What the COA for egg white protein actually contains
An egg white protein certificate is a protein report with a moisture correction. It carries protein by Kjeldahl with the 6.25 nitrogen factor, the moisture that converts that figure to an as-is basis, fat, ash and the physical and microbiological tests of a spray-dried powder. The identity line should describe the protein profile, not only the words “egg white”; the limits in the first table are the catalogue specification, while the batch COA confirms one lot.
The protein figure is only half the certificate: it needs the 6.25 nitrogen factor, the dry basis and the moisture beside it, and the egg allergen statement belongs in the same file.
Reading the certificate
Read a certificate as a set of claims that have to be checked one at a time. Every parameter should show the measurement, the technique behind it and the boundary it had to meet. When a line gives only a verdict, the buyer has no way to test it.
Protein and moisture are a pair. Neither stands alone: protein is reported on a dry basis, moisture says how much of the powder is not protein, and the as-is value used in a formula is the product of the two. The identity row is the other anchor, because “egg white protein” is a source and a process, not a single molecule.
| Parameter | Method | Release limit |
|---|---|---|
| Appearance | Visual | Off-white to light tan powder |
| Protein, dry basis | Kjeldahl, N × 6.25 | ≥80.0% |
| Moisture | Gravimetric, vacuum oven | ≤8.0% |
| Fat | Solvent extraction | ≤1.0% |
| Ash | Gravimetric, 550 °C | ≤5.0% |
| Identification | Protein profile against a reference | Conforms |
| Heavy metals | ICP-MS | Pb ≤3 · As ≤2 · Cd ≤1 · Hg ≤0.1 mg/kg |
| Microbiology | Plate count and absence tests | APC ≤1,000 cfu/g; yeast and mould ≤100 cfu/g; E. coli and Salmonella absent |
| Particle size | Sieve analysis | ≥95% through 80 mesh |
The allergen statement is not a test line, but it travels with the certificate: the material is egg-derived by definition.
Dry basis, moisture and the nitrogen factor
Protein is calculated from nitrogen, and the calculation is only as good as the factor. Egg protein uses 6.25. The same nitrogen result with the milk factor, 6.38, reads about 2.1% higher; with the collagen factor, 5.55, about 11% lower. A certificate that gives a percentage without the factor leaves the reader to guess.
The basis matters as much. At the 8.0% moisture limit, a lot at 80.0% protein on a dry basis contains 73.6% protein as weighed. A formula that needs 20 g of protein takes 27.2 g of that powder, not 25.0 g. The certificate should state “dry basis” in the protein row and report moisture as a measured figure, so the buyer can repeat the calculation for the lot in hand.
Kjeldahl measures nitrogen, not protein. Non-protein nitrogen is counted as protein by the factor. That is why the identity profile, and on suspicion a nitrogen-source screen, belong in the same review. A high protein figure from an unknown source is a question, not a result.
Limit, result and what separates them
A specification number and a lot result are two different things, and a certificate should never let one stand in for the other. The limit defines the window; the measured value says where inside it the lot fell. Printing the window again in the result column tells the buyer nothing about the powder.
| Test | Limit | What the result should show |
|---|---|---|
| Protein | ≥80.0% dry basis, N × 6.25 | A measured percentage and the nitrogen result behind it |
| Moisture | ≤8.0% | A measured percentage |
| Fat and ash | Fat ≤1.0%; ash ≤5.0% | A measured percentage for each |
| Heavy metals | Per element | One figure in mg/kg for each element |
| Microbiology | Counts and absence | The measured count plus the absence result |
The verdict should be reproducible from the figures beside it. Microbiology needs a colony count and an absence result; the metal panel needs a number for each element rather than one summed figure; protein needs the measured percentage together with its factor and basis.
What varies from lot to lot
Hen age, feed and the season shift the solids a little; the spray dryer shifts moisture, colour and particle size; the heat step shifts how the powder disperses. A floor of 80.0% is met by a lot at 82% and by one at 80.5%, so a buyer who wants a narrower band must state it.
Colour is a weak but useful signal. Off-white to light tan covers a wide range, and a shift inside it is not an identity failure. A powder that browns in the bag is a different matter: egg white contains a small amount of glucose, which reacts with lysine during warm storage, darkening the powder and lowering the available lysine. Some processors remove the glucose with an enzyme step before drying; the certificate rarely says so, and the stability file is the place to ask.
A trend can matter more than a single result near an edge: protein drifting low, moisture climbing, or a new colour. The certificate's lot code must be the code on the bag, the drum and the sample kept back.
When an outside test earns its cost
Outside testing earns its cost at a new source, at the first shipment into a regulated market, when the allergen statement is challenged, when the nitrogen looks too high, or when one lot breaks the pattern of the previous ones. The panel is narrower than a full certificate: protein with the nitrogen figure, an amino acid profile against an egg white reference, moisture, fat and ash, ICP-MS for the metals, and the microbiological count.
If the protein looks too good for the amino acid profile, add a screen for non-protein nitrogen, including urea and melamine by LC-MS/MS. If the source is disputed, an ovalbumin-specific immunoassay or an electrophoretic protein pattern answers a different question from total protein. Ask what each screen can detect; “not detected” without a detection limit says more about the laboratory than about the powder.
Keep the chain of custody intact. The referee should test the sample that was retained, and the report should carry the lot code. In a dispute, hand over that sample, the certificate and the specification, then ask for the test that tells the candidate materials apart rather than a second run of the same assay.
Comparing two suppliers
Compare six things: the protein result with its factor and basis; moisture; fat and ash; the amino acid or protein profile; the egg allergen statement; and the pack with its lot code. If two offers match on protein but not on factor, basis or form, they are offers for different materials.
Traceability is the next layer: the manufacturer, the heat treatment, the drying step, and whether the powder is milled or instantized. The catalogue specification sits on the egg white protein product page. The grade choice is set out on the grades page, the identity tests on the identity page, the method limits in the analytical methods library, and the release workflow on the quality page.
Related documents
Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.
Request a quotation