How to prove a lot is L-carnitine L-tartrate
A lot is L-carnitine L-tartrate when the document, the chromatogram, the infrared spectrum, the chiral result and the 2:1 carnitine-to-tartrate ratio agree. The assay alone cannot prove the form: a blend of carnitine and tartaric acid can be made to weigh like the salt, and the base can carry the same carnitine figure. Identity is a set of measurements that close the same question from different sides.
The identity of the tartrate is the substance plus the counter-ion: HPLC and IR name the carnitine salt, and the 2:1 carnitine-to-tartrate ratio proves which salt it is.
The four identity layers
| Layer | Question | Test | What it proves |
|---|---|---|---|
| Record | Is the form named? | Name, CAS number, formula, lot code | Paperwork only |
| Substance | Is it carnitine? | HPLC retention and infrared spectrum | The molecule |
| Configuration | Is it the L form? | Chiral HPLC or polarimetry | The enantiomer |
| Counter-ion | Is it the tartrate? | Tartaric acid by HPLC or titration; carnitine content | The 2:1 salt |
The order matters. A buyer who starts with the assay is looking at the one number that is compatible with every failure mode on the list. The record is the simplest layer and the easiest to check; the counter-ion is the layer that separates the tartrate from the base and from a blend.
The 2:1 ratio and what it catches
The salt pairs two carnitine units with one L-tartaric acid unit. The theoretical mass fractions are 68.2% carnitine and 31.8% tartaric acid. A certificate that reports carnitine at 68.5% and tartaric acid at 31.5% is consistent with the salt; a certificate that reports carnitine at 68.5% but no tartaric acid figure has only told half the story.
The ratio is also the blend detector. A powder made from carnitine base and tartaric acid can be formulated to the same carnitine figure, but the two components are separate solids rather than one salt. The infrared spectrum and the X-ray pattern can show the difference, and the dissolution behaviour may differ as well. The ratio check is not a purity grade; it is a form check.
X-ray diffraction and the solid form
X-ray diffraction reads the crystal lattice. It can show that a lot is the same crystalline form as the reference, and it can catch an amorphous dilution or a physical mixture that the assay does not resolve. It is not a purity assay and it does not measure the counter-ion.
XRD cannot assign the configuration of either half. L-carnitine and D-carnitine are isostructural, and L-tartaric acid and D-tartaric acid are as well, so a diffraction pattern cannot prove which enantiomer is present. Use XRD for the solid form and chiral methods for the configuration; a supplier who offers a diffraction pattern as proof of the L form has offered the wrong evidence.
The substitution routes to check
| Route | What it does | Signal | Test |
|---|---|---|---|
| Base plus tartaric acid | Matches the mass and the carnitine figure | IR or XRD shows two solids; the ratio may drift | IR, XRD, tartaric acid assay |
| D- or DL-tartaric acid | Alternative counter-ion; same mass | Chiral result differs; rotation shifts | Chiral HPLC, polarimetry |
| L-carnitine HCl | Different counter-ion; chloride present | Tartaric acid low; chloride high | Ion chromatography, tartrate assay |
| Dilution with a carrier | Lowers both fractions | Salt assay and carnitine both low | Mass balance, loss on drying |
| D-carnitine or a racemate | Same mass, wrong enantiomer | Chiral result; rotation toward zero | Chiral HPLC, polarimetry |
Each route is caught by a different line. The salt assay catches dilution; the carnitine figure catches a low carnitine load; the tartaric acid figure catches the wrong counter-ion; the chiral result catches the wrong enantiomer. A certificate that reports only the salt assay has tested one of the five.
How to write identity into the specification
- “L-carnitine L-tartrate, CAS 36687-82-8, C18H36N2O12, 2:1 salt.”
- “Assay 98.0–102.0% by HPLC; state the basis.”
- “L-Carnitine content 68.0–72.0% by HPLC or titration.”
- “Tartaric acid content consistent with the 2:1 ratio, with the method named.”
- “Identification by HPLC retention and infrared spectrum.”
- “Chiral HPLC for D-carnitine, and a chiral check on the tartrate where the risk assessment needs it.”
- “Loss on drying ≤1.0%; particle size ≥95% through 80 mesh.”
Five questions for the supplier
- Which form and CAS number are on the certificate, and is the carnitine figure on the same basis as the salt assay?
- What is the tartaric acid result, and which method produced it?
- Can you provide the HPLC chromatogram, the infrared spectrum and the chiral result, not only the assay percentage?
- What is the loss on drying on this lot, and how was the carnitine figure calculated?
- If this lot is challenged, which retained sample would both sides test, and at which laboratory?
Five answers, each tied to a different measurement, build the identity file; one assay percentage cannot. The product page carries the catalog specification; the COA page shows where each figure sits on the certificate; the grades page compares the forms; the level-four comparison covers fill and water; the methods index explains the separations; the quality page describes the release file; and the L-carnitine page covers the base form.
Related documents
Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.
Request a quotation