06 Identity & adulteration

How we prove an algal DHA lot is DHA

Technical document 06 · Reviewed 2026-11-19 · Algal DHA Powder

On this page
  1. Four layers, one material
  2. What the GC run has to show
  3. The DHA, EPA and DPA spectrum
  4. The carrier and the mass balance
  5. XRD has no DHA to see
  6. The routes that pass a DHA assay
  7. How to write the specification
  8. Five questions for the supplier

A DHA lot is proved in four layers: the documentary chain, a GC run that identifies and quantifies the fatty acid, a spectrum that points to the source, and a mass balance covering carrier and oil load. A 10% assay shows DHA is present; it does not show that the oil is algal, that the carrier is as declared, or that the oil is fresh.

In one line

A 10% DHA result says the fatty acid is present; the chromatogram, the fatty-acid spectrum, the carrier balance and the oxidation figures say what the powder is.

Four layers, one material

What each layer establishes, and what it leaves open
LayerEvidenceWhat it establishesWhat it leaves open
DocumentarySpecification, COA, lot code, source statementThe pack is the lot describedWhether the chemistry is right
ChromatographicGC-FID of methyl esters, DHA standard, chromatogramThe peak is DHA and the content is at the stated levelThe source of the oil or the carrier
CompositionalDHA, EPA, DPA and the rest of the profileThe oil has the spectrum of an algal oilThe oil load or the oxidation state
MatrixCarrier, mass balance, moisture, PV and p-AVThe powder is the grade ordered and not degradedThat the DHA is algal on its own

Each layer can be genuine while another is wrong: a correct chromatogram can sit on an oxidised oil, a correct oil can be diluted with carrier, a correct powder can carry another lot's certificate. Identity is what the layers say together; the COA page carries the certificate lines.

What the GC run has to show

The standard method is gas chromatography of fatty acid methyl esters: the oil is extracted, transesterified, separated on a capillary column and measured by flame ionisation. DHA is assigned by retention time against a standard and quantified from an internal standard, giving grams per 100 g, or from peak area, giving the composition of the extracted oil. The certificate should name the column, programme and calculation.

The extraction must recover the oil without changing it, and the recovery should be stated. The separation must resolve DHA from the neighbouring C22 fatty acids, or a shoulder inflates the peak. The result must say whether it refers to the powder or the extracted oil: on a 10% powder the denominators differ by a factor of four.

A single peak is not a full identity: a blend can be built to produce it. The chromatogram is evidence when it shows the rest of the spectrum.

The DHA, EPA and DPA spectrum

Algal oil from Schizochytrium is DHA-dominant: EPA is a small fraction and DPA is measurable. Fish oil is a broader omega-3 mixture in which EPA usually carries a substantial share, it also contains long-chain monounsaturates such as C20:1 and C22:1, and a cholesterol fraction. The spectrum is a source fingerprint, not a purity measure.

Spectrum markers that separate algal oil from fish oil
MarkerAlgal DHA oilFish oilWhy it matters
DHA shareDominant fatty acidSubstantial, alongside EPAExplains the 10% basis
EPASmall fractionUsually a larger shareSource indicator
DPAMeasurablePresent, variableProfile comparison
C20:1 and C22:1LowPresentMarine-oil marker
SterolsAlgal patternCholesterol-rich patternConfirms the source family

A single marker can be added, but a profile that matches on DHA, EPA, DPA, the monounsaturates and the sterols is hard to fake at commercial scale.

The carrier and the mass balance

Modified starch is the wall, and the wall is most of a 10% powder, which makes the carrier part of identity: the right DHA figure with the wrong carrier is a different material for the label and the allergen file. The certificate should declare the carrier and its source; the specification should say whether the starch is maize, tapioca or wheat derived — wheat brings an allergen question the other two do not.

The mass balance ties the layers together. DHA, the other fatty acids, the carrier, moisture and ash should account for the powder, and the oil load should fit the DHA figure and the oil's own assay. A 10% powder built on a 40% DHA oil is roughly a quarter oil; a much larger implied load needs explaining.

XRD has no DHA to see

XRD is not an identity method for algal DHA powder. DHA is an oil at room temperature with no crystal lattice; the powder's pattern comes from the carrier, not the fatty acid, so a diffractogram cannot show DHA, quantify it or separate algal from fish oil. GC-FID of the methyl esters, the fatty-acid profile and the sterols carry identity.

XRD's use is physical: whether a spray-dried carrier is amorphous or partly crystalline, which affects flow and encapsulation, or whether a crystalline mineral excipient is present. Those are process questions, not identity lines.

The routes that pass a DHA assay

Adulteration routes for algal DHA powder and the test that gives it away
RouteWhat survives the assayWhat exposes it
Fish oil substitutedA DHA result inside 10%EPA, DPA, C20:1 and C22:1 profile; sterols
Lower DHA sold as 10%Appearance and the grade nameAssay, mass balance, oil load
Oxidised oilThe DHA assayPV and p-AV, TOTOX, odour
Undeclared carrier or dilutionA 10% result with no carrier lineMass balance, moisture, microscopy
Ethyl ester or another lipid classTotal DHA by GCLipid class, glycerol or ethyl ester evidence

DNA testing is not the answer: a refined oil holds little amplifiable DNA, so a negative fish-DNA result proves little; the fatty-acid and sterol profile carries the case and belongs in the specification.

How to write the specification

Write the full name and source: “Microencapsulated algal DHA powder 10%, oil from Schizochytrium sp., modified-starch carrier.” Then the analytical lines: “DHA ≥10.0% by GC (CAS 6217-54-5); EPA and DPA reported on the same run; oil load declared; carrier modified starch, source declared; free oil reported; moisture ≤5.0%; PV ≤5.0 meq/kg; p-AV ≤20.0; ≥95% through 40 mesh; heavy metals Pb ≤3, As ≤2, Cd ≤1, Hg ≤0.1 mg/kg; APC ≤1,000 cfu/g, yeast and mould ≤100 cfu/g, E. coli and Salmonella absent.”

Add the negative statements the label depends on: “Not fish oil; no fish-derived carrier; no undeclared carrier.” Pair each with the test that catches it: the spectrum for fish oil, the mass balance for an undeclared carrier. The algal versus fish oil page takes the comparison further; the fish oil powder page shows the parallel specification.

Five questions for the supplier

  1. Which GC method and standard produced the DHA result, and is it on the powder or the extracted oil?
  2. What are DHA, EPA, DPA and the rest of the profile on this lot, and can I see the chromatogram?
  3. What is the oil load and the carrier, including starch source, and what is the free or surface oil?
  4. What are the peroxide value, p-anisidine value and moisture on this lot, by which methods?
  5. Which algal strain and oil supplier sit behind the lot, and what is the allergen statement?

The catalog specification is on the algal DHA powder hub, storage behaviour is on the stability page, and evidence retention is on the quality page.

Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.

Request a quotation