06 Identity & adulteration

How we prove a vitamin E lot is the acetate

Technical document 06 · Reviewed 2026-11-18 · Vitamin E

On this page
  1. The four layers of the identity file
  2. The potency arithmetic, and where it stops
  3. What XRD and infrared can, and cannot, show
  4. The routes that put another material in the drum
  5. How to write the specification
  6. Five questions for the supplier

A vitamin E lot is identified in four layers: the documents and the lot chain, the chromatographic identity against a tocopheryl acetate standard, the potency arithmetic that ties the assay to IU, and the carrier and mass balance that describe the powder. A retention time is the centre of that file, but on its own it does not separate the acetate from the free tocopherol, the succinate or a diluted powder. The layers have to agree before the lot is called the acetate.

In one line

A retention time alone does not prove the acetate; the ester, the isomer, the potency and the carrier have to agree.

The four layers of the identity file

What each identity layer proves, and what it cannot prove alone
LayerEvidenceWhat it leaves open
DocumentsCAS 7695-91-2, form, lot code, specification version, packA correct paper file can describe another drum
ChromatographyHPLC retention time and spectrum against a tocopheryl acetate standardA co-eluting substance or a different ester
PotencyAssay percentage, IU per gram, calculation at 1 mg = 1 IUFree tocopherol can land in the same IU window
FormulationCarrier, loss on drying, dispersibility, particle sizeWhether the oil is the declared ester

The layers are not alternatives. A certificate can be genuine and still belong to a different lot; a chromatogram can be genuine and still be run on a standard that is not the acetate; a potency figure can be right and still describe the wrong molecule. The file is complete when the four agree with each other and with the drum.

The potency arithmetic, and where it stops

The assay reports tocopheryl acetate as a mass fraction. At 1 IU per milligram of the dl-acetate, 50.0–55.0% is 500–550 IU/g. That checks the internal consistency of the certificate: a sheet that prints 52% and 500 IU/g does not reconcile at the dl-acetate factor, and a sheet that prints 52% and 707 IU/g is describing the natural d-acetate at 1.36 IU/mg. The arithmetic catches a mismatched form before a sample is opened.

It stops short of identity. Free dl-alpha-tocopherol carries about 1.1 IU/mg, so a 50% tocopherol powder reads about 550 IU/g — the same figure as a 55% acetate lot. A succinate at 50% reads about 445 IU/g for the synthetic form and about 605 IU/g for the natural one. The IU windows overlap, and the 50.0–55.0% assay window is wide enough to absorb the difference. Potency narrows the question; the chromatogram and the ester test answer it.

The mass balance is the second arithmetic check. At 50% acetate, the carrier and moisture make up the other half; at 55%, a little less. If the certificate reports 50% acetate, 20% carrier and 5% moisture, the reader should ask what the remaining 25% is. A declared carrier that does not close the balance is a formulation to explain, not a rounding difference.

What XRD and infrared can, and cannot, show

X-ray diffraction is the wrong primary test for this powder. The acetate is a liquid carried on modified starch, and the powder is largely amorphous; XRD sees crystalline excipients, mineral fillers or a crystalline sugar, not the ester. A diffraction pattern can confirm that a crystalline solid is present, and it can screen for an unexpected crystalline component, but a clean pattern does not prove the acetate.

Infrared spectroscopy is more useful. The acetate ester has a carbonyl band near 1,740 cm⁻¹, the free tocopherol has a phenolic O–H and no ester carbonyl, and the succinate has an acid O–H with a different carbonyl pattern. A saponification step then releases the acid: acetic acid from the acetate, succinic acid from the succinate. The ester test and the chromatogram together are the chemical identity; XRD is a supporting check on the solid matrix.

The fourth layer is the isomer. Natural d-alpha and synthetic dl-alpha have the same chromatographic retention on an achiral column, so the distinction needs a chiral separation or a specific-rotation measurement after hydrolysis. A certificate that claims the natural form without one of those tests is making a paper statement, not an analytical one.

The routes that put another material in the drum

Adulteration routes for a vitamin E 50% powder and the marker for each
RouteWhy it can pass a quick checkWhat shows it
Free tocopherol instead of the acetateClose IU per gram at 50–55%Retention time, infrared ester band, saponification
Succinate instead of the acetateSame vitamin, similar powderDifferent retention, acid release, IU factor
Dilution below 50%Assay still inside a loose specificationAssay, carrier proportion, mass balance
Natural labelled as synthetic, or the reverseSame retention on an achiral columnChiral analysis, specific rotation, IU factor

The motive in each row is the same: to sell a different or more available material under a specification written for the acetate. The defences are also the same: a standard that names the ester, a method that separates it from the neighbours, and a mass balance that closes. A certificate that reports only “vitamin E 50%” gives the buyer no line to check.

How to write the specification

Write the identity into the specification rather than the title: “DL-alpha-tocopheryl acetate 50% water-dispersible powder; tocopheryl acetate 50.0–55.0% by HPLC, expressed on the as-sold basis; 500–550 IU/g; carrier modified starch and silicon dioxide, declared; loss on drying ≤5.0%; 100% through 40 mesh; dispersible in cool water; Pb ≤3, As ≤2, Cd ≤1, Hg ≤0.1 mg/kg; APC ≤1,000 cfu/g, yeast and mould ≤100 cfu/g, E. coli and Salmonella absent.”

The form, the isomer and the basis are the three lines that stop a substitution. If the specification says only “vitamin E 50% powder”, a tocopherol or a succinate can be offered against it without a word being untrue. If it names the acetate, the standard and the IU factor, the certificate has to answer the identity question line by line.

Five questions for the supplier

  1. Which ester and which isomer is the lot — dl-alpha-tocopheryl acetate or something else?
  2. Which standard was the HPLC run against, and can the chromatogram be sent with the certificate?
  3. Does the assay reconcile with the IU figure at 1 IU per milligram, and on what basis is the percentage reported?
  4. What are the carrier, its proportion and the loss on drying for this lot?
  5. Is there any chiral or specific-rotation data, and what does it show about the d and dl forms?

Five direct answers amount to an identity file. The COA page shows where each figure sits on the certificate; the grade page places the acetate among the other forms; the acetate versus succinate page separates the two esters; the compliance page covers the label name. The chromatographic method is described in the HPLC note and the spectroscopic check in the FTIR note.

Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.

Request a quotation