The regulatory file for copper gluconate
Copper gluconate is judged by the exact salt, the destination and the finished-product category, not by the certificate alone. Copper is a nutrient under both the EU and US frameworks, but a supplement, a fortified food and a food additive are separate routes with separate limits, labels and evidence. The buyer's regulatory team confirms the route; this page sets out the framework and the documents the file needs.
The specification covers the powder; the regulatory file establishes the route, the permitted limits and the label wording for the destination.
What the file contains
A useful file answers four questions in order. Which material and which version of the specification? Which lot, and what did its certificate measure? Which route, limits and label rules apply where the product will be sold? What happens to the file if the source, process or pack changes? The COA covers the lot, the TDS covers the specification and the SDS covers handling; the route question sits outside all three.
Keep the allergen and GMO declarations, the origin record, the residual-solvent position and any customer-specific statement in the same file. If a statement is missing for a lot, say so before the order rather than at the port.
The certificate does not choose the route. A supplement, a fortified food and a food additive are separate categories, and the same copper salt can be acceptable in one and not another. The destination, the daily amount and the label wording decide.
European Union
Food supplements in the EU sit under Directive 2002/46/EC. Its annexes name the nutrients and the forms that may be used, and the directive also sets the label particulars. The buyer's team checks the current annex entry for copper gluconate, the language of the member state and any national notification. Alongside it: general food law (Regulation (EC) No 178/2002), labelling (Regulation (EU) No 1169/2011), contaminants (Regulation (EU) 2023/915) and claims (Regulation (EC) No 1924/2006).
If the use is as a food additive instead, Regulation (EC) No 1333/2008 and its lists are the entry point, and the evidence is not the same. The buyer should tell the supplier which route the file is being built for; a supplement specification cannot answer an additive question.
Copper has a reference value for labelling. The label gives the amount of the nutrient per portion and the percentage of that value, calculated from elemental copper rather than from the salt.
United States
US regulation begins with the intended use. A dietary supplement follows DSHEA and 21 CFR 111; a conventional food or a food additive follows another path. The supplier names the basis for the ingredient and points to the document behind it; the buyer confirms that the basis reaches the finished product and the claim.
21 CFR 101.36 sets the Supplement Facts panel: copper per serving and the percentage of the Daily Value. The ingredient line names the source, so copper gluconate and copper bisglycinate cannot be swapped at the same copper number. A structure/function statement must be truthful, substantiated and carry the DSHEA disclaimer; disease claims are outside the route. Label and claim review sit apart from the certificate.
State rules and customer specifications can be tighter than the federal requirement; record the state and the customer standard that apply.
Contaminants and the finished dose
The contaminant calculation belongs to the finished product, not only to the drum. Start with the table below, then apply the destination text and the daily dose to reach the final number.
| Parameter | Typical supplement reference | What the file should show |
|---|---|---|
| Lead (Pb) | 3.0 mg/kg in the supplement (EU) | Lot result, method, limit and the finished-product calculation |
| Cadmium (Cd) | 1.0 mg/kg in the supplement (EU) | Lot result and any category exception that applies |
| Mercury (Hg) | 0.10 mg/kg in the supplement (EU) | Lot result and method |
| Arsenic (As) | Customer or market limit | The agreed limit and the method |
For copper the element is the nutrient, not a contaminant. The raw-material copper figure of 13.5–14.5% is used to calculate how much salt delivers the declared daily amount, and that amount is checked against the applicable upper-level guidance for the market. That is a finished-product calculation, not a raw-material specification.
Contaminant results are converted to the finished dose. A raw material at the lead ceiling leaves no headroom if the salt is the only source and the daily amount is large; a multi-mineral formula needs tighter limits. Microbiology is a buyer requirement everywhere; the catalog sets APC ≤1,000 cfu/g, yeast and mould ≤100 cfu/g, and absence of E. coli and Salmonella.
Label and claims
Nothing on this page or in the specification is a disease claim. Nutrient and structure/function claims depend on the market: the EU and GB registers list authorised wording and conditions, while the US permits substantiated structure/function statements with the DSHEA disclaimer. The brand's reviewer checks the wording, the dose and the product category.
The certificate does not authorise a claim, and a claim does not alter the specification. The label names the copper source and declares elemental copper; claim review is a separate exercise with its own evidence.
The document pack
| Document | What it must show | Scope |
|---|---|---|
| Certificate of analysis | Lot, tests, methods, limits, results and basis | Every lot |
| Specification | Identity, assay basis, copper, water, physical and contaminant limits | Per product |
| Technical data sheet | Form, typical values, solubility, packing and storage | Per product |
| Safety data sheet | Hazard, handling and transport information | Per product |
| Allergen and GMO statements | Declarable allergens and GM status | Per product |
| Origin and manufacturing flow | Site, route and country of origin | Per supplier |
| Residual-solvent statement | Solvent used, result or declaration | Per product |
A certificate on its own is not a file; it only has meaning against the specification.
Checklist before the first order
- The salt, CAS number and specification version are named.
- The COA reports assay and copper with the basis and methods, and the pair reconciles.
- Water, heavy metals and microbiology are compared with the destination limits at the real dose.
- The route — supplement, food or additive — is confirmed for the destination.
- The label names the copper source and declares elemental copper per portion.
- The claim wording is reviewed and no disease claim appears.
- Source, process and pack are under change control; the retained sample carries the lot code.
Start with the catalog specification on the product hub. The COA page explains the lot certificate, and the identity page covers the analytical evidence. Framework references are in the EU note and the US note; the quality page describes the release file, and the editorial policy explains the review process.
Related documents
Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.
Request a quotation