02.1 Isolate vs spirulina

Phycocyanin vs spirulina: the isolate and the whole alga

Technical document 02.1 · Reviewed 2026-11-19 · Phycocyanin

On this page
  1. The isolate and the whole organism
  2. The numbers side by side
  3. Why the whole alga cannot give a clean blue
  4. The label names one material, not the other
  5. Two regulatory routes, not one
  6. When to choose which

Phycocyanin is the blue protein-pigment extracted from spirulina; whole spirulina is the dried cyanobacterium. The isolate delivers the pigment in a small mass and a clean blue, while the whole biomass delivers a green powder with fibre, other pigments and a characteristic taste at a much lower pigment fraction. They are not interchangeable by weight, and the label name follows the material.

In one line

The isolate is a colour and a protein figure; the whole alga is a food with a much lower pigment fraction, a green colour and a taste the isolate does not have.

The isolate and the whole organism

Spirulina is the dried biomass of Arthrospira platensis, a cyanobacterium grown in open or closed culture and harvested, washed and dried. It is a food in the everyday sense: the whole cell, with its protein, fibre, lipids, chlorophyll and phycocyanin still together. Phycocyanin is a phycobiliprotein inside that cell, a water-soluble protein carrying a blue bilin chromophore. The isolate is made by extracting the biomass with water, separating the pigment-protein from the cell debris and drying the extract.

That process is the whole difference. The isolate is a fraction of the alga, not a more colourful version of the powder. It has lost most of the fibre and the chlorophyll, it carries the pigment at a higher percentage, and its taste is milder but not absent. A buyer who handles the two as one material will size the dose, the label and the regulatory file on the wrong basis.

The numbers side by side

Phycocyanin isolate against whole spirulina powder
PropertyPhycocyanin isolate (catalog)Whole spirulina
Phycocyanin≥25.0% by UV/VisA minority of the dry mass; the published range is roughly 10–20%
Protein≥50.0% by KjeldahlCommonly quoted at 55–70% on a dry basis
ColourBlue powder; deep blue solutionGreen powder; green suspension
Mass for 100 mg of pigment400 mg at 25.0%About 0.5–1.0 g at the published range
Fibre and cell wallLargely removed by the extractionPresent
Ash≤8.0%Varies with the culture medium and the wash
Label namePhycocyanin, or spirulina extract, per the marketSpirulina, Arthrospira platensis
Usual categoryColour additive or a defined ingredientA whole food

The mass row is the arithmetic that matters. A formula that needs 100 mg of phycocyanin takes 400 mg of the 25.0% isolate, or roughly half a gram to a gram of whole spirulina at the published range. The whole powder therefore brings several times the mass for the same pigment, and with that mass come the fibre, the chlorophyll and the taste.

The protein figures are not the same measurement in disguise. In the isolate, the pigment is part of the protein, so the ≥25.0% pigment sits inside the ≥50.0% protein. In the whole alga, the protein figure includes phycocyanin plus the other cellular proteins, and the two are not reported as separate release lines.

Why the whole alga cannot give a clean blue

Whole spirulina looks green because chlorophyll absorbs red and blue light and dominates what the eye sees. The phycocyanin is there, but its blue is masked by the green. Adding more whole powder to a formula to push the blue therefore adds chlorophyll at the same time, and the shade drifts toward green rather than becoming more intense. The isolate removes the chlorophyll, which is why a small mass can produce a deep blue solution.

The isolate has its own colour limits. The blue is pH-dependent and fades with light and heat, so a low-pH drink or a hot process can dull it. Whole spirulina carries the pigment inside a cell and a matrix, and its colour behaviour in a drink is different again. Neither material is a drop-in for a synthetic dye, and the shade should be validated in the finished matrix.

The label names one material, not the other

A product that declares “spirulina” and contains the isolate has described the source but not the ingredient; a product that declares “phycocyanin” and contains whole spirulina powder has overstated the pigment. The two names are not synonyms, and the regulatory category behind each one is different. The isolate's label name also depends on the market: a colour use and a supplement use can require different wording for the same powder.

The protein claim is the other label trap. Whole spirulina can contribute grams of protein per serving because the serving is grams; the isolate is used at a few hundred milligrams for colour, which contributes a small fraction of that. A protein claim built on phycocyanin is a different proposition from one built on whole spirulina, and the label should follow the material actually weighed into the batch.

Two regulatory routes, not one

Whole spirulina has a long food history and is usually handled as a food or a food ingredient. The isolate is a concentrate with a defined specification, and the route depends on the market and the use: a colour additive, a food used for colour, or a dietary ingredient in a supplement. The route decides the permitted categories, the use level, the label wording and the documents the importer keeps.

This page does not assert that either material is authorised for a particular use in a particular market. The buyer's regulatory team confirms the route for the destination, and the supplier keeps the specification, the source and the process under change control. A colour-additive file and a whole-food file are not interchangeable, even when both describe the same organism.

When to choose which

Choose the isolate when the job is colour, when the mass per serving is small, or when the formula needs a defined pigment figure that can be released against a UV/Vis method. Choose whole spirulina when the product is positioned as the whole food, when the fibre and the other cell components are part of the offer, or when a green powder is acceptable. If the job is protein rather than colour, neither is the obvious choice: a collagen peptide or a soy protein isolate is a protein purchase with its own specification.

Do not mix the two to hit a label number. A blend of isolate and whole powder can be built to any pigment figure, but the label, the taste and the regulatory category then have to be rebuilt around the blend. The product hub carries the isolate specification; the grades page compares the formats; the identity page covers the tests; the methods library describes the pigment assay; the quality page describes the release file.

Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.

Request a quotation