Omega-3 concentrate oxidises; the concentration removes its natural protection
An omega-3 concentrate fails by oxidation. EPA and DHA are the most unsaturated acids in the oil, and the bonds that make them useful are the ones oxygen attacks. Concentration also removes much of the tocopherol and minor-lipid fraction that slowed the reaction in the crude oil, so the distillate is more exposed and depends on the antioxidant declaration and on the pack.
The concentration step strips the tocopherols and minor lipids that protected the crude oil, so the concentrate depends on an added antioxidant, a low-oxygen pack and a short, measured storage life.
The sealed pack: headspace, light and the antioxidant
Water is a minor component of the oil, and the catalog keeps free fatty acid at ≤0.10% rather than setting a moisture line. Hydrolysis still matters, because a wet or warm pack raises FFA, but the reaction that ends the storage life is oxidation. The air above the oil is the reservoir: each sampling replaces part of the headspace, and a drum that is half empty holds more oxygen than a full one.
The 1 kg amber bottle and the 25 kg HDPE drum both block light; the closure, the liner and the transfer line are the weak points. Close the container between samples and decant a part-used drum into a smaller opaque one. A nitrogen blanket is available on request and should be written into the order when the oil will be stored or shipped for a long period.
Because distillation has reduced the natural tocopherols, any antioxidant added back is part of the specification. Its type and level belong on the TDS, and a change is a material change. Copper and iron accelerate the reaction at trace levels, so the process description should exclude brass, mild steel and other contact materials that shed metal ions.
Softgel, emulsion and the oil-water boundary
A softgel encloses the oil; a drink or a liquid supplement disperses it as an emulsion. In the emulsion, oxygen meets the oil at the droplet surface, and a smaller droplet means more surface. Emulsifier choice, homogenisation, pH and the heat load all change how fast the oil reacts, and a bulk result does not predict the finished drink.
The softgel is protected by its shell, but the seam and the shell’s permeability set the real barrier. A transparent shell on a lit shelf is an exposure, and a fish-gelatin shell is an allergen fact as well as a packaging choice. For a liquid, measure PV and p-AV at fill and through storage, and keep dissolved oxygen low; an antioxidant slows the chain but does not repair oil that has already reacted.
What drives the reaction
| Factor | What it does | Control |
|---|---|---|
| Oxygen | Forms hydroperoxides, then aldehydes | Low headspace, nitrogen, sealed container |
| Light | Drives photochemical oxidation | Amber or opaque pack, dark store |
| Heat | Raises the rate of every step | Cool store, low process temperature |
| Copper and iron | Decompose hydroperoxides | Stainless steel and glass contact |
| Water | Hydrolyses the esters; FFA rises | Dry oil, sealed pack, low humidity |
| Antioxidant | Slows the chain; cannot reverse it | Declare the type and the level |
The factors compound rather than add: warmth, light and a large headspace reinforce one another, and a softgel on a bright shelf feels both light and heat at once. The answer is specific to a pack, a condition and a time.
A stability protocol for the concentrate
Define the pack, the condition, the time points and the test panel before the first sample goes in. Long-term 25 °C/60% RH, intermediate 30 °C/65% RH and accelerated 40 °C/75% RH are the usual set; add a light-exposure arm, because a dark incubator cannot reproduce the failure that light causes. A heated oven test ranks formulations but does not replace data from the actual pack.
Each time point covers PV, p-AV, TOTOX, FFA, appearance and odour. Run EPA, DHA and the total at the beginning and the end to show the profile has held, and include the trans-isomer figure if the specification sets one. Show the individual results and identify the pack and the lot family; a 1 kg bottle and a 25 kg drum differ in headspace and in how often they are opened, so one data set does not cover the other.
Rancimat yields an induction time under heated air. It is useful for ranking antioxidants or lots, and the result then has to be confirmed in the pack. The softgel shell and the seal sit outside that test.
How the finished formula changes it
Four formats expose the oil in four ways: a softgel encloses it, an emulsion spreads it over a large interface, a powder on a carrier leaves surface oil exposed, and a bulk blend dilutes it with another oil. The last case changes the sterol profile and the EPA+DHA per gram, which is an identity question before it is a stability one.
An overage or a stronger antioxidant cannot resurrect an oil that has already reacted: the aldehydes stay, and the smell comes back even when a fresh assay hides them. The formulator decides whether an overage is needed; that decision belongs with the label and the stability file, not with the pack alone.
Setting the retest period
No single shelf-life number applies to an omega-3 concentrate. The retest period belongs to a pack and a storage condition and is supported by data for that pack; without those three pieces, a number is only a claim.
Re-assay the retained sample when the retest period ends and before extending use. An extension needs data; a bulk result does not transfer to a repacked bottle, a softgel or a powder. Each matrix and each pack changes the rate.
The standard packs are listed on the MOQ page; the release tests are on the COA page; the form is compared with the refined oil on the concentrate versus fish oil page; the refined oil’s own protocol is on the fish oil stability page; the oxidation methods are indexed under methods; the release workflow is on the quality page.
Related documents
Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.
Request a quotation