02 Grades & forms

Pantothenic acid grades: free acid powder, mesh and the calcium salt

Technical document 02 · Reviewed 2026-11-20 · Pantothenic Acid

On this page
  1. Why one vitamin name covers several grades
  2. The grade families side by side
  3. Mesh, flow and the hygroscopic powder
  4. The dose and the dosage form decide the grade
  5. What to write into the specification
  6. When a different grade is the wrong choice

D-Pantothenic acid is supplied here as an 80 mesh powder, with granulation available on request. The grade choice is the form first — free acid, calcium salt, sodium salt, panthenol or pantethine — and the particle second. The table lists the materials a buyer may meet under the vitamin B5 name; only the free-acid rows are this product.

In one line

The grade is the form plus the particle: a free-acid powder, a granulated free acid and a calcium salt are three different specifications, not three pack sizes.

Why one vitamin name covers several grades

“Vitamin B5” is a label name, not a specification. The nutrient is pantothenic acid; the commercial materials are the free acid, its calcium salt, its sodium salt, panthenol and pantethine. Each has its own CAS number, assay basis and label name, so a purchase order that names only vitamin B5 has left the form open.

The free acid also has two enantiomers. The catalog names D-pantothenic acid, and the D-form is the one used as the vitamin. That matters because the identity lines on this product are HPLC and IR, and neither separates D from L on its own; specific rotation is the check when the enantiomer is contractual.

This range supplies the D-form of the free acid as a powder. The other materials in the table are listed so that a quotation can be read, not because they can be substituted without a new specification and, in most markets, a new label review.

The grade families side by side

Pantothenic acid forms and grades, and what changes
GradeFormTypical useWhat changes
Free acid powderWhite to off-white powder, ≥95% through 80 meshCapsules, tablets, dry blendsBaseline; acidic solution; hygroscopic
Free acid, granulatedAgglomerated powder, on requestHigh-speed tableting, stick packsFlow, dust and bulk density; same assay, pH and drying limit
Free-acid premixFree acid on a carrier, on requestLow-dose blendsAssay per gram, carrier and label; not the same specification
Calcium D-pantothenateWhite powder, 40 meshCapsules, tablets, dry blendsSalt factor 0.920, calcium 8.0–8.6%, near-neutral pH
Sodium D-pantothenateSodium salt, powderWhere calcium is not wantedCounter-ion, label and hygroscopicity
D-PanthenolLiquid alcoholLiquid formatsNot a powder; a different ingredient and label
PantethineDimeric formSpecialty formatsDifferent CAS number and label

The first two rows are this product. Every other row moves at least one line on the certificate, and most move the ingredient list as well. A granulated free acid still has to meet the same assay, pH and loss on drying; the granulation changes the physical behaviour, not the chemistry.

Mesh, flow and the hygroscopic powder

80 mesh is a finishing specification: at least 95% of the powder passes an 80 mesh sieve, which is finer than the 40 mesh figure on the calcium salt. The number describes the coarse fraction, not the whole distribution. A powder that passes 80 mesh can still hold a large share of fines, and fines are what dust, stick to a capsule shell and segregate in a blend.

Pantothenic acid is hygroscopic. A fine powder exposes more surface to the air than a coarse one, so an open drum in a humid room takes up water faster at 80 mesh than at 40 mesh. Granulation binds the fines into larger particles and usually improves flow and reduces dust, but it can slow dispersion in a stick pack and it adds a different particle-size line to the certificate.

Sieve results depend on the sieve, the shaking time and the sample size. A laser diffraction result is a distribution, not a sieve figure, so ask which method produced the number before comparing two suppliers. The methods library describes both approaches.

The dose and the dosage form decide the grade

A capsule carrying 5 mg of pantothenic acid needs very little powder inside a large fill. At that level the ingredient is a small part of the blend, which is exactly where segregation and uneven mixing appear. A diluted premix may even out the blend, but the carrier it brings lowers the assay per gram and forces a label change.

A high-dose tablet or stick pack uses the undiluted powder instead. There the fill weight is mostly the ingredient, flow and dust count for more than dilution does, and the free acid's own acidity becomes a taste issue: its 5% solution sits at pH 2.5–3.5, sharp in a drink mix. Calcium D-pantothenate gives a solution closer to neutral, so the form decision lands on the sensory result before the grade decision does.

Decide the form and the dosage form before the mesh. A direct-compression tablet wants flow and a coarse fraction; a hard capsule can take the 80 mesh powder; a stick pack wants a powder that disperses without lumps.

What to write into the specification

  • “D-Pantothenic acid, CAS 79-83-4, C9H17NO5.”
  • “Assay 98.0–101.0% by HPLC; state the moisture basis on the certificate.”
  • “Identification by HPLC retention and IR spectrum; state the HPLC wavelength.”
  • “Loss on drying ≤5.0%; pH 2.5–3.5 in 5% solution.”
  • “Particle size ≥95% through 80 mesh; granulation, bulk density or flow only if agreed in writing.”
  • “Destination market and the form named in the market file confirmed before the order.”

A specification that says only “vitamin B5 99%” has not named the form, the grade, the moisture basis or the mesh. The product page carries the catalog values; the level-four comparison covers the salt factor and the label; the vitamin B5 page describes the calcium salt; the quality page shows how the grade is released.

When a different grade is the wrong choice

If the market file or the label names calcium pantothenate, the free acid is not a drop-in. In the EU, the food-supplement directive lists the pantothenic acid forms in its Annex II; as of this review the free acid is not a separate entry, so the buyer's regulatory team has to confirm the route for the destination before the order. The compliance page sets out the framework.

If the formula needs a neutral solution, the salt is the practical starting point; neutralising the free acid in the formula creates a pantothenate salt and changes the ingredient list. If the process needs a coarser or a finer powder than 80 mesh, the mill belongs in the agreement, not in a footnote. And a granulated grade is not a substitute for the standard powder in every process; it is chosen for flow or dust control, not because it sounds more finished.

Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.

Request a quotation