How we prove a lot is alpha-ketoglutaric acid
A lot is the free acid when the certificate names CAS 328-50-7, the HPLC retention and IR spectrum match the reference, calcium stays at or below the reporting limit, and the assay and water balance. None of those checks is sufficient alone; the assay in particular cannot separate the acid from calcium α-ketoglutarate or from a diluted lot.
Four independent readings have to agree before the name is safe: the chromatogram, the IR spectrum, the calcium figure and the water result.
Four separate checks
A name on a certificate is paperwork. The powder behind it has to answer four separate questions, and each one needs a different measurement. Suppliers often answer the first and stop.
| Check | What it settles | How it is read | Result that supports the name |
|---|---|---|---|
| Paper | Which form is declared | Name, CAS and formula on the sheet | A statement, not a measurement |
| Chromatography | Whether the keto acid is present | Retention time and IR bands | A match to the reference |
| Counter-ion | Whether the salt is absent | Calcium by ICP-OES | At or below the reporting limit |
| Balance | Whether the lot is diluted | Assay, water, impurity peaks | Figures that add up |
A matching chromatogram and a near-zero calcium figure together are stronger than either alone. The water result then says whether the assay was expressed on a dry or an as-is basis.
The calcium ratio: proving the free acid
Calcium is the form check that is easiest to add. The free acid contains none; the calcium salt contains about 21.8% in the anhydrous form. A lot sold as the acid should return calcium at or below the method's reporting limit, and one sold as the salt should return a figure that agrees with its formula and its water content. A physical blend of the two falls somewhere between.
ICP-OES sits outside the catalog specification. Call for it when the form is contested, during source qualification, or when label and certificate name different forms. Get the reporting limit with the result; “less than” is meaningless without the number attached to it.
Solution pH supports the calcium figure. The acid reads 2.0–3.0 at 5%, and a calcium salt solution is less acidic at the same strength; pH is not quantitative because concentration and residual acid move it. IR adds a structural check: the carbonyl region of a carboxylic acid differs from that of a carboxylate, so a match to an acid reference also argues against the salt.
X-ray diffraction and the solid form
Diffraction asks about the solid, not the solution: is the powder crystalline, and does the pattern fit a reference? It separates a crystalline acid from an amorphous blend and lets two sources be compared. Purity and the counter-ion are outside what it measures. Read the reference pattern, not just the word “match”.
In a dispute, diffraction, calcium, HPLC and IR together carry more weight than any single result. It is not a routine release test here, and “XRD conforms” without a pattern says almost nothing.
How substitution shows up
| Adulterant | What it does | Signal | Test |
|---|---|---|---|
| Calcium salt | Adds calcium; makes the solution less acidic | Calcium near 21.8%; higher pH | ICP-OES, pH, IR |
| Succinic or malic acid | A common bulk acid with similar handling | Low assay or an extra HPLC peak | HPLC, IR |
| Bulking agent | Dilutes the acid | Assay low; water or ash high | Mass balance |
| Water | Lowers the as-is assay | Water high; dry-basis assay normal | Karl Fischer |
| Another keto acid | Similar carbonyl chemistry | Retention or IR mismatch | HPLC, IR, NMR |
Appearance proves almost nothing: white crystalline powder covers a wide family of materials, and a recrystallised blend can match it. The calcium figure, the IR spectrum and the balance are the readings that matter.
Identity clauses for the specification
- “α-Ketoglutaric acid, CAS 328-50-7, C5H6O5.”
- “Assay 98.0–102.0% by HPLC, basis stated on the certificate.”
- “Identification by IR and by HPLC retention against a reference.”
- “Water ≤1.0% by Karl Fischer; pH 2.0–3.0 for a 5% solution.”
- “Calcium by ICP-OES at or below the reporting limit for the acid form.”
- “Heavy metals and microbiology as per the catalog specification.”
- “Pack, storage condition and destination recorded before the order.”
Five questions to put to the supplier
- Which form and which CAS number does this lot's certificate carry?
- What do the chromatogram and IR spectrum show for this lot?
- What calcium result did ICP-OES return, and what is the reporting limit?
- How much water did the lot carry, and against which basis was the assay expressed?
- Would you agree to a joint re-test of the retained sample if the lot is disputed?
An identity file is these five answers taken together, not one assay figure on its own. The catalog specification and the form are on the product hub; the certificate line by line is on the COA page; the form comparison is on the grades page; the label consequences are on the level-four comparison; the separation is explained in the HPLC method note.
Related documents
Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.
Request a quotation