02.1 MK-4 vs MK-7

MK-4 vs MK-7: dose, label and the market file

Technical document 02.1 · Reviewed 2026-11-19 · Vitamin K2 MK-4

On this page
  1. Two side chains, one ring
  2. The dose is where the difference becomes practical
  3. Source and the impurity that follows it
  4. What the label has to say
  5. The entry names MK-7, not MK-4
  6. What changes when you switch

MK-4 and MK-7 are the same vitamin K family with side chains of four and seven isoprene units: C31H40O2 at about 444.66 g/mol and C46H64O2 at about 649.02 g/mol. The chemistry differs by two isoprene units; the practical difference is the dose. MK-4 is used at 5–45 mg, MK-7 at 90–180 µg, a gap of 250 to 500 times, and that gap drives the grade, the label, the analytical method and the market file.

In one line

MK-4 and MK-7 are the same vitamin K2 family at doses several hundredfold apart, so the form, the label and the market file change together.

Two side chains, one ring

Both molecules share the methylnaphthoquinone ring that makes them vitamin K2. What differs is the polyisoprene side chain: four units in MK-4, seven in MK-7. Each unit adds C5H8, so the longer chain raises the molecular weight by about 204 g/mol, makes the molecule more lipophilic and moves it later on a reversed-phase column. Both are fat-soluble, practically insoluble in water and sensitive to light.

Menaquinone-4 and menaquinone-7 side by side
PropertyMK-4MK-7
FormulaC31H40O2C46H64O2
Molecular weightAbout 444.66 g/molAbout 649.02 g/mol
Side-chain unitsFour isoprene unitsSeven isoprene units
CAS number863-61-62124-57-4
Identity markerMenadione and related substancesall-trans and cis isomer ratio
Usual commercial grade98% crystalline powder1% spray-dried powder

A longer chain is not a higher grade; the two are separate materials with separate specifications. A certificate written for one homologue does not release the other, and each method needs its own standard and impurity profile.

The dose is where the difference becomes practical

MK-4 doses sit in milligrams and MK-7 doses in micrograms. A 45 mg MK-4 capsule and a 90 µg MK-7 capsule both say “vitamin K2”, and the first carries 500 times the mass of the second. There is no official conversion factor that turns one into the other; the molecular-weight ratio of about 0.685 converts mass on a molar basis, not a dose.

The same declaration in two menaquinones
FigureMK-4MK-7
Usual daily dose5–45 mg90–180 µg
The 45 mg dose in micrograms45,000 µg90 µg is the low end
Share of the EU reference value (75 µg)60,000%120%
Pure menaquinone needed45.9 mg at 98%0.093 mg at 97%
Weight of the usual grade45.9 mg of powder9 mg of 1% powder

The last two rows explain why the grades differ. A 45 mg MK-4 dose is weighed as tens of milligrams of the isolated powder, which is a normal capsule fill. A 90 µg MK-7 dose is 0.09 mg of the pure material, which is not weighable on a production line, so MK-7 is normally supplied as a 1% powder and the dose becomes 9 mg of powder. The grade follows the dose, not the other way round.

The label percentage follows the same arithmetic. At 45 mg, an MK-4 product would declare 60,000% of the EU vitamin K reference value; at 90 µg, an MK-7 product declares 120%. That is not a formatting problem. It is a signal that the two products sit at different dose levels and may sit under different regulatory routes.

Source and the impurity that follows it

The commercial MK-4 is a synthetic menaquinone. Menadione is the starting material, and the side chain is built onto it, so residual menadione and related substances are the impurities to specify. MK-7 is supplied from a synthetic route or from Bacillus subtilis fermentation, including the natto strain; its characteristic quality question is the all-trans to cis ratio, because the long chain can isomerise.

That difference reaches the specification. An MK-4 specification needs a menadione limit and a related-substances limit; an MK-7 specification needs an all-trans floor, a cis ceiling and a limit for other menaquinones. A supplier who sends one certificate for “vitamin K2” has not said which of the two materials was made, and the impurity profile is the quickest way to tell.

What the label has to say

In the EU, the MK-7 ingredient is named “Menaquinone” or “Vitamin K2” under the novel-food entry, while an MK-4 ingredient is labelled under the vitamin rules for the destination; the form still has to be declared. In the US, the Supplement Facts panel carries the form in parentheses: “Vitamin K (as menaquinone-4)” or “Vitamin K (as menaquinone-7)”. In both markets the amount is a mass of the named menaquinone, in micrograms.

“Vitamin K2” on its own names neither. A label that says only vitamin K2 leaves the form to the ingredient list, and a label that names MK-7 while the certificate reports MK-4 has an error on the label before it has one in the drum. The carrier or the oil belongs in the ingredient list, not in the name of the vitamin.

The entry names MK-7, not MK-4

The EU Union list entry for vitamin K2 (menaquinone) is built on MK-7: 97–102% MK-7, at least 92% all-trans and no more than 6.0% cis isomers. Its specification describes the homologous series, but the authorised material and the limits are set for MK-7; the route for an MK-4 ingredient is a separate question for the buyer's regulatory team. In the US, the dietary-ingredient basis is ingredient-specific, and the supplier should say whether the ingredient was on the US market before 15 October 1994 or is backed by a notification. The UK checks its own retained list.

Japan is the market with the longest MK-4 record: menatetrenone is dosed there at 45 mg per day as a medicinal product, and the food and supplement routes are separate. That dose level is the clearest illustration of the gap between the two menaquinones, and it is not interchangeable with an MK-7 supplement dose.

What changes when you switch

A switch changes the specification, the reference standard, the impurity profile, the dose, the label, the pack and the market file. A 1 kg pouch of 98% MK-4 carries about 980 g of the menaquinone; a 1 kg pouch of 1% MK-7 carries about 10 g. The same pack size is a different quantity of active material, and the dose count differs with it.

A switch deserves a new specification and a new label review, not an amended purchase order. Write a new specification, check the label against the destination, and confirm the route before the first order. The MK-4 product page carries the specification, the MK-7 product page the sister material, and the vitamin K1 page the phylloquinone case. For the grade decision see the MK-4 grade page; the separation is described in the methods library and the release file on the quality page.

Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.

Request a quotation