Colostrum vs IgG: the whole powder and the isolate
Whole colostrum powder and an IgG isolate are two different commercial articles. The catalog powder is ≥70.0% protein with ≥20.0% IgG, ≤5.0% fat and ≤5.0% lactose; a purified IgG fraction is ≥90.0% IgG with almost no fat or lactose. The same IgG dose therefore weighs about a fifth as much from the isolate, and the label names a different ingredient.
Whole colostrum is 20% IgG and about 70% protein; an IgG isolate is over 90% IgG with almost no fat or lactose, so the same IgG dose weighs a fifth as much and the label names a different ingredient.
The whole secretion and one protein
Colostrum is the first milk after calving, and a powder made from it keeps the protein complement of that secretion: immunoglobulins, lactoferrin, growth factors and the casein and whey proteins around them. An IgG isolate starts from colostrum or from a whey stream and keeps one class of protein. The two share an origin, not a composition.
That difference shows in four figures. Whole colostrum carries about 29% of its protein as IgG; an isolate carries nearly all of its protein as IgG, and almost no fat and lactose, because the process removed them. One is not a better grade than the other. They are two positions along the same separation, and a buyer is choosing a position, not a rank.
The figures side by side
| Figure | Whole colostrum powder | IgG isolate |
|---|---|---|
| Protein | ≥70.0% | ≥90.0% |
| IgG | ≥20.0% | ≥90.0% |
| IgG as a share of protein | About 29% | Above 95% |
| Fat | ≤5.0% | ≤1.0% |
| Lactose | ≤5.0% | ≤1.0% |
| Other milk proteins | Present | Largely removed |
| Typical label | Colostrum | Immunoglobulin G |
The isolate figures are a specification that can be agreed for a fractionated grade. The point of the table is the gap between the rows, not the exact value of any single line: protein and IgG converge in an isolate and diverge in the whole powder.
The dose arithmetic
IgG is the figure that decides the mass. One gram of IgG needs 5 g of whole colostrum at 20%, or about 1.1 g of an isolate at 90%. A 500 mg capsule of the whole powder carries about 100 mg of IgG; a 500 mg capsule of the isolate carries about 450 mg. That arithmetic is what turns an IgG target into a fill weight.
It also decides the format. A capsule holds roughly 500–800 mg of powder, so a high IgG dose from whole colostrum needs several capsules or a stick pack. The isolate fits the same dose into one or two capsules, and brings less fat, less lactose and less of the rest of the secretion with it. Those are arithmetic examples, not a recommended intake.
What the label can say
The label wording follows the article rather than the origin. A product labelled “colostrum” declares the whole powder and its quantity; a product labelled “immunoglobulin G” declares the fraction. Declaring 500 mg of colostrum and implying 500 mg of IgG is a labelling error, and declaring an IgG quantity while using the whole powder means the declared figure has to be calculated from the IgG result of the lot.
The allergen does not change. Both articles are milk products, so the milk declaration is required in the EU and the United States, however low the lactose figure is. A low lactose number is a composition statement, not an allergen exemption.
How a certificate tells them apart
Two ratios do the work. The IgG-to-protein ratio is about 0.29 in whole colostrum and close to 1 in an isolate, and the fat and lactose figures are a few percent in the whole powder against 1% or less in the isolate. A certificate that reports 90% IgG and 70% protein is internally inconsistent and needs an explanation, because IgG is measured as protein.
Both articles are measured by radial immunodiffusion for the IgG and by Kjeldahl for the protein, so the methods do not separate them. The arithmetic does. That is why a certificate should be read as a set of figures that have to agree, not as a list of passes.
Storage and the fat question
The whole powder carries up to 5.0% fat and up to 5.0% lactose, and both are storage liabilities that an isolate largely avoids. Fat oxidises and gives an off-odour in a warm store; lactose with protein browns as water activity rises. The isolate has less of each, so its storage risk is concentrated in the IgG itself, which is still heat-sensitive.
Neither article is the stable one by default. The pack, the temperature and the time decide, and the retest period belongs to the article and the pack that were tested. The stability page sets out the protocol and the failure routes.
When to choose which
Choose whole colostrum when the label names colostrum, when the format carries a few grams of powder, and when the rest of the secretion is part of what the customer is buying. Choose an isolate when the label declares an IgG quantity, when the dose has to fit in a small capsule, or when fat and lactose are the constraint.
Switching in either direction resets the specification, the label and the stability work. Name the article, the IgG figure and the basis in the purchase order, and confirm the destination route for the exact fraction rather than for colostrum in general.
The product hub carries the catalog specification, the grade page places both articles in the wider range, the COA page shows where each figure comes from, and the lactoferrin and whey concentrate pages show the neighbouring single-protein and commodity options.
Related documents
Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.
Request a quotation