Zinc malate grades: mesh, moisture and the zinc figure
Zinc malate is one salt, so a grade is not a second chemistry. What changes between commercial offers is the particle size, whether the powder is granulated, the moisture limit the supplier will release against, and how the assay and zinc figures are declared. The choice between zinc malate and another zinc salt is a separate decision, made on zinc per gram, solubility and the name the label can use.
For zinc malate, grade means particle size, granulation, moisture and a stated zinc figure; the salt name stays the same.
Why a single salt still has grades
A capsule does not fill itself with a certificate. The powder has to flow into the dosator, the tablet press has to compress it without sticking, and the blend has to stay uniform while it is conveyed. Those are physical properties, and they are set by milling, sieving and granulation rather than by the reaction that made the salt. A 40 mesh powder and a granulated powder can carry the same assay and behave differently on the line.
There is also a commercial grade question: what the supplier will guarantee on the certificate. A standard line releases at 98.0–102.0% assay, 32.0–34.0% zinc and ≤2.0% loss on drying. A tighter moisture limit can be agreed for a hygroscopic matrix or a long hold, but it is a specification change, not a packing choice, and it should be quoted as one.
The grade options side by side
| Grade | What changes | Typical use | Watch |
|---|---|---|---|
| Standard powder, 40 mesh | ≥95% through 40 mesh; free-flowing | Capsules, tablets, blends | Fines can dust and segregate |
| Fine powder, finer cut | Higher surface area; slower flow | Chews, suspensions, small sachets | Dust, caking, blend loss |
| Granulated | Larger particles; better flow, less dust | Tablets, stick packs, high-speed filling | Granulation aids must be declared |
| Tighter moisture limit | Lower loss on drying at release | Humid plant, long hold, effervescent mix | Agreed limit, not a standard pack |
These rows are process variants, not different salts. A granulated zinc malate still assays as zinc malate and still carries about 33% zinc; what moves is the particle-size distribution, the bulk density and the flow. A certificate that explains a zinc result by pointing to the mesh has confused a physical change with a chemical one.
The salt choice is a different table. Zinc malate is specified at 32.0–34.0% zinc; zinc citrate at 31.0–32.5%; zinc gluconate at about 14.3% on the anhydrous formula; zinc oxide at 78.0–80.0%. The first two are close enough that the fill difference is small, the gluconate needs roughly twice the mass, and the oxide is the most concentrated but practically insoluble.
| Salt | Zinc figure | Water solubility | Fits |
|---|---|---|---|
| Zinc malate | 32.0–34.0% | Slightly soluble; more soluble in acid | Capsules, tablets, acidic blends |
| Zinc citrate | 31.0–32.5% on the dried basis | Slightly soluble; buffered suspension | Capsules, tablets, sticks |
| Zinc gluconate | About 14.3% theoretical | Freely soluble | Clear drinks, syrups |
| Zinc oxide | 78.0–80.0% | Practically insoluble | Tablets where mass is tight |
Particle size, flow and the room
The 40 mesh figure means at least 95% of the powder passes a 40 mesh sieve, which is about 420 micrometres. That is a coarse-ish powder: it flows better than a fine flour but still throws dust when it is poured. A finer cut increases the surface area and the dust, improves the mouthfeel in a chew, and makes segregation in a low-dose blend more likely. Granulation is the usual answer when the line needs flow and the formula can declare the binder.
Moisture changes the physics before it changes the chemistry. A powder that has picked up surface water cakes in the hopper, bridges in the feed frame and weighs unevenly. The ≤2.0% loss-on-drying limit is a release gate; a plant in a humid climate should ask for the in-use handling instruction as well as the release result, because the number on the certificate describes the pack, not the hopper.
What the dosage form can carry
The fill arithmetic is simple at 33.0% zinc: a 10 mg zinc claim needs about 30.3 mg of zinc malate, a 25 mg claim about 75.8 mg and a 50 mg claim about 151.5 mg. In a capsule those masses are comfortable, and the salt leaves room for the excipients. In a small tablet or a two-piece capsule at the top of its size range, the same 50 mg claim starts to compete with the disintegrant and the lubricant, and the granulated grade may pack better than the standard powder even though the mass is unchanged.
In a stick pack or a powder blend, the grade decides whether the salt stays mixed. A fine powder can settle away from a coarse sugar or an organic acid; a granulated grade with a similar particle size to the other ingredients is easier to keep uniform. In a chew or a gummy, the taste of the salt and the water activity matter more than the mesh, and a matrix trial is the only reliable test.
How to write the grade into the specification
- “Zinc malate, CAS 2847-05-4, C4H4O5Zn; salt name written out.”
- “Assay 98.0–102.0% by HPLC; zinc 32.0–34.0% by complexometric titration; basis stated.”
- “Loss on drying ≤2.0%; tighter limit only by written agreement.”
- “≥95% through 40 mesh; granulated or finer cut named if supplied.”
- “Identification by infrared spectrum and HPLC retention against a reference.”
- “Heavy metals, microbiology and pack as listed on the catalog specification.”
The grade line should describe what will be shipped, not what could be made. “Zinc malate, 40 mesh” and “zinc malate, granulated” are two specifications with two certificates; a purchase order that names only the salt leaves the physical form open.
When another salt is the better fit
Zinc malate is a sensible default for a capsule or tablet that wants a moderate zinc figure, a low moisture limit and an anion that dissolves more readily in an acidic matrix. It is not the automatic choice everywhere. A clear, neutral ready-to-drink beverage needs a salt that dissolves freely, and the gluconate is the usual answer. A formula already built around a citrate buffer may gain from keeping the citrate, because the anion is part of the pH system. A tablet that is short of mass may need the oxide, provided the formulator accepts that it is practically insoluble.
Switching salts is a change control, not a substitution at the weigh-up. The mass per serving, the taste, the rate at which the powder disperses, the stability package and the label all move together. The product hub carries the catalog line; the malate versus citrate comparison works through the zinc arithmetic and the fill; the zinc citrate page gives the other salt's specification; the HPLC method note describes the assay; the quality page covers release.
In this document
Related documents
Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.
Request a quotation