Which chymotrypsin grade: activity, trypsin content and form
The catalog grade is a purified chymotrypsin powder at ≥1,000 USP U/mg by the ATEE assay, white to off-white, at least 95% through 40 mesh and freely soluble in water. A crystallised preparation with a higher activity, a diluted or granulated powder, a trypsin–chymotrypsin blend or a fermentation-derived food enzyme is a different purchase, with its own assay, carrier statement and label.
A chymotrypsin grade is fixed by three numbers and one form: activity, trypsin limit, specific activity and the physical state of the powder, not by the word chymotrypsin alone.
Why the name does not fix the grade
Chymotrypsin is extracted from pancreas, where it sits beside trypsin, carboxypeptidases, amylase and lipase. The zymogen chymotrypsinogen is activated by trypsin, and the purification train then decides how much active chymotrypsin and how much trypsin travel into the powder. Drying and blending set the activity per gram of the material that is finally packed. “Chymotrypsin” names the enzyme; it does not name any of those steps.
The word “alpha” is often added, and it describes a crystallised form of the enzyme rather than a purity grade. Two alpha-chymotrypsin powders can differ in activity, in trypsin content and in salt load. Activity and purity are separate axes, and the trypsin ratio is a third axis that a single activity figure hides.
What changes between grades
| Grade | Activity | Trypsin | What changes for the buyer |
|---|---|---|---|
| Purified powder, catalog | ≥1,000 USP U/mg by ATEE | A ratio cap written into the specification | The reference grade: 40 mesh, water-soluble, 1 kg and 25 kg |
| Higher-activity crystallised | Higher figure, same ATEE method | Shown as its own result | Less powder per dose and a narrower weighing range |
| Cut with a carrier | Fewer units per gram | Set by the concentrate | Carrier named on the label; more powder per dose |
| Granulated | Assayed on the granule | Set by the concentrate | Lower dust, slower wetting, new mesh |
| Chymotrypsin with trypsin | One figure per enzyme | Intended, not a cap | Both enzymes and both unit systems declared |
| Fermentation-derived | Defined by its own method | No animal companion | A production organism and a separate file |
The first row is the grade catalogued here; the rest are distinct products, each needing its own specification instead of the word “chymotrypsin” with a different number attached. Dilution shows why: the units per gram depend on how much carrier was added, so two diluted powders with the same declared strength may contain different amounts of enzyme.
Powder, dust and dissolution
The catalog material is a white to off-white, free-flowing powder; at least 95% of it passes through 40 mesh. In water it gives a clear solution, an advantage in a liquid trial or a stick pack and a minor point in a capsule, where the fill is weighed as a solid. Particle size matters twice: coarser granules segregate less in a blend, and they also take longer to wet out.
Airborne powder is a respiratory sensitiser, and the safety data sheet names the extraction and protective measures. Granulation lowers dust and improves flow, but it alters the sieve result and the wetting time, so the change belongs in the specification. The solid also takes up moisture, and lumps in the pouch interfere with weighing long before they affect a certificate.
Dose arithmetic in units, not milligrams
Convert the label target into a mass by dividing the target units by the activity on the certificate. A capsule filled with 500 mg of the catalog powder contains at least 500,000 USP units; a target of 250,000 units needs 250 mg of the same powder. A blend that carries 5,000 U/g needs 100 g for 500,000 units, which is why a blend is bought on its own assay rather than on the concentrate's figure.
These are arithmetic examples, not a dose recommendation; their purpose is to keep label, weigh-up and certificate aligned. As activity rises, the mass per dose falls, and uniform mixing becomes the limiting issue; a diluted or granulated grade may suit the line better than a more concentrated one.
What to write into the purchase specification
- “Chymotrypsin (CAS 9004-07-3, EC 3.4.21.1), with source and tissue declared.”
- “Activity ≥1,000 USP U/mg by the ATEE assay at 237 nm, pH 7.0, 25 °C; basis stated.”
- “Trypsin limit as a ratio to the chymotrypsin activity, measured on the same lot.”
- “Identification by ATEE activity and infrared spectrum; protein and specific activity where agreed.”
- “Moisture ≤5.0% loss on drying; ≥95% through 40 mesh; metals and microbiology per the table.”
- “Any carrier identified; no other enzyme unless declared; source and TSE statement supplied.”
- “The pack, and the storage condition that goes with it, written into the quotation.”
When the catalog grade is the wrong choice
When the label declares two enzymes, purchase the blend and require an assay for each; a chymotrypsin certificate says nothing about added trypsin. A customer who needs a non-animal source is not served by a pancreas extract, however high its activity. If the line cannot weigh the dose accurately, a dilution with a declared carrier is the practical answer. A liquid held for days is a process problem, not a grade problem: the enzyme attacks itself in water, and no powder choice prevents that.
The catalog entry sits on the chymotrypsin product page, and the two-enzyme question is taken further on the chymotrypsin versus trypsin page. The companion enzyme is described on the trypsin product page, the three-enzyme standard on the pancreatin page, the release lines on the COA page, and the assay vocabulary in the methods section.
In this document
Related documents
Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.
Request a quotation