Colostrum grades: the four figures that set the powder
Colostrum is sold as a whole powder, a higher-IgG powder, a basic-protein fraction and an IgG isolate. The catalog grade is protein ≥70.0% with IgG ≥20.0%, fat ≤5.0% and lactose ≤5.0%. The grade is a set of four figures rather than one, and the IgG figure is the one that decides how much powder a capsule or a stick pack needs.
The grade is set by the IgG figure and the protein basis together, and the fat and lactose limits are what separate a colostrum powder from a milk powder.
Why the grades exist
Colostrum is not a single article of commerce. The raw fluid can be skimmed, its lactose reduced, its casein and whey proteins separated, and its immunoglobulin fraction isolated. Each step changes the four figures that define the powder, and each step has a customer who wants it.
The catalog grade sits in the middle: it keeps the protein complement of the secretion while removing most of the fat and the lactose. A grade that pushes IgG to 30% or beyond has been fractionated or blended with an immunoglobulin concentrate. A grade that raises protein to 80% while dropping IgG to 10% is a basic-protein fraction, not a stronger colostrum; the basic protein is a separate product for that reason.
The choice is not a quality ladder. A buyer who needs a declared IgG quantity in a small capsule is not served by a higher protein figure, and a buyer who wants the whole secretion is not served by an isolate.
The grade families side by side
| Grade | Protein | IgG | Fat | Lactose |
|---|---|---|---|---|
| Whole colostrum powder (catalog) | ≥70.0% | ≥20.0% | ≤5.0% | ≤5.0% |
| Higher-IgG colostrum powder | ≥70.0% | ≥30.0% | ≤5.0% | ≤5.0% |
| Colostrum basic protein | ≥80.0% | ≥10.0% | — | — |
| IgG isolate | ≥90.0% | ≥90.0% | ≤1.0% | ≤1.0% |
A dash means the limit belongs to the individual specification rather than to this table. The basic-protein fraction is sold on protein and ash, with ash ≤5.0% as its usual companion limit; its fat and lactose are set case by case. The higher-IgG powder is a specification that can be agreed on request, not a second catalog grade.
Fat, lactose and how the powder behaves
The fat and lactose limits are not housekeeping. Fat carries the colour and the odour, lowers the flow of the powder in a humid room and gives the product a lipase-driven off-note on storage. Lactose is the line that separates colostrum from milk powder, and it also matters in the capsule: a lactose-reduced powder is the easier starting point for a blend that has to keep its water activity low.
The catalog form is ≥95% through 80 mesh. That is a fine powder, and fine colostrum powder is cohesive and dusty; granulation on request gives a freer flow on a stick-pack line, at the cost of a different particle-size specification. Both forms disperse in water to a slightly turbid liquid, because the residual fat and the protein do not give a clear solution.
Colour runs from off-white to light tan and moves with the season, the skim and the dryer. A darker lot inside that window is not automatically a failure, but a colour shift paired with a fat figure at the top of the range or an odour change is worth investigating before the lot goes into a blind capsule.
Dose arithmetic and the fill
IgG is the figure a dose is built on, and the grade decides the mass. One gram of IgG needs 5 g of the 20% grade, 3.3 g of a 30% grade or 1.1 g of a 90% isolate. Those are arithmetic examples, not a recommended intake.
The capsule calculation follows the same route. A 500 mg fill of the catalog grade carries about 100 mg of IgG; the same fill of a 30% grade carries 150 mg; a 500 mg fill of the isolate carries 450 mg. A formulator who writes “500 mg colostrum” on the label has declared 500 mg of powder and about 100 mg of IgG, and the two statements are not interchangeable.
An excipient dilutes the IgG per gram, so the overage belongs in the fill weight rather than in the assay. Work the blend's IgG figure out from the ingredient certificates instead of assuming that the powder figure survives the fill.
What to write into the specification
- “Bovine colostrum powder, with the collection window stated.”
- “Protein ≥70.0% by Kjeldahl with the factor 6.38 named.”
- “IgG ≥20.0% by radial immunodiffusion, with the reference standard named.”
- “Fat ≤5.0%, lactose ≤5.0%, moisture ≤7.0%.”
- “Particle size ≥95% through 80 mesh; heavy metals and microbiology as listed.”
- “Process temperature stated; the milk allergen and bovine origin declarations on file.”
The process line is the one buyers leave out. IgG is a protein, and a drying step that runs hot is a specification change even when every chemical line still passes.
When the whole powder is the wrong choice
Whole colostrum is the wrong choice when a single capsule has to carry a high IgG dose. A 500 mg capsule cannot deliver more than the IgG the grade contains, and the answer is a stronger grade or a different format rather than a larger capsule. It is also the wrong choice when the label declares an IgG quantity as the ingredient, and when the destination classifies an immunoglobulin fraction as a different article from the whole powder.
The product hub carries the catalog ranges. The level-four page compares the whole powder with the isolate, the lactoferrin page shows a single-protein milk ingredient for comparison, the whey concentrate page is the reference for a commodity milk protein, and the COA page shows where each figure comes from.
In this document
Related documents
Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.
Request a quotation