished supplement, and the ingredient's contribution is calculated from the dose. What changes is the identity file, the loss-on-drying limit and the specification lines that the buyer has to hold.

When to choose which

Choose the bisglycinate when the label needs the chelate, the formula is built around the glycine salt, or the buyer's specification calls for the calcium-to-glycine ratio. Choose the citrate when the label, the supplier and the tooling are already citrate and the calcium figure is the only argument for moving; at about 21% each, the move gains little in mass and requires a new specification, a new identity test and a new label.

Choose neither when the goal is the highest calcium load per gram. Calcium carbonate carries about 40% calcium and is the high-load comparison; the citrate versus carbonate page sets out that arithmetic. And if the only goal is a chelate claim, the citrate cannot carry it; the form has to match the claim.

The catalog specification is published on the calcium bisglycinate product page. The two salts are compared at specification level on the salt comparison page, the certificate lines are read on the COA page, and the identity tests are on the identity page. The citrate specification is on the calcium citrate product page.

Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.

Request a quotation