Choosing a magnesium orotate grade: the salt, the hydrate and the fill
Magnesium orotate is one of several magnesium salts, and at 6.4–6.8% elemental magnesium it is one of the lowest-percentage common choices: a 100 mg magnesium dose needs about 1.5 g of the dihydrate. The grade question is a salt question first, among orotate, citrate, lactate and oxide, and a particle question second. The hydrate and the mesh belong in the specification, not in the packing notes.
At 6.4–6.8% magnesium, orotate needs about 1.5 g of powder per 100 mg of the element, so the grade choice is a fill-weight decision before it is a label decision.
The label names two different masses
The label names the salt in the ingredient list and declares magnesium in the nutrition panel. Those are two statements about two different masses. Magnesium orotate is the magnesium salt of orotic acid, a pyrimidine carboxylic acid, in a 1:2 ratio: two orotate anions for each magnesium ion. The dihydrate formula is C10H6MgN4O8·2H2O, and the molar mass is about 370.5 g/mol.
Only 6.56% of that mass is magnesium; the rest is the orotate and the water of crystallisation. A purchase order that says “magnesium” has selected the nutrient but not the ingredient, and two salts that both answer to that word can differ by a factor of two or more in the powder needed for the same label claim.
Orotate against the other magnesium salts
| Salt | Elemental Mg | Powder per 100 mg Mg | Water solubility | Usual fit |
|---|---|---|---|---|
| Magnesium orotate, dihydrate | 6.4–6.8% | About 1,470–1,560 mg | Slightly soluble | Capsules, tablets |
| Magnesium citrate, anhydrous | 14.5–16.4% | About 610–690 mg | Soluble | Capsules, tablets, sticks |
| Magnesium citrate, nonahydrate | About 11.9% | About 840 mg | Soluble | Sticks, beverages |
| Magnesium oxide | 57.0–60.0% | About 167–175 mg | Practically insoluble | Tablets, capsules |
The table compares the element and the mass, not a health effect. The orotate's low percentage is not a defect; it is the arithmetic of a large organic counter-ion. The citrate and the lactate dissolve more readily, and the oxide is the most concentrated and the least soluble. The magnesium lactate page carries that specification, and the citrate page carries the other.
Flow, mesh and the suspension
The catalog grade is a 40 mesh powder: at least 95% passes a 425 µm sieve. Mesh is a flow and blending property, not a purity ranking. The catalog does not fix a bulk density, so ask for the lot figure: two powders at the same mesh can fill a capsule die differently.
Solubility is the physical line that separates orotate from citrate and lactate. The dihydrate is only slightly soluble in water, so a dispersion is a suspension, not a solution. In a capsule or tablet, the sediment question does not arise; in a stick pack it is visible unless the grade is milled finely and the formula is built as a suspension. Granulation is available on request and changes the flow and the dust, not the salt.
From dose to fill weight
The calculation starts with the elemental target and divides by the magnesium fraction. At 6.6%, 100 mg of magnesium needs about 1,515 mg of dihydrate; at the edges of the range the figure runs from about 1,470 to 1,560 mg. A 500 mg capsule therefore carries only about 32–34 mg of magnesium, and a 1,000 mg tablet carries about 64–68 mg.
That arithmetic decides the format. A 100 mg claim needs roughly 1.5 g of orotate, which is two to three size 00 capsules or a large tablet; the same claim from anhydrous citrate is about 0.62 g and from the nonahydrate about 0.84 g. In a stick pack the orotate mass fits, but the low solubility has to be designed around. The orotate versus citrate page works the comparison through dose by dose.
Specification lines for the dihydrate
Build the specification around the dihydrate and the two assays, not around a generic magnesium figure.
- “Magnesium orotate dihydrate, CAS 34717-03-8, C10H6MgN4O8·2H2O.”
- “Assay 98.0–102.0% by HPLC, with the basis stated.”
- “Magnesium 6.4–6.8% by complexometric titration, with the basis stated.”
- “Water 9.0–11.0% by Karl Fischer.”
- “Identification by IR against a dihydrate reference and by HPLC retention with peak purity.”
- “≥95% through 40 mesh; granulated or milled variants quoted separately.”
- “No added magnesium oxide or another magnesium salt.”
A specification copied from magnesium citrate will fail on the magnesium range and on the water, and the supplier will be right to reject it. The salt name, the hydrate and the assay basis are the three lines that make the rest of the document checkable.
The magnesium orotate product page carries the catalog specification, and the compliance page covers the market questions that follow the salt choice. The complexometric method note describes the magnesium assay, and the HPLC note describes the orotate assay.
In this document
Related documents
Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.
Request a quotation