02.1 Citrate vs carbonate

Calcium citrate vs carbonate: elemental calcium, acid and the label

Technical document 02.1 · Reviewed 2026-11-18 · Calcium Citrate

On this page
  1. Elemental calcium, converted
  2. The acid reaction
  3. What the mass does to the dosage form
  4. What the label must name
  5. Choosing between them
  6. Specifying either salt

Calcium citrate tetrahydrate is 21.0–22.0% calcium and calcium carbonate is about 40%, so a 500 mg calcium claim needs about 2.3 g of the citrate or 1.25 g of the carbonate. The citrate dissolves in acid without gas, the carbonate effervesces, and the label must name whichever salt is in the drum. Those three facts — mass, acid and source — decide most switches between the two.

In one line

Citrate carries about 21% calcium and carbonate about 40%, so the same label claim needs roughly twice the citrate mass, and the acid response differs.

Elemental calcium, converted

The conversion is simple arithmetic, and it is where most label errors start. Divide the label claim by the calcium fraction of the salt. At 21.5% calcium, 500 mg of calcium needs 500 ÷ 0.215 = 2,326 mg of calcium citrate tetrahydrate. At 40.0%, the same claim needs 1,250 mg of calcium carbonate. The same sum at 200 mg gives 930 mg and 500 mg.

Salt mass for a calcium label claim
Label claimCitrate tetrahydrate, 21.5%Anhydrous citrate, 24.1%Carbonate, 40.0%
100 mg Ca465 mg415 mg250 mg
200 mg Ca930 mg830 mg500 mg
500 mg Ca2,326 mg2,075 mg1,250 mg
800 mg Ca (EU reference intake)3,721 mg3,320 mg2,000 mg

Read the table from the label backwards. A 1,000 mg tablet of calcium citrate carries about 215 mg calcium; a 1,000 mg tablet of calcium carbonate carries about 400 mg. A capsule that holds 600 mg of citrate powder carries about 129 mg calcium and needs four capsules for a 500 mg claim. The salt weight, not the label claim, is what the press and the capsule filler see.

Round only at the end. Anhydrous citrate is about 24.1%, and a lot at the low end of the tetrahydrate window is 21.0%. Using 21.5% as a planning figure is reasonable; using it as a specification is not.

The acid reaction

Calcium carbonate reacts with acid: CaCO3 + 2 HCl → CaCl2 + CO2 + H2O. In a stick or a tablet the carbon dioxide is visible as fizz; in a sealed container it is pressure, and in a tablet it can lift the grain. Calcium citrate dissolves in dilute acid without gas, because it contains no carbonate to release carbon dioxide. In a slurry, the carbonate consumes acid and raises the pH as it dissolves; the citrate buffers instead.

Taste follows the chemistry. Carbonate is chalky and drying, and it can leave a gritty mouthfeel at high dose. Citrate is saline and sour, and the sour note grows with the dose. In a capsule neither is noticeable; in a chew, a gummy or a stick the difference decides whether the format is acceptable.

The acid response also sets the format. An effervescent tablet needs carbonate. A clear acidic drink can use citrate, but its solubility is low and the acidulant has to be tuned. A gummy with an acidulant will react with carbonate during cooking, so either the gas is managed or the salt changes.

What the mass does to the dosage form

Mass drives the unit count. At 500 mg calcium, the citrate is 2.3 g of powder and the carbonate is 1.25 g. A size 00 capsule holds roughly 600–700 mg, so the citrate claim is three to four capsules and the carbonate claim is two. A tablet press can make a 2.3 g tablet, but it is a large one; the carbonate fits a conventional 1.25 g tablet with room for excipients.

Sticks carry the mass more easily than capsules. A 2.3 g citrate dose plus flavour and sweetener is a normal stick weight; the same stick with carbonate would carry 1.25 g of salt and need more excipient to fill the same weight. Suspensions behave differently again: the citrate settles more slowly than a dense carbonate, but both need a thickener and a resuspension test.

Choose the format before choosing the salt. If the product is a two-capsule serving, carbonate has the mass advantage. If it is an effervescent tablet, carbonate is the only one that fizzes. If it is a high-dose stick with an acidic flavour, citrate fits the chemistry and the taste.

What the label must name

In the European Union the ingredient list names the calcium source from Annex II to Directive 2002/46/EC, and calcium is declared in milligrams and as a percentage of the 800 mg reference intake. In the United States the Supplement Facts panel declares elemental calcium against a 1,300 mg Daily Value, and the ingredient list names the salt. The United Kingdom uses the 800 mg reference intake in its retained nutrition labelling.

The source name is not interchangeable. A product made with calcium carbonate cannot declare calcium citrate, and a blend must name both sources. If the salt changes and the powder weight stays the same, the calcium figure moves by nearly a factor of two; if the calcium claim stays the same, the powder weight moves. Either change needs a new label and a new batch record.

A source claim on the front of the pack should match the ingredient list. “Made with calcium citrate” is a statement about the source; if carbonate is also present, the front and the ingredient list disagree. The reference intake entry explains how the percentage is calculated.

Choosing between them

When each salt fits the brief
SituationCitrateCarbonate
High calcium claim in few unitsMore mass, more unitsAbout 40% Ca, compact
Effervescent tabletNo gasSupplies the carbon dioxide
Acidic drink or stickDissolves without fizz; sour noteReacts, foams, chalky
Chalky taste unacceptableSaline-sourChalky
Non-acidic matrixTrial the pHTrial the pH and the gas
Label must name citrateThe only optionCannot be substituted

The table is a starting point for a trial, not a rule. What must not happen is a silent substitution: the label, the specification and the certificate have to name the same salt.

Specifying either salt

Write the citrate specification with the hydrate and the mesh: “Calcium citrate tetrahydrate, 21.0–22.0% Ca by complexometric EDTA; assay not less than 97.5% on the dried basis; loss on drying not more than 13.0%; citrate identification by reaction and IR; not less than 95% through 80 mesh; bulk density 0.60–0.95 g/mL; Pb ≤3, As ≤2, Cd ≤1, Hg ≤0.1 mg/kg.”

For the carbonate, write its own calcium window, its own loss on drying and its own acid reaction. Add a clause that names the salt and excludes substitution: “Calcium carbonate; no calcium citrate or calcium oxide added.” The same clause in reverse belongs in the citrate specification.

Switching salts is a change control, not a purchasing choice. Re-run the fill weight, the taste, the pH and the label; then reissue the specification. The certificate for the new salt will not match the old specification.

The grade page covers the wider choice of hydrate and mesh; the COA page lists the release limits; the compliance page covers the source list and the label rules; the product hub carries the catalog specification.

Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.

Request a quotation