Magnesium acetate vs magnesium citrate: taste, solubility and the label
Magnesium acetate and magnesium citrate are different salts, not two grades of one material. The acetate is freely soluble and carries a salty, vinegar-like note; the citrate is soluble, reads tart and lemony, and buffers over a wider pH range. At the same elemental magnesium dose the acetate needs more powder, and the label must name the salt that is actually in the formula.
The two salts deliver the same mineral with different counter-ions: acetate dissolves faster and tastes of vinegar, citrate is tart and buffers better, and the label must name the one that is actually in the powder.
Two salts, two identities
The catalog acetate is the tetrahydrate, C₄H₆MgO₄·4H₂O, CAS 16674-78-5. The catalog citrate is the anhydrous salt, C₁₂H₁₀Mg₃O₁₄, CAS 3344-18-1. The formulas explain the first practical difference: two acetate ions balance one magnesium ion, while two citrate ions balance three magnesium ions. The citrate salt therefore carries more magnesium per gram of salt, and the acetate carries more water per gram of powder.
| Property | Magnesium acetate | Magnesium citrate |
|---|---|---|
| Formula | C₄H₆MgO₄·4H₂O | C₁₂H₁₀Mg₃O₁₄ |
| CAS number | 16674-78-5 | 3344-18-1 |
| Magnesium | 11.0–12.5% | 14.5–16.4% |
| Water | 25.0–30.0% by Karl Fischer | ≤2.0% loss on drying |
| Counter-ion | Two acetate ions per magnesium | Two citrate ions per three magnesium |
| Taste | Salty, with a vinegar note | Tart and lemony |
| Label name | Magnesium acetate | Magnesium citrate |
| Typical format | Capsules, tablets, powder blends | Capsules, sticks, drink mixes |
The table is a starting point, not a ranking: both are legitimate magnesium sources, and the choice turns on dosage form, taste and label.
Solubility and the solution
Both salts dissolve in water, but not in the same way. Magnesium acetate is freely soluble; it goes into solution quickly and stays there at the concentrations used in a concentrate or a stick pack. Magnesium citrate is soluble as well, but its solubility and its taste depend on the hydrate grade and on the pH. The anhydrous grade is the one specified on this site; the nonahydrate is a different mass per dose.
Acetate is the conjugate base of a monoprotic weak acid with a pKa near 4.76, so it buffers in a narrow window around that pH. Citrate has three acid constants and buffers across a wider range, which is why a citrate drink can hold its pH through a fruit system more easily. That buffering is a formulation property, not a reason to switch; it changes the acid, the sweetness and the flavour balance around the salt.
At high load, the acetate solution is the easier one to keep clear. The citrate solution can become cloudy or slow to dissolve when the concentration rises or the pH moves; trial the intended concentration rather than the powder’s solubility in water alone. For a clear, high-load concentrate the acetate is simpler; for wider pH stability the citrate brings buffer capacity.
Taste at the dose, not in a beaker
The taste difference starts with the counter-ion. Acetate has a vinegar note, strongest when the pH is low enough for a meaningful fraction of acetic acid to be present; at neutral pH it is milder but still there. Citrate reads tart and lemony, and becomes more sour as the pH falls. Both salts carry the bitterness of the magnesium ion, which grows with dose and is not removed by either counter-ion.
In a capsule or a tablet, taste is irrelevant. In a stick pack, a chew or a drink, the matrix decides. A fruit flavour can carry the citrate’s acidity; a milder or savoury system may carry the acetate better. Sweeteners change the balance: a high-intensity sweetener can make the vinegar note more obvious by removing the sugar that would round it off. Trial the finished matrix at the label dose, not a 1% solution.
The dose is the other half of the taste question. A 50 mg magnesium stick may taste clean with either salt; at 200 mg the counter-ion becomes a flavour of its own. If the label dose is high and the flavour system is delicate, the choice of salt belongs in the sensory trial, not in a later reformulation.
Mass per dose and the capsule
The magnesium figure sets the mass. At 11.0–12.5% magnesium, 100 mg of the element needs roughly 800–909 mg of acetate powder; at 14.5–16.4%, the citrate needs roughly 610–690 mg. The acetate dose therefore carries more powder and more counter-ion per milligram of magnesium. In a 500 mg capsule, the acetate delivers about 55–62.5 mg of magnesium, and the citrate about 72.5–82 mg.
That difference decides the dosage form. A high-dose capsule or a small tablet is easier with the citrate, which packs more magnesium per milligram. A stick pack or a drink can afford the larger acetate mass and gains from its solubility. The acetate grades page sets out the hydrate arithmetic, and the citrate grades page does the same for the anhydrous and nonahydrate forms.
Both figures are estimates. The capsule trial, the bulk density of the lot and the certificate decide the final fill, and a change of salt needs a new fill weight rather than a note in the batch file.
What the label has to say
The label names the salt, not the mineral alone. In the EU, the ingredient list uses the permitted name for the magnesium source, and the nutrition declaration reports magnesium in mg and as a percentage of the 375 mg NRV. In the US, the Supplement Facts panel reads “magnesium (as magnesium acetate)” or “magnesium (as magnesium citrate)”, and the magnesium daily value is 420 mg. A formula that switches salt without changing the panel is mislabelled even when the magnesium number is unchanged.
The hydrate state is a specification term rather than a label term for the acetate, but it changes the mass per dose and therefore the nutrition calculation. For the citrate, the anhydrous and nonahydrate grades carry different magnesium percentages, so the grade belongs in the specification and the label review. The compliance page covers the permitted-source and claim checks in more detail.
A flavour name is not a salt name. “Lemon” on the front does not make the product citrate, and “vinegar” does not make it acetate. The ingredient list is the record, and it has to match the certificate the buyer keeps on file.
When to choose which
Choose the acetate for a clear, fast-dissolving solution where the vinegar note fits the flavour, and for a capsule or tablet where the larger mass is acceptable. Choose the citrate for a smaller capsule, a tart drink or a system that needs buffer capacity across a wider pH range. If the label already names one salt, the other is a change control, not a substitution.
Both salts are legitimate magnesium sources; the choice is a taste, mass and label decision. Trial the matrix, check the certificate for the hydrate and the magnesium figure, and write the salt name into the specification before the first order. The magnesium acetate hub and the magnesium citrate hub carry the two specifications; the analytical methods library and the complexometric method note explain the magnesium assay; the quality page describes the release file.
Related documents
Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.
Request a quotation