Mixed tocopherols vs alpha-tocopherol: the profile, the use and the label
Mixed tocopherols and alpha-tocopherol are separate ingredients. The first is a four-homologue oil, normally gamma-dominant and carrying only 10–20% alpha; the second is a concentrate of at least 90% d-alpha-tocopherol. That difference sets the vitamin E number, the antioxidant job and the label name, and it cannot be reduced to a strength comparison.
The mixture and the alpha concentrate differ in the profile before they differ in strength, and only the alpha fraction carries the vitamin E figure the label declares.
Two products, not two strengths
CAS 1406-66-2 covers the mixed tocopherols; the product has no single formula because it is a family of homologues. The alpha concentrate is CAS 59-02-9 and C29H50O2, a single molecule. Both are fat-soluble, water-insoluble oils supplied in amber glass, which is why the packs look alike and the products are not interchangeable.
Nor is one a diluted or purified version of the other. Both begin with a vegetable-oil deodorizer distillate, but the concentration step targets different fractions: the mixed grade retains gamma and delta, while the alpha grade enriches alpha and removes most of the others. An order for “tocopherols 90%” specifies neither.
The profile is the difference
| Homologue | Mixed tocopherols (catalog) | Alpha concentrate (catalog) |
|---|---|---|
| Alpha-tocopherol | 10.0–20.0% | ≥90.0% d-alpha |
| Beta-tocopherol | Not set; EU entry below 10.0% | Balance |
| Gamma-tocopherol | 50.0–70.0% | Balance |
| Delta-tocopherol | 10.0–20.0% | Balance |
| Total tocopherols | ≥90.0% | ≥90.0% as d-alpha |
Both columns can begin with a 90% total and still describe different products. The alpha value differs by a factor of four or more, and the mixed product is gamma-dominant while the concentrate is alpha-dominant. That is why the mixed oil suits antioxidant use and the concentrate suits vitamin E potency.
IU, mg alpha and the label arithmetic
Vitamin E arithmetic begins with alpha and uses 1.49 IU per milligram of d-alpha-tocopherol. A 15% alpha mixed oil therefore carries about 224 IU/g; at 10% it carries about 149 IU/g and at 20% about 298 IU/g. A 90% alpha concentrate carries about 1,341 IU/g. Applying 1.49 to the total tocopherols of the mixed oil would overstate its vitamin E several-fold.
The same logic gives the mass per dose. Declaring 15 mg alpha-tocopherol takes about 100 mg of a 15% mixed oil, 150 mg at 10% or 75 mg at 20%; the 90% concentrate needs about 16.7 mg. The EU expresses the label value in mg alpha-tocopherol equivalent, the US in mg alpha-tocopherol, so the same oil does not produce the same number in both markets. Keep the conversion in the label file.
The use decides the choice
The mixed oil does two jobs. In a fat or oil it acts as an antioxidant at a dose expressed as a percentage of the matrix; the gamma and delta homologues are part of why it is selected, and the peroxide value of the blend shows whether it is working. In a supplement it supplies tocopherols, but the vitamin E figure is still taken from alpha.
The alpha concentrate is chosen when vitamin E potency is the objective: a softgel or tablet with a defined IU or mg alpha declaration and a fill weight that cannot accommodate a larger mass of oil. The mixed oil would multiply the mass per dose, so it is not a drop-in. In the other direction, the concentrate cannot supply the gamma and delta fractions a mixed-profile formula is built around.
Stability follows the profile and the pack
Both oils oxidise, and both depend on a sealed, dark, cool pack. The mixed oil carries its own antioxidant fraction, but that fraction is spent as it protects the oil, and peroxide value rises as the reserve falls. The alpha concentrate is also consumed in the same way. Neither has a shelf life independent of its container.
The matrix chooses between them. An oil blend can take either, and the blend's stability test is the evidence. An emulsion needs the tocopherol at the interface, where the mixed profile and the single molecule do not behave identically. A dry powder often does better with the acetate. The stability page describes the protocol.
The label declaration
EU Directive 2002/46/EC Annex II permits mixed tocopherols as a vitamin E form and, as of this review, attaches a composition footnote: alpha below 20%, beta below 10%, gamma 50–70%, delta 10–30%. The label value is in mg alpha-tocopherol equivalent, with the other homologues converted at their own factors. When the oil is used only as an antioxidant, it is declared as an additive — for example, antioxidant: tocopherol-rich extract — rather than as the vitamin E source.
In the US, the Supplement Facts panel states vitamin E in mg alpha-tocopherol against a 15 mg Daily Value, and only alpha counts. Mixed tocopherols may be named in the ingredient list, but gamma and delta do not increase the vitamin E figure. The label must describe the form and role the file covers, not whichever form happens to be in the warehouse.
Which product for which job
Pick the mixed oil for antioxidant protection in a fat or oil, for a label that names mixed tocopherols, or for a formula that needs gamma and delta beside alpha. Pick the alpha concentrate for vitamin E potency, for a d-alpha label, or for a fill that cannot carry the larger mass of mixed oil. Pick the acetate for a dry powder that benefits from the more stable ester.
Changing from one to the other requires change control, a new specification and a new label check. They share a feedstock family and a pack style, but not a profile, a vitamin E value or a label name. The product hub lists the catalog specification; the vitamin E page covers the synthetic acetate powder; the grades page places the comparison in the range; the methods index covers the HPLC assay; the quality page covers release.
Related documents
Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.
Request a quotation