Chymotrypsin vs trypsin: two serine proteases, two units
Chymotrypsin and trypsin are both pancreatic serine proteases, and both are sold in units defined by USP methods. The shared name is the trap: the chymotrypsin unit is measured with ATEE at 237 nm, the trypsin unit with BAEE at 253 nm, and neither figure can be recalculated from the other. A product that names both enzymes needs two assays, two limits and two numbers on the label.
Two enzymes, two substrates, two wavelengths: the chymotrypsin number and the trypsin number are separate measurements, and no factor turns one into the other.
The two definitions
The table sets the two definitions side by side. What matters is not the size of the absorbance change on its own but the fact that the substrate, the wavelength and the assay pH all differ, so the two rates are not on a shared scale.
| Enzyme | EC number | Substrate | Reading | Assay conditions | Unit definition |
|---|---|---|---|---|---|
| Chymotrypsin | 3.4.21.1 | ATEE | 237 nm | pH 7.0, 25 °C | Absorbance change of 0.0075 per minute |
| Trypsin | 3.4.21.4 | BAEE | 253 nm | pH 7.6, 25 °C | Absorbance rise of 0.003 per minute |
The chymotrypsin unit is the larger absorbance change of the two, and someone will eventually suggest dividing one number by the other. The suggestion fails because the two products absorb differently at their own wavelengths. A conversion would need a common substrate and a common detection wavelength, and this pair has neither.
What the method has to print
A certificate for either enzyme is reproducible only when the reader can repeat the measurement. That means recording the substrate and how much was used, the buffer and its pH, the temperature, the path length, the reaction volume, the raw rate per minute, the weighed enzyme mass and the basis for that mass. A result printed without these is a number, not an assay.
Both methods are kinetic, and both need the initial rate. A reading taken after the reaction has slowed reports less activity than the enzyme actually has, and the mistake is invisible unless the absorbance trace is examined. The chymotrypsin method reads at 237 nm and the trypsin method at 253 nm; a laboratory that reports one wavelength for both has run a single assay and renamed it.
Where each enzyme cuts
The two enzymes recognise different side chains. Chymotrypsin binds an aromatic side chain and cuts the peptide bond on its carboxyl side, so a hydrolysate made with it ends many peptides at tyrosine, tryptophan or phenylalanine; leucine and methionine are accepted, but more slowly. Trypsin binds a basic side chain and cuts after lysine or arginine. The catalytic machinery is shared; the binding pocket is what differs.
That difference is a process decision, not a detail. Two hydrolysates made from the same protein with the two enzymes have different peptide lengths, different terminal residues and often different solubility or taste. A blend produces a third peptide population, not an average of the first two.
Why the activities travel together
Chymotrypsin is made as an inactive precursor, chymotrypsinogen, which trypsin activates by cutting one bond. The two enzymes therefore start in the same tissue and remain together until a separation step removes one. That is why a chymotrypsin specification carries a trypsin limit and a trypsin specification carries a chymotrypsin limit: each certificate has to state how much of the other enzyme survived.
The purification target is not the same in both directions. A chymotrypsin lot is judged on a low trypsin figure; a trypsin lot is judged on a low chymotrypsin figure. Two powders can both be called purified while one carries the companion activity that the other was meant to remove.
Ratios are made of units, not grams
A combination product is normally described by the ratio of activities, for example equal chymotrypsin and trypsin units. That ratio is not a mass ratio. Suppose the chymotrypsin is 1,000 USP U/mg and the trypsin is 250 USP U/mg: one milligram of the first supplies 1,000 chymotrypsin units, while four milligrams of the second supply 1,000 trypsin units. An equal-unit blend is therefore one part chymotrypsin to four parts trypsin by weight.
Writing “equal parts” fixes the weights, not the activities, so the assay may find a ratio nobody intended. The certificate should state the activity of each enzyme, the ratio of those activities and the units in which the ratio is expressed.
Naming both enzymes
When both enzymes are ingredients, both belong on the panel and in the specification, each with its own activity. The word “protease” is not a substitute: it hides which enzyme was added and makes the two assays unverifiable. The species and tissue behind a pancreatic preparation belong in the specification as well.
A trypsin figure can also appear in a chymotrypsin file as a purity limit. That is not the same as a second ingredient, and the label should distinguish the two: a limit records what was removed, an ingredient records what was added. A carrier introduced by dilution or granulation is a third material and has to be declared too.
Choosing the right enzyme
Begin with the bond that has to be broken. Aromatic side chains point to chymotrypsin, basic side chains to trypsin. If both are needed, purchase the combination and require a separate assay and limit for each enzyme, rather than accepting a single-enzyme powder with an unstated companion. If the goal is general proteolysis, neither pancreatic enzyme is necessarily right: neutral and alkaline proteases have their own pH ranges and their own units.
The catalog entry is on the chymotrypsin product page; the grades page sets out the powder choices, the identity page shows the supporting tests, and the COA page covers the release lines. The companion enzyme is on the trypsin product page, the three-enzyme standard on the pancreatin page, the assay vocabulary in the methods section, and the quality page describes release.
Related documents
Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.
Request a quotation