02.1 Palmitate vs acid

Ascorbyl palmitate vs ascorbic acid: solubility, use and the label

Technical document 02.1 · Reviewed 2026-11-20 · Ascorbyl Palmitate

On this page
  1. Two materials, one vitamin
  2. Water or oil
  3. What each one is used for
  4. The conversion and the fill weight
  5. What the label has to say
  6. When each is the right choice

Ascorbyl palmitate is the fat-soluble ester of ascorbic acid: 42.5% of its mass is ascorbic acid, it does not dissolve in water, and it dissolves in oils and fats. Ascorbic acid, CAS 50-81-7, is water-soluble and acidic. The two deliver the same vitamin but not in the same phase, and the label has to name the ester and calculate the vitamin C from the ester mass.

In one line

Ascorbyl palmitate is 42.5% ascorbic acid by mass and dissolves in oil rather than water, so it changes the phase, the dose arithmetic and the ingredient name on the label.

Two materials, one vitamin

Ascorbic acid and ascorbyl palmitate side by side
PropertyAscorbic acidAscorbyl palmitate
CAS number50-81-7137-66-6
FormulaC6H8O6C22H38O7
Molecular weight176.12414.53
Vitamin C per gram1.000 g0.425 g
SolubilityWater; slightly in ethanolFats, oils and ethanol; not water
Melting pointAbout 190 °C, with decomposition107–117 °C
EU additive identityE 300E 304 (i)
Typical roleVitamin source, acidulant, antioxidantOil-soluble antioxidant, vitamin C source

The table is a comparison, not a ranking: each material has its own CAS, specification and label name, and a purchase order that says “vitamin C” has specified neither.

Water or oil

The ester is practically insoluble in water and soluble in fats, oils and ethanol. In a softgel fill or an oil blend it dissolves in the oil phase; in an emulsion it partitions into the oil droplets; in a dry capsule it sits as a powder in the fill. In a clear aqueous drink it does not dissolve, and a suspension is a different product with a visible cloud and its own stability study.

Ascorbic acid is the opposite: it dissolves readily in water and gives an acidic solution. That is why it suits a stick pack or a drink, and why it can attack an acid-sensitive matrix. The ester does not lower the pH of a water phase the way the acid does, because it is not in that phase at the same concentration.

Solubility is not stability: the ester in oil is protected from water but exposed to oxygen, light and heat, and the acid in water is exposed to all of them. Each form has its own failure route.

What each one is used for

The ester is used for two jobs. As an antioxidant, a small amount protects an oil or fat from oxidation, and the ester is consumed in the process. As a vitamin C source, a larger amount is formulated into a softgel, an oil blend or an oil-based capsule that carries the vitamin in the fat phase. The same material serves both, but the amounts and the declarations differ.

Ascorbic acid is used where water is the phase: beverages, stick packs, aqueous gels and tablets, and as an acidulant and antioxidant in its own right. It is also the reference material for the vitamin C figure, which is why the conversion factor exists.

The choice is a phase decision: with no oil phase, the ester has nowhere to go; in a clear water-based drink, the acid is the form that dissolves.

The conversion and the fill weight

The conversion is the ratio of molecular weights: 176.12 ÷ 414.53 = 0.4249. One gram of the ester supplies 0.425 g of ascorbic acid equivalent, and one gram of ascorbic acid needs 2.354 g of the ester. The factor is fixed by the formula and does not move with the assay.

Two worked examples. A label that declares 100 mg of vitamin C from ascorbyl palmitate needs 100 ÷ 0.4249 = 235 mg of the ester. A label that declares 500 mg of the ester delivers 212 mg of vitamin C equivalent. Neither figure is a recommendation; they are the arithmetic that keeps the label and the weigh-up in agreement.

The assay basis is a second correction. A lot at 95.4% on the dried basis with 0.8% loss on drying is 94.6% as-is; the vitamin C equivalent as-is is then 94.6 × 0.4249 = 40.2%. Apply the water correction first, then the ester factor, and do not skip either step.

The fill weight follows. A 100 mg vitamin C dose costs 235 mg of fill as the ester against 100 mg as the acid, so the same dose needs more than twice the mass in the capsule or softgel, and that difference can decide the dosage form.

What the label has to say

In the EU, the ester has two identities. As the additive, it is E 304 (i), and the ingredient list names the additive; as the vitamin source, the supplement list in Annex II of Directive 2002/46/EC names L-ascorbyl 6-palmitate, and the nutrition declaration gives vitamin C in mg and as a percentage of the 80 mg nutrient reference value. The role decides which declaration applies, and one product should not mix them.

In the US, the Supplement Facts panel declares vitamin C in mg and as a percentage of the 90 mg Daily Value, with the source in parentheses: “Vitamin C (as ascorbyl palmitate)”. The ingredient list names the ester. A food use as an antioxidant follows the additive route instead, and 21 CFR 182.3149 is the reference to read.

The declared vitamin C is 42.5% of the ester mass. A label that declares the ester mass as vitamin C overstates the vitamin by 135%; a label that declares the vitamin and leaves out the ester name hides the source. The claim is a separate review; this site makes no health claim.

When each is the right choice

Choosing between ascorbyl palmitate and ascorbic acid
SituationAscorbyl palmitateAscorbic acid
Clear aqueous drinkInsoluble; not a fitDissolves; fits
Oil or softgel fillDissolves in the oil phasePractically insoluble in oil
Dry capsuleFits, at 2.35× the mass per vitamin doseFits at a lower mass
Antioxidant in oilThe oil-soluble choicePoorly soluble in oil
Acid-sensitive matrixNo water-phase acidityAcidic in water
Low-mass doseNeeds more mass per vitamin doseThe smaller mass

Choose the ester when the phase is oil, the antioxidant has to sit in the fat, or the label is built around a softgel or oil blend. Choose the acid when the phase is water, when the dose has to be small, or when the acidity is part of the product. If the formula has both phases, the two can be used together, each with its own declaration and limit.

A switch in either direction needs a new specification, a stability study in the new matrix, a label review and a written change control. It is not a weigh-up adjustment, and it is not a unit conversion applied at the balance.

The ascorbyl palmitate page carries the catalogue specification; the grades page places this comparison in the range; the vitamin C hub carries the acid; the stability page covers the oil-phase risks; the compliance page covers the two regulatory roles; the methods library explains the assays; the quality page covers release.

Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.

Request a quotation