How we prove a vitamin D2 oil lot is ergocalciferol
A vitamin D2 oil lot is ergocalciferol when the specification names the form and CAS 50-14-6, HPLC retention and the ultraviolet spectrum match an ergocalciferol standard, the IU arithmetic reconciles with the concentration, and the carrier and antioxidant are declared. At 1.0 MIU/g the vitamin is only about 2.5% of the oil, so colour proves nothing; the chromatogram carries the identity.
Identity in an oil is the chromatogram, the UV spectrum and the IU arithmetic agreeing, with the carrier and the D3 screen written into the record.
The identity layers
Naming the right material on paper does not prove that the material is in the bottle. The layers are separate questions, each with its own proof. Stopping at the first one proves only that the paperwork exists.
| Layer | Question | Evidence | What it proves |
|---|---|---|---|
| Document | Is the form and CAS named? | Ergocalciferol, CAS 50-14-6, C28H44O | Paperwork only |
| Chromatography | Is the peak ergocalciferol? | HPLC retention against a D2 standard, with D3 separated | The molecule |
| Spectrum | Is the ultraviolet profile right? | UV maxima near 265 nm and the absorbance ratios | The chromophore |
| Mass balance | Does the IU/g match the mass? | IU/g ÷ 40 = µg/g, compared with the HPLC result | The concentration |
| Carrier | What carries the vitamin? | Carrier name, fatty-acid profile, allergen statement | The full composition |
The IU ratio and the mass balance
Because 1 µg of ergocalciferol equals 40 IU, a 1.0 MIU/g oil holds 25,000 µg of the vitamin in every gram. That is 25 mg/g, or 2.5% by mass; the 1.1 MIU/g grade reaches 27,500 µg/g and 2.75%. These values come from the IU definition and are independent of the supplier.
Audit the arithmetic in both directions: micrograms per gram from HPLC multiplied by 40 should equal the certificate's IU/g, and dividing IU/g by 40 should return the same micrograms. A mismatch means one figure is wrong. The certificate should show its conversion so a reader can reproduce it. At 2.5%, the carrier outweighs the vitamin by about thirty-nine to one, which is why the carrier record matters.
A second ratio matters when both forms are screened. Ergocalciferol and cholecalciferol share the 40 IU per microgram convention and a similar ultraviolet spectrum, so the IU figure cannot separate them; retention time and the peak-area ratio can. A D2 peak with a D3 shoulder is a mixed lot even when the total vitamin D area sits inside the potency range. The certificate should name the D2 standard and give the D3 detection limit.
Ergocalciferol is made by ultraviolet irradiation of ergosterol, and the reaction leaves a family of isomers. Previtamin D2, lumisterol and tachysterol can survive purification, and a related-substance method is what shows them. A lot can pass its potency range while the isomer profile moves, so the chromatogram deserves a look even when the IU number is comfortable.
X-ray diffraction: what it can and cannot do here
X-ray diffraction is a solid-state method: it asks whether a material is crystalline and whether its pattern matches a reference. An oil is a liquid solution, so XRD has no release role for it; a certificate claiming “XRD conforms” for oil says very little. Use the method on the crystalline raw material, on a powder on carrier, or on a solid that separates from the bottle.
For the crystal, the melting range of 115–118 °C is the simpler solid-state check, and XRD is the stronger evidence when a lot is disputed or a new source is qualified. For the oil, the stronger evidence is HPLC with UV detection, the IU arithmetic and the carrier profile. A match statement needs the reference pattern and the detection limit before it can be read.
What adulteration looks like
| Adulterant | What it does | Signal | Test |
|---|---|---|---|
| Vitamin D3 | Lower-cost source with the same IU convention | Different retention; D3 peak where D2 should be | HPLC/UV with both standards; LC-MS |
| Carrier dilution | Lowers IU/g while keeping the colour | Potency below the range; mass balance off | HPLC potency, IU arithmetic |
| Oxidised carrier | Rancid oil; vitamin loss follows | Peroxide value above the limit; odour | Peroxide value, fatty-acid profile |
| Undeclared carrier | Allergen or label mismatch | Fatty-acid profile differs from the declared oil | GC fatty-acid profile, allergen review |
| Isomer-rich D2 | Lower potency; extra related substances | Additional peaks; assay short of the label | Related-substance method, UV |
Appearance is the weakest evidence, because a pale yellow colour is easy to reproduce with another carrier. Retention time, UV spectrum, IU arithmetic and peroxide value are harder to fake. If a certificate reports colour and potency but no identity test, the most plausible substitution remains unchecked.
How to write the identity into the specification
- “Ergocalciferol oil, CAS 50-14-6, C28H44O, 1.0–1.1 MIU/g by HPLC.”
- “Identification by HPLC retention against an ergocalciferol standard and by UV spectrum; state the wavelength.”
- “Potency in IU/g with the micrograms-per-gram equivalent; the conversion is 40 IU per microgram.”
- “Carrier oil named; antioxidant package named; peroxide value ≤10.0 meq O₂/kg.”
- “A vitamin D3 screen where the form or the source is in question, with the detection limit.”
- “Heavy metals and microbiology as listed; destination market confirmed before the order.”
Six questions for the supplier
- Who supplied the carrier oil, and where is it declared?
- What potency did the lot release at, in both IU and micrograms?
- Can we see the chromatogram and the spectrum, not just the final number?
- Which antioxidant is present, and what peroxide value did the lot return?
- Was a D3 screen run, and what limit of detection applies?
- If we dispute the result, is a joint re-test on the retain sample available?
Answers to those six questions amount to an identity file in practice; a single potency figure does not. The catalog values are on the product page; the COA page maps each certificate line; the grades page compares the formats; the oil-versus-powder page follows the carrier and label; the vitamin D2 page covers the solid grade; the methods library explains the tests; release is described on the quality page.
Related documents
Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.
Request a quotation