02 Source comparison

Algal DHA or fish oil: choosing an omega-3 source

Technical document 02 · Reviewed 2026-11-19 · Algal DHA Powder

On this page
  1. Two sources, one powder format
  2. What the two 10% powders actually declare
  3. What the grade does to the powder
  4. What the grade does to the dose arithmetic
  5. How to write the specification
  6. When the powder is the wrong choice

Both products are sold as omega-3 powders, but a 10% algal DHA powder and a 10% fish oil powder do not declare the same thing. The algal product is standardised on DHA alone at ≥10.0% by GC; the fish product is standardised on EPA plus DHA at ≥10.0%, so its DHA per gram is generally lower. The source also decides the allergen statement and the name on the ingredient list.

In one line

The source decides what the label can say, and the grade decides how much powder a declared intake needs; they are separate decisions.

Two sources, one powder format

An omega-3 powder exists to put an oil into a dry matrix: a capsule, a stick, a gummy or a beverage. The oil can come from a fermented alga or from rendered fish, and either oil can be encapsulated in a starch wall and milled to a mesh size. The physical format is therefore not the decision. The fatty-acid profile, the allergen position and the source file are.

Algal DHA is produced by fermentation, so the oil is DHA-dominant with a small EPA fraction and a measurable DPA fraction. Fish oil is a mixture in which EPA and DHA both matter, and the ratio between them varies with the species and the season. A formulator who needs a declared DHA figure and a fish-free label starts elsewhere than one who needs a total omega-3 figure and an established fish-oil name.

What the two 10% powders actually declare

Label basis of a 10% algal DHA powder and a 10% fish oil powder
LineAlgal DHA powder 10%Fish oil powder 10%
Standardised onDHA ≥10.0% by GCEPA + DHA ≥10.0% by GC
DHA per 100 gAt least 10 gA fraction of the 10% total, reported on the COA
EPASmall fraction, reportedReported, usually a larger share
Ingredient listAlgal oil (Schizochytrium sp.)Fish oil
AllergenNot a fish ingredientFish is a declared allergen

The trap is the word “10%”. Two quotations can both say 10% and describe different quantities of DHA, because one percentage is a single fatty acid and the other a sum. A specification that says only “omega-3 10%” does not say which fatty acid the figure refers to, and the label needs DHA, not the sum.

What the grade does to the powder

The catalog grade is the 10% powder at ≥95% through 40 mesh. A 20% grade is available on request, and the trade is simple arithmetic: twice the DHA per gram, half the powder per serving, and a higher oil load inside the same starch wall. At 10% DHA the wall is the larger part of the powder; at 20% the oil is a much bigger share of the particle, so the barrier has less material to work with per gram of oil and the powder depends more on the pack.

Mesh and flow matter as much as the assay on a filling line. A 40 mesh powder flows into capsules and stick fills, disperses in water without dissolving — the oil sits inside the wall, so the dispersion is a suspension, not a solution — and compresses into a tablet only at a low oil load. Gummies and chews add heat and water; beverages add both plus a long hold time. Each matrix needs a trial with the actual powder, not with a similar grade from another supplier.

What the grade does to the dose arithmetic

The percentage converts a label figure into powder weight. At 10% DHA, one gram of powder carries 100 mg of DHA; at 20%, 200 mg. A label that declares 200 mg DHA per serving therefore needs 2.0 g of the 10% powder or 1.0 g of the 20% grade, before any overage the brand decides to add. The same arithmetic runs the other way: a fixed capsule fill caps the DHA a capsule can declare.

Powder weight for a 200 mg DHA declaration, before overage
GradeDHA basisPowder for 200 mg DHA
Algal DHA 10%≥10.0% by GC2.0 g
Algal DHA 20%Set on the order, on request1.0 g at a 20% result
Fish oil 10%EPA + DHA ≥10.0%From the lot's DHA result, not the 10% sum

A 500 mg capsule filled with the 10% powder carries about 50 mg of DHA, so a 200 mg declaration needs four capsules or a larger fill. That is where the 20% grade, a bigger capsule or another dosage form becomes the design question — a question about the label, not the powder's quality.

How to write the specification

Name the source and the grade in the product name: “Microencapsulated algal DHA powder 10%.” Then write the analytical lines: “DHA ≥10.0% by GC (CAS 6217-54-5); EPA and DPA reported on the same run; oil from Schizochytrium sp.; carrier modified starch, declared; moisture ≤5.0%; peroxide value ≤5.0 meq/kg; p-anisidine value ≤20.0; ≥95% through 40 mesh; heavy metals Pb ≤3, As ≤2, Cd ≤1, Hg ≤0.1 mg/kg; APC ≤1,000 cfu/g, yeast and mould ≤100 cfu/g, E. coli and Salmonella absent; allergen statement: no fish ingredient.”

Two clauses prevent most misunderstandings. First, the CAS number identifies DHA, not the powder; it belongs on the specification as the marker, next to the assay. Second, add the negative line that the label depends on: “Not fish oil; no fish-derived carrier.” A negative line is only useful if the file can support it, so pair it with the source statement and the fatty-acid profile.

When the powder is the wrong choice

The powder is not the automatic answer. A softgel holds oil directly, and one gram of fill carries far more DHA than one gram of a 10% powder, so a high-dose softgel is usually an oil project. A clear beverage is a poor fit unless the formula tolerates haze and sedimentation. A market that does not permit the carrier, or a label that names fish oil, rules the powder out for reasons unrelated to its assay.

The source choice also belongs to the label, not only to the formula. Switching from fish oil to algal DHA changes the ingredient name, the allergen statement and possibly the regulatory route, which is a change-control event. The algal versus fish oil page takes the label question line by line; the compliance page sets out the market files, and the fish oil powder page carries the comparison specification. The catalog grade sits on the algal DHA powder hub.

Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.

Request a quotation