02 Grade comparison

Choosing a choline chloride grade: powder, solution or carrier

Technical document 02 · Reviewed 2026-11-20 · Choline Chloride

On this page
  1. One salt, several grades
  2. The grades side by side
  3. Water, mesh and the powder in the room
  4. Matching the grade to the dosage form
  5. Writing the grade into the specification
  6. When a grade is the wrong choice

Choline chloride appears on the market as a 98–101% crystalline powder, a granulated powder, a 70–75% aqueous solution and a 60% feed-grade product on a carrier. The catalog grade here is the powder at 80 mesh for capsules, tablets and powder blends, with granulation available on request. The grade decides the choline per gram, the water load and whether the material is a food ingredient at all.

In one line

The grade is the carrier, the water and the mesh: the same salt at 99% powder, 75% solution or 60% feed grade is three different specifications.

One salt, several grades

Choline chloride is a single chemical entity: CAS 67-48-1, C5H14ClNO, molecular weight 139.62. What changes between grades is the concentration, the carrier and the physical form. A 99% crystalline powder, a granulated powder of the same assay, a 75% solution and a 60% feed product are four commercial materials with four specifications.

The distinction is not cosmetic. The 60% feed grade is built on a carrier such as corn cob or silica; it is a feed additive, not a food or supplement ingredient, and its carrier changes the ash, the flow and the label. The solution grade carries 25–30% water by design. The granulated grade has the same assay as the powder but a different particle-size distribution, dust level and flow.

A purchase order that says “choline chloride” without the grade has not specified the material. The grade decides how much choline arrives per kilogram, what the water load is, and which regulatory route the pack can take.

The grades side by side

Choline chloride grades · concentration, choline and water
GradeCholine chlorideCholine per gramWaterTypical use
Crystalline powder98.0–101.0% (catalog)About 746 mg at theoreticalLOD ≤1.0%Capsules, tablets, sticks, blends
Granulated powderSame assay as the powderAbout 746 mg at theoreticalLOD ≤1.0%High-speed presses, blends, dust control
Aqueous solution70–75%About 522–560 mg25–30% by designLiquids, syrups, liquid fills
Feed grade on carrierAbout 60%About 448 mgCarrier-dependentAnimal feed only

The choline figures are arithmetic, not a label dose: 104.17 ÷ 139.62 = 0.746, so one gram of the pure salt carries about 746 mg of choline. The catalog fixes the salt assay and the water, not a choline window; the measured choline figure comes from the lot certificate, and it should be used for the label worksheet. The feed grade is listed here to mark the boundary, not as an alternative supply.

Water, mesh and the powder in the room

Choline chloride is deliquescent. It absorbs water from the air until it can become sticky or wet, and the rate rises with temperature and humidity. A 99% powder left in an open dish in a humid room will cake at the surface and then through the mass. The USP monograph directs that it be kept in well-closed containers for that reason, and the catalog loss on drying of ≤1.0% is a release gate, not a storage allowance.

The catalog powder is ≥95% through 80 mesh. That is a finishing specification: it moves with the mill and the sieve, not with the chemistry, and a finer powder has more surface for water uptake and more dust. Granulation coarsens the particles, improves flow and reduces dust, but it does not raise the assay and it does not make the material less hygroscopic; it changes how the powder behaves in the hopper.

pH is 6.0–8.0 in 10% solution, so the salt is close to neutral, unlike the acidic bitartrate. Solubility is high, which is why the solution grade exists and why a spill is easy to clean and hard to dry.

Matching the grade to the dosage form

Capsules. The 80 mesh powder or the granulated form. The powder is the simpler choice; the granulate flows better on a high-speed filler. Control room humidity and keep the hopper covered, because a deliquescent fill will pick up water from the air during a long run.

Tablets. Granulation is the usual answer: it improves flow, reduces dust and gives a more uniform fill. Direct compression is possible with a coarse, free-flowing lot, but the deliquescence still has to be managed by the room and the pack. A tablet that picks up water during compression can stick, cap or soften in storage.

Sticks and drink mixes. The powder dissolves freely and carries a high choline load per gram, which keeps the stick weight down. The taste is bitter, so the flavour system has to cover it. The foil seal is the critical barrier; a pinhole is enough to turn the powder into a cake.

Liquids. The 70–75% solution is the practical input: it is already dissolved, it is pumpable, and it carries no dust. The water is part of the formula, so the preservative system and the pH have to be designed for it. A dry powder can also be dissolved on site, but the solution grade removes a handling step and a dust risk.

Writing the grade into the specification

Start with the salt, the CAS number and the grade. For the catalog powder: “Choline chloride, CAS 67-48-1, assay 98.0–101.0% by titration with the titrant and basis named, choline by HPLC or IC, loss on drying ≤1.0%, pH 6.0–8.0 in 10% solution, total amines within the agreed limit, ≥95% through 80 mesh, and the catalog heavy-metal and microbiology panels.”

If the destination needs the USP monograph, write the monograph limits instead of the catalog ones: 99.0–100.5% on the anhydrous basis, water ≤0.5%, pH 4.0–7.0, total amines ≤0.001%, residue on ignition ≤0.05%, and the monograph's identification by infrared and chloride test. The two specifications are close but not identical, and a lot can meet one and miss the other.

For a solution grade, add the assay, the density or the mass per litre, the water, the pH and the preservative or microbial limits. For a granulated grade, add the particle-size distribution and the bulk density. For any grade, add the food or feed statement, the allergen and GMO statements, and the pack. A grade that is not named in the specification is not controlled.

When a grade is the wrong choice

The feed grade is not a cheaper supplement grade. It contains a carrier, it is sold against feed specifications, and its contaminant and labelling file belongs to feed. A supplement made from it would need a different specification, a different certificate and a different regulatory route.

The solution grade is the wrong choice for a dry blend: it adds water that the blend cannot tolerate. The granulated grade is not a purity upgrade: it is the same assay with a different particle size, so it does not solve a choline shortfall.

The catalog values are on the choline chloride product page. The release panel is on the COA page, the pack and lead time on the MOQ page, and the salt comparison on choline chloride vs choline bitartrate. The choline bitartrate product page carries the other salt, and the quality page describes how a grade is released.

Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.

Request a quotation