02.1 Threonate vs glycinate

Magnesium L-threonate vs glycinate: magnesium content, dose and the label

Technical document 02.1 · Reviewed 2026-11-18 · Magnesium L-Threonate

On this page
  1. The conversion, not the percentage
  2. What the fill can carry
  3. The daily figure and the EU ceiling
  4. What the label declares
  5. When each salt fits the label
  6. Five checks before the switch

The two salts differ by a factor of about 1.7 in salt weight for the same magnesium. At 7.2–8.3% magnesium, threonate needs 1,205–1,389 mg of salt for 100 mg of magnesium; glycinate at 13.5–14.2% needs 704–741 mg. That difference decides the capsule count, the serving size and the number the label declares.

In one line

At 7.2–8.3% magnesium, threonate needs about 1.7 times the salt weight of glycinate for the same magnesium dose, and that difference reaches the capsule and the label.

The conversion, not the percentage

The magnesium percentage is a concentration, not a dose. To use it, divide the magnesium target by the assay: 100 mg ÷ 0.083 = 1,205 mg of threonate, and 100 mg ÷ 0.072 = 1,389 mg at the low end. For glycinate, 100 mg ÷ 0.142 = 704 mg and 100 mg ÷ 0.135 = 741 mg. The range matters as much as the midpoint, because a lot at the low end needs more powder than a lot at the high end.

Salt weight needed for a given magnesium target · calculated from the catalog ranges
Magnesium targetMagnesium L-threonateMagnesium bisglycinate
25 mg301–347 mg176–185 mg
50 mg602–694 mg352–370 mg
100 mg1,205–1,389 mg704–741 mg
200 mg2,410–2,778 mg1,408–1,481 mg
250 mg3,012–3,472 mg1,761–1,852 mg

The ratio between the two columns is not a fixed number either. At the midpoints it is about 1.75; across the two catalog ranges it runs from about 1.6 to 2.0. A formulator who uses a single conversion factor for both salts will be wrong at one end of the range.

What the fill can carry

A capsule holds a volume, and the powder has a bulk density. A 400–500 mg fill is a common working range for a mineral powder, and excipients reduce the active weight further. At a 500 mg fill, a 100 mg magnesium target takes three threonate capsules and two glycinate capsules; a 250 mg target takes seven and four. At a 400 mg fill, the threonate count rises to four for 100 mg and eight to nine for 250 mg. A larger capsule or a denser granulation can reduce the count, but it cannot reduce the powder weight.

A tablet has the same arithmetic with a compression limit. A 100 mg magnesium target from threonate is a 1.2–1.4 g tablet, or two smaller tablets; from glycinate it is a 0.7–0.74 g tablet. A stick pack can carry 1–3 g of powder, which suits threonate at a modest target. A gummy adds the weight of the gel network, so the salt weight per gummy is only part of the formula.

The fill also changes the excipient load. More threonate powder means less room for a flow agent, a disintegrant or a flavour, and the capsule or tablet gets larger before the magnesium figure reaches the label. That is a formulation decision, not a reason to change the assay.

The daily figure and the EU ceiling

Build the label dose from the magnesium target, then check it against the market. The EU novel-food authorisation for magnesium L-threonate sets a maximum of 250 mg magnesium a day, corresponding to about 3,000 mg of salt at 8.3%. At 7.2%, the same 250 mg needs about 3,470 mg of salt. A product that declares 250 mg magnesium from a low-assay lot will carry more salt than the nominal 3,000 mg figure, and the label should be built from the assay rather than from the nominal number.

The serving size follows. If a serving is three capsules, the magnesium per serving is three times the fill times the assay, not three times a nominal 100 mg. If a serving is one stick, the salt weight per stick sets the magnesium figure. The arithmetic should be done once, in the specification, and then checked against the label and the COA.

What the label declares

In the EU, the nutrition declaration states the magnesium figure in mg and as a share of the nutrient reference value, while the ingredient list names the salt as “Magnesium L-threonate”. The novel-food conditions add the adult-only statement and the pregnancy and lactation exclusion. The label may also state the salt weight, but that figure has to agree with the magnesium figure and the assay.

In the US, the Supplement Facts panel gives the magnesium amount and its Daily Value percentage; the ingredient statement names magnesium L-threonate. A label that declares 2,000 mg of magnesium L-threonate and 100 mg of magnesium is making two statements that have to agree: at 8.3%, 2,000 mg of salt delivers about 166 mg of magnesium, not 100 mg. One of the two numbers is wrong, or the salt is not what the label says.

In Great Britain, the retained nutrition and labelling rules apply, and the 2026 instruments name magnesium L-threonate monohydrate. The label has to use the permitted name and meet the novel-food conditions for the market. The salt name, the magnesium figure and the serving size are three separate declarations, and all three have to trace back to the same specification.

When each salt fits the label

Glycinate fits when the label has to deliver a high magnesium figure in a small serving, when the capsule count has to stay low, or when the market wants a form with a long Annex II history and no novel-food conditions. At 13.5–14.2%, it packs more magnesium into each gram.

Threonate fits when the label names magnesium L-threonate, when the magnesium target is modest enough for the salt weight, and when the market file supports the form. The capsule count is the practical test: a 100 mg target is three to four capsules at a 400–500 mg fill, and a 250 mg target is seven at a 500 mg fill. If that count is unacceptable, the salt is wrong for the project, not the assay.

Do not blend the two to hit a magnesium number without declaring both sources. A blend can reach a figure that neither salt reaches alone, but the ingredient list and the COA have to name both, and the label arithmetic has to use the blend’s measured magnesium, not the midpoint of two catalog ranges.

Five checks before the switch

  • The assay basis: dried or as-is, and the lot’s actual magnesium figure.
  • The salt weight per serving, calculated from that figure rather than the catalog midpoint.
  • The capsule or tablet count at the fill the formula can carry.
  • The label name, the elemental magnesium declaration and the serving size.
  • The market conditions for the salt, including the EU adult-only and 250 mg magnesium conditions.

The broader salt comparison is on the grade page. The certificate lines are on the COA page, the market conditions are on the compliance page, and the catalog specification is on the product page.

Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.

Request a quotation