02.1 Oxide vs carbonate

Magnesium oxide vs magnesium carbonate: elemental magnesium and the acid reaction

Technical document 02.1 · Reviewed 2026-11-19 · Magnesium Oxide

On this page
  1. The elemental magnesium figures
  2. The acid reaction, with and without gas
  3. What controls the rate
  4. The fill weight follows the figure
  5. What the label has to say
  6. When to choose which

Magnesium oxide and magnesium carbonate both react with acid to release the magnesium ion, but they are not interchangeable on a label or on a balance. The oxide is about 60.3% magnesium by mass and is specified here at 57.0–60.0%; the anhydrous carbonate is 28.8% magnesium, and the basic hydrated carbonate sold in commerce sits near 25%. Per gram, the oxide carries roughly twice the magnesium and roughly twice the acid-consuming capacity, and the carbonate answers the acid with carbon dioxide gas.

In one line

The oxide carries about twice the magnesium and twice the acid-consuming capacity per gram; the carbonate answers with gas, and the fill weight follows the figure.

The elemental magnesium figures

Start with the formula. Magnesium oxide, MgO, has a molar mass of 40.30 g/mol, of which 24.305 g/mol is magnesium: 60.3% by mass. Magnesium carbonate, MgCO3, has a molar mass of 84.31 g/mol, so the same magnesium is 28.8% of the anhydrous carbonate. The carbonate is heavier because it carries carbon and oxygen that the label does not count as magnesium.

Magnesium oxide against magnesium carbonate
PropertyMagnesium oxideMagnesium carbonate
FormulaMgOMgCO3
Molar mass40.30 g/mol84.31 g/mol
Magnesium, theoretical60.3%28.8% anhydrous; about 25% in the basic hydrate
Magnesium, catalog57.0–60.0%Not specified on this site; confirm with the supplier
Magnesium in 500 mg285–300 mgAbout 125–144 mg
Acid consumed per gramAbout 49.6 mmol H+About 23.7 mmol H+

The last row is stoichiometry, not a performance claim. One mole of either compound consumes two moles of acid. A gram of oxide contains more moles of magnesium, so it consumes more acid per gram; the ratio is 40.30 versus 84.31, about 2.1 to 1.

The acid reaction, with and without gas

In dilute acid, magnesium oxide takes up two protons and forms the magnesium ion and water:

MgO + 2H+ → Mg2+ + H2O

Magnesium carbonate takes up the same two protons, but the carbonate part leaves as carbon dioxide:

MgCO3 + 2H+ → Mg2+ + H2O + CO2

The gas is the practical difference. One gram of anhydrous carbonate can release about 0.52 g of carbon dioxide, and that gas has to go somewhere. In an open blend or a stick pack mixed with water, it escapes and the powder effervesces. In a tablet, a capsule or a sealed pouch with residual moisture, it can pressurise the pack, open the seams or swell a tablet. The oxide produces no gas on the same reaction, so it is the simpler choice when a sealed pack must stay flat.

Both reactions release heat and consume acid; the oxide leaves water, the carbonate leaves water and gas. A switch changes the headspace, the pack pressure and the acid demand, not only the magnesium figure.

What controls the rate

Neither material is fast-dissolving in neutral water. Both are only sparingly soluble, and both rely on acid to dissolve. The rate is therefore a surface question: particle size, surface area and the grade of the powder decide how quickly the acid reaches the solid.

A light, precipitated oxide has a high surface area and reacts quickly in a dilute acid test. A dense, ground oxide has less surface per gram and reacts more slowly. A dead-burned oxide has very little surface and is close to inert. The carbonate has its own particle-size and hydrate profile; a fine carbonate reacts faster, and the gas can disturb the bed and change the local mixing.

Acid strength, temperature, stirring and the solid-to-liquid ratio all move the result. If the rate is important to the formula, agree a time-to-clear or acid-consumption method with the supplier and run it on the qualification sample; do not compare a certificate's mesh line with a reaction rate.

The fill weight follows the figure

A label dose of 250 mg elemental magnesium needs 250 ÷ 0.58 = 431 mg of oxide at a midpoint of 58.0%, or 250 ÷ 0.25 = 1,000 mg of a basic carbonate at about 25%. The carbonate dose is more than twice the mass for the same magnesium, and it is usually bulkier. That is a capsule-size and blend-weight decision before a chemistry one.

A 500 mg capsule can carry 285–300 mg of magnesium as oxide, or about 125–144 mg as carbonate. To reach the same magnesium figure with the carbonate, the formulator needs a larger capsule, more powder per serving, or a different magnesium source. The oxide is the concentrated route; the carbonate is the dilute route.

A light oxide at low bulk density may not fit the capsule that the label assumes; a dense oxide or a granulate may fit but react more slowly. The carbonate's gas can also affect a tablet's appearance and the seal of a sachet. The fill trial should use the exact grade and the exact pack, not a generic sample.

What the label has to say

The label declares the ingredient and the amount of magnesium, not only the weight of the salt. “Magnesium oxide 500 mg” and “magnesium 285 mg” are different statements, and the second is the figure the nutrient reference value is calculated against. The destination's labelling rules decide the format; the arithmetic is the same in every market.

In the EU, the nutrient reference value for magnesium is 375 mg, so 285 mg is 76% of the NRV. In the United States, the Daily Value is 420 mg, so the same 285 mg is 68% of the DV. Those figures are for illustration, not a recommended intake. The finished product's dose and the destination rules set the label; the brand's reviewer confirms the wording.

The ingredient name and the elemental figure have to match the certificate. If the label says magnesium oxide, the lot should be oxide, not a carbonate blend; if the label says magnesium carbonate, the oxide is not a drop-in. A change of magnesium source is a new specification, fill weight and label line, even when the elemental figure is held constant.

When to choose which

Choose the oxide when the formula needs the most magnesium per gram, when the pack must not generate gas, and when the capsule or tablet volume is the binding constraint. Choose the carbonate when the acid reaction is meant to produce gas, or when the formula is built around the carbonate's lower magnesium density and the fill has room for it. Neither choice is a product claim; it is a decision about mass, gas and handling.

For a clear solution rather than a suspension, neither material is the starting point. Magnesium citrate is the soluble comparison. The carbonate side of the current catalog is represented by calcium carbonate; the chemistry on this page is magnesium carbonate, and the same acid-and-gas logic applies to both carbonates.

The product hub carries the catalog specification. The parent grades page places this comparison in the wider range; the COA page shows how the magnesium figure is reported; the identity page gives the tests that separate an oxide from a carbonate; the methods library explains the titration and diffraction methods; the quality page describes the release workflow.

Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.

Request a quotation