06 Identity & adulteration

Proving a chymotrypsin lot: ATEE rate, protein and trypsin limit

Technical document 06 · Reviewed 2026-11-19 · Chymotrypsin

On this page
  1. The identity layers
  2. The two ratios that matter
  3. X-ray diffraction is a weak tool here
  4. What substitution looks like
  5. What to write into the specification
  6. Questions to put in writing

A chymotrypsin lot is the named enzyme when five separate checks point the same way: the paperwork names the protein and its source, the ATEE assay gives a rate in the expected range, gel electrophoresis shows a band near 25 kDa, the trypsin figure stays inside its limit, and protein, moisture and activity add up to a coherent mass balance. No single figure proves identity; the activity alone would also fit a pancreas fraction or a partly inactivated preparation.

In one line

The proof of identity is the pattern formed by several measurements, not the activity number that a certificate prints first.

The identity layers

A supplier can put the right name on a drum and still ship a different protein. The layers below separate what is claimed from what is measured.

Five layers of chymotrypsin identity
LayerQuestionTestWhat it proves
PaperworkDoes the label name the enzyme and its source?Name, CAS 9004-07-3, species and tissueThat a document exists
RateDoes the powder hydrolyse ATEE?ATEE assay at 237 nm, pH 7.0, 25 °CA chymotrypsin-type protease
SizeIs the protein close to 25 kDa?Electrophoresis under reducing conditionsA protein of the expected size
CompanionHow much trypsin is present?BAEE assay at 253 nmHow clean the separation was
BalanceIs the activity diluted or partly lost?Protein, moisture, specific activityWhether the numbers fit together

The two ratios that matter

Two ratios expose what the activity figure hides. The first is trypsin activity divided by chymotrypsin activity; the two enzymes are separated from the same gland, and a high ratio means the separation stopped early, while a very low ratio means the trypsin was removed deliberately. Neither case is visible in the chymotrypsin figure itself.

The second is units per milligram of protein. If the protein is high but the activity is ordinary, part of the powder is inactive: unactivated chymotrypsinogen, denatured enzyme, or a foreign protein. If the protein is low and the activity is ordinary, the preparation is relatively pure. Chymotrypsinogen deserves a separate look because it is the precursor, it has a similar molecular weight, and it contributes protein without contributing ATEE activity; an incomplete activation step is therefore a protein-to-activity problem, not an activity problem.

Taken together, the ratios diagnose the process. A high trypsin ratio points to the separation. A low specific activity points to activation, drying or storage. A shift across several lots is more informative than any one certificate.

X-ray diffraction is a weak tool here

Chymotrypsin is an amorphous solid, so a diffraction pattern is a diffuse band rather than a series of sharp lines, and it cannot establish that the protein is chymotrypsin. A certificate that presents “XRD conforms” as identity evidence for this product has used a method that cannot answer the question.

Diffraction is still useful for one thing: crystalline carriers. Lactose monohydrate, dextrose and sodium chloride produce sharp reflections, so a powder that has been extended with one of them can show a pattern even when its activity per gram has been adjusted to look normal. Ask for the reference pattern and the detection limit before accepting a match; a sharp pattern in a material sold as carrier-free deserves an explanation.

The catalog identity test is the ATEE assay together with infrared spectroscopy, and the infrared comparison is a similarity check on the amide bands, not a sequence determination. For a disputed lot, peptide mass fingerprinting or N-terminal sequencing gives the sequence-level answer that infrared and diffraction cannot. The methods section explains what each technique proves and what it leaves open.

What substitution looks like

How a chymotrypsin substitution shows up
SubstitutionWhat it doesSignalTest
Pancreas fraction rich in trypsinCompanion activity risesTrypsin ratio above the limitBAEE assay on the same lot
Different proteaseGeneral protease method is positiveWrong band size; different substrate patternElectrophoresis and a substrate panel
Crystalline carrierActivity per gram fallsSharp diffraction; high ashDiffraction, ash, moisture
Heat or autolysis damageProtein remains, activity fallsLow specific activity; fragment ladder on the gelProtein and ATEE assay
ChymotrypsinogenProtein present, no activityNormal protein with low activitySpecific activity and activation check
Undeclared sourcePaperwork does not match the materialInconsistent source statementDocuments; species-specific test where needed

The fragment ladder is worth understanding. Active chymotrypsin that has been held warm or alkaline cuts itself and other protein chains, so a gel shows the main band plus smaller fragments. A powder can pass a protein assay and still fail an activity specification for that reason.

What to write into the specification

  • “Chymotrypsin, source and tissue named, CAS 9004-07-3, EC 3.4.21.1.”
  • “Activity ≥1,000 USP U/mg by ATEE at 237 nm, pH 7.0, 25 °C, with the basis stated.”
  • “Identity by ATEE activity plus infrared comparison to a reference.”
  • “Trypsin limited as a ratio to the chymotrypsin activity on the same lot.”
  • “Protein and specific activity reported where agreed, method named.”
  • “Loss on drying ≤5.0%; carrier declared; no second enzyme unless named.”
  • “Source and TSE statement with every lot.”

Questions to put in writing

  1. What species and tissue does this lot come from, and which certificate line records it?
  2. What are the chymotrypsin and trypsin figures for this lot, and in which units?
  3. Will you send the protein value, the specific activity and the gel image?
  4. How do you show that the chymotrypsinogen was fully activated?
  5. If we disagree on the result, will you share the retained sample and repeat the method?

Those five answers, in writing, are the identity file. The catalog entry is on the chymotrypsin product page; the COA page shows where each figure sits, the grades page contrasts the powder with a blend, the chymotrypsin versus trypsin page takes the two-enzyme question further, the companion enzyme is described on the trypsin product page, and the quality page describes release.

Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.

Request a quotation