02.1 Pancreatin vs pancrelipase

Pancreatin vs pancrelipase: the triad, the ratio and the label

Technical document 02.1 · Reviewed 2026-11-19 · Pancreatin

On this page
  1. Two monographs, two articles
  2. The ratio is the product
  3. The units are shared, the material is not
  4. What the label declares
  5. Two routes, not one
  6. When each is the right purchase

Pancreatin and pancrelipase are both USP articles made from pancreas, and both are assayed with the same three USP units, but they are not interchangeable. Pancreatin is a minimum of 25 USP U/mg amylase, 25 protease and 2 lipase, from hog or ox pancreas; pancrelipase is a minimum of 100 amylase, 100 protease and 24 lipase, from hog pancreas, labelled by lipase activity. The ratio and the label follow from those two monographs, and so does the regulatory route.

In one line

The two monographs share three USP units but not the same ratio, source or label: pancreatin is an amylase-protease-lipase 25:25:2 triad from hog or ox pancreas, pancrelipase a 100:100:24 lipase-led article from hog pancreas.

Two monographs, two articles

Both articles are pancreas extracts, but the monographs define them differently. The minima, the permitted species, the ratio and the label basis all change together.

USP pancreatin and USP pancrelipase · the article definitions
PropertyPancreatinPancrelipase
SourceHog or ox pancreasHog pancreas only
Minima per mg (amylase : protease : lipase)25 : 25 : 2 USP U100 : 100 : 24 USP U
Ratio (amylase : protease : lipase)12.5 : 12.5 : 14.17 : 4.17 : 1
Lipase per mg1×12× the pancreatin minimum
Labelling basisA whole-number multiple of the three minima, or pancreatinLipase activity in USP units
StorageTight container, not more than 30 °CTight container, not more than 25 °C

The table is the comparison in one view. The two articles are not the same material at different dilutions: the ratio changes, the permitted species changes, and the label basis changes.

The ratio is the product

The minima are floors, and the ratio is the part that matters. Pancreatin at its minima is 12.5 parts amylase and 12.5 parts protease to one part lipase. Pancrelipase at its minima is about 4.17 parts of each to one part lipase, with twelve times the lipase per milligram.

Work the arithmetic on a 100 mg inclusion. At the minima, 100 mg of pancreatin carries 2,500 amylase, 2,500 protease and 200 lipase units. The same 100 mg of pancrelipase carries 10,000 amylase, 10,000 protease and 2,400 lipase units. Delivering 2,400 lipase units from 1× pancreatin at its minimum would take 1,200 mg of powder, twelve times the mass. That is why the lipase-rich article exists, and why a formulator cannot use the two as interchangeable weights.

Pancrelipase is not a uniform concentrate of pancreatin, either. Its amylase and protease are only four times higher per milligram, not twelve. A formula built on the 12.5 : 12.5 : 1 ratio cannot be rebuilt by weighing less pancrelipase, because the balance of the three activities would change.

The units are shared, the material is not

The two monographs use the same three USP unit definitions. One USP unit of amylase decomposes starch at 0.16 µEq of glycosidic linkage per minute; one unit of protease liberates, per minute, peptides not precipitated by trichloroacetic acid that match 15 nmol of tyrosine at 280 nm; one unit of lipase liberates 1.0 µEq of acid per minute at pH 9.0 and 37 °C. A USP lipase unit from pancreatin and a USP lipase unit from pancrelipase are therefore the same unit, measured by the same assay.

A shared unit is not a shared material. The unit says how fast a preparation works under one assay; it does not say how much amylase or protease sits beside it. Nor does it make the unit interchangeable with FIP, Ph. Eur. or supplier units, which use different substrates and conditions. The LU versus FIP note on the lipase page shows the same problem in another unit system.

What the label declares

Pancreatin may be labelled as a whole-number multiple of the three minimum activities when it is stronger than 1×, and a dilution has to declare its carrier. A supplement panel that declares pancreatin should state the three activities and the species, not only the mass of powder. “Pancreatin 25/25/2” describes the minimum; a 3× lot should be labelled 3× and meet 75/75/6.

Pancrelipase is labelled to indicate lipase activity in USP units. The monograph requirement is the lipase figure, so a buyer should ask for the amylase and protease results on the same certificate and on the label. Calling a 12× pancreatin “pancrelipase” because the lipase numbers match is a label error: the article, the source and the ratio are different. Calling pancrelipase “pancreatin 12×” has the same problem in reverse.

Two routes, not one

In the United States, pancrelipase is the active substance of FDA-approved prescription products. A pancreatin ingredient for a supplement or a food use is reviewed on its own basis, which the brand's regulatory team confirms; the certificate does not establish it. A pharmacopoeial article supplied for a drug product is a separate route again.

In the EU, a food enzyme sits under Regulation (EC) No 1332/2008, and the Union list is still pending at this review, so national provisions apply under Article 24. In the UK, Great Britain and Northern Ireland are checked separately. No page on this site asserts that either article is authorised for a named market; the destination, the finished product and the intended use decide.

When each is the right purchase

Choosing between pancreatin and pancrelipase
SituationArticle to specify
A supplement or food enzyme built on the 25:25:2 triadPancreatin 1×, with the species named
A high lipase activity in a small fillPancrelipase, with the full ratio checked
An ox-pancreas sourcePancreatin; pancrelipase is hog only
A label that already declares pancrelipasePancrelipase, with the regulatory route confirmed
A formula built on the pancreatin ratioPancreatin; pancrelipase is not a weight-for-weight substitute

The choice is not made by comparing one number. Put the source, the three activities, the ratio, the label basis and the regulatory route side by side, and change the specification and the label together if the article changes.

The catalog position is on the pancreatin product page; the grade options are on the pancreatin grade page; the release lines are on the COA page; the single-activity comparison is on the lipase page and the amylase page; the market files are on the compliance page; the release workflow is on the quality page.

Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.

Request a quotation