Nicotinamide riboside chloride or free base: choosing the grade
The catalog grade is nicotinamide riboside chloride: CAS 23111-00-4, C11H15ClN2O5, molecular weight 290.70, with chloride at 12.0–13.0%. The free base is a different material with its own CAS number and its own mass basis, and the two are not interchangeable in a formula or on a label. This page compares the forms and sets out what changes when a project switches from one to the other.
The catalog grade is the chloride salt, not the free base: the counter-ion changes the CAS number, the mass basis and the label name.
Why nicotinamide riboside comes in two forms
Nicotinamide riboside is a nucleoside: a nicotinamide ring joined to a ribose. The molecule can be supplied as the neutral free base or as the chloride salt, and the chloride is the form in this catalog. The counter-ion gives the powder a defined composition and an analytical handle, because the chloride figure can be measured and compared with theory.
The free base carries no counter-ion. Its molecular weight is 254.24 against 290.70 for the salt, so the same mass of powder does not carry the same amount of nicotinamide riboside. An order for “NR” that does not name the salt has not specified a grade.
Chloride salt against free base
| Property | Chloride salt (catalog) | Free base |
|---|---|---|
| CAS number | 23111-00-4 | 1341-23-7 |
| Formula | C11H15ClN2O5 | C11H14N2O5 |
| Molecular weight | 290.70 | 254.24 |
| Chloride | 12.0–13.0% (theory 12.19%) | None |
| Nicotinamide riboside content | About 87.5% by mass | The whole mass, before assay |
| Water | ≤2.0% by Karl Fischer | Own specification |
| Label name | Nicotinamide riboside chloride | Nicotinamide riboside |
| Catalog grade | Yes | No |
The last two rows decide most projects. The label name follows the form, and the form in this catalog is the chloride. A certificate for the free base does not describe the salt, even when the assay figures are close.
Appearance, solubility and handling
The chloride salt is a white to off-white, free-flowing powder, freely soluble in water. It is hygroscopic, so the water limit and the pack belong in the specification rather than in a storage note. A pouch left open takes up moisture, the as-is assay falls and the powder can cake.
The free base has its own solubility and handling profile. A formula built on one form cannot be switched to the other without rechecking dissolution, appearance and hold time. For a capsule or a stick pack the salt is the practical starting point; for a non-aqueous system the free base may be the only one that dissolves. The formulation decides, and that decision should come before the label artwork.
Mass arithmetic and the label
The mass ratio between the forms is 254.24 ÷ 290.70 = 0.8746. A label that declares 300 mg of nicotinamide riboside chloride delivers about 262 mg of the nicotinamide riboside moiety. A label that needs 300 mg of the moiety needs 343 mg of the salt. These are label arithmetic, not a suggested intake.
The assay basis adds a second calculation. A 98.0% result on the dried basis is not 98.0% of the powder as weighed when water is present. Convert with the water result first, then apply the salt factor if the label uses the other form. Leaving either step out is the usual error, and it is invisible on a certificate that reports a single percentage.
The same reasoning applies to the dosage form. A capsule uses the solid salt, with a fill weight sized on the salt mass. A stick pack or a drink mix takes the salt because it dissolves. A tablet needs a compression study on the salt, not on a blend built from the free base.
Specification clauses
- “Nicotinamide riboside chloride, CAS 23111-00-4, C11H15ClN2O5, molecular weight 290.70.”
- “Assay 98.0–102.0% by HPLC; state whether the result is as-is or on the dried basis.”
- “Identification by HPLC retention and UV spectrum, and by 1H NMR.”
- “Chloride 12.0–13.0%; water ≤2.0% by Karl Fischer.”
- “Heavy metals and microbiology as listed; pack, storage condition and retest period.”
- “Destination market and the labelled form confirmed before the order.”
When the other form does not fit
If the label names the free base, the chloride salt is not a drop-in: the declared ingredient, the mass and the market file would all describe a different material. If the label names the chloride, a free-base lot is outside the specification even when its assay is higher. The form belongs to the identity; it is not a factor applied at the balance.
Any switch between the forms needs written change control, a fresh specification, a new batch certificate and a label review. It is not a rename, and it is not a way to average two quotations.
The catalog ranges are on the nicotinamide riboside product page. The certificate lines are explained on the COA page; the tests that separate the salt from the free base are on the identity page; the pack and moisture risks are on the stability page. The comparison with NMN is on the NR versus NMN page, and that molecule is covered on the NMN product page; the dinucleotide is on the NAD page. The assay method is described in the HPLC method note.
In this document
Related documents
Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.
Request a quotation