02 Grade comparison

D-Mannose grades: crystalline powder, granulate and the name twin

Technical document 02 · Reviewed 2026-11-19 · D-Mannose

On this page
  1. Why one sugar has more than one physical form
  2. The forms we supply, side by side
  3. Flow, dust, dissolution and caking
  4. Capsules, sticks and the arithmetic of the label
  5. What to write into the specification
  6. When the other choice is wrong

D-Mannose leaves the factory in two physical forms: the catalog crystalline powder and a granulated powder available on request. The molecule does not change between them — CAS 3458-28-4, C6H12O6, HPLC assay 98.0–101.0%, rotation +14.0° to +16.0° on the dry basis — so the choice is about handling, not potency. Mannitol, despite the shared letters, is a separate material with CAS 69-65-8, and it is not a grade of D-mannose.

In one line

A D-mannose grade changes the powder and its handling, not the molecule; mannitol is a different material, not a coarser grade.

Why one sugar has more than one physical form

Powders of the same sugar can behave differently in a hopper. Particle size and shape set flow, dust, segregation and the rate at which the powder dissolves, and those are the variables a grade controls. The chemistry stays fixed, which is why the assay and the rotation do not move when the particle size does.

D-Mannose is hygroscopic, and that fact reaches into the grade decision. Both the crystalline and the granulated form take water from the air, so granulation does not make the powder moisture-proof. It changes the surface and the flow; the pack still has to keep the water out.

“Grade” is also a word that can disguise a substitution. A quotation that offers “mannose” without a CAS number may be offering mannitol, a sugar alcohol with a similar name, a different formula and a much higher rotation. The CAS number is the quickest way to keep the two apart.

The forms we supply, side by side

D-Mannose forms and the name twin that is not a grade
FormWhat changesAssay and rotationTypical use
Crystalline powder (catalog)Dissolves fast; fine dust; picks up waterHPLC 98.0–101.0%; +14.0° to +16.0° dry basisCapsules, tablets, stick packs, drink mixes
Granulated, on requestBetter flow; less dust; slower dissolutionIdentical assay and rotation; only the particle form changesBlending, capsule filling, dust control
Mannitol (not a grade)Sugar alcohol; C6H14O6; 182.17; CAS 69-65-8Separate assay and rotation; not D-mannoseDiluent or excipient; not a substitute

The first two rows are one molecule at different particle sizes. The third is another compound that happens to share part of the name. It belongs in an identity file and on its own purchase order, not in a grade comparison.

Flow, dust, dissolution and caking

The crystalline grade dissolves rapidly and leaves a clean, sweet solution. That suits a stick pack or a drink mix, where the powder should disappear on stirring. The same fines can dust during weighing and separate in a low-shear blend, which is the reason for the granulated option.

Granulation aggregates the fines into larger particles. The aggregate flows more freely, raises less dust and blends more evenly. What suffers is speed of dissolution: a granule wets and dissolves more slowly than a fine crystal, so a granule-based drink mix may need longer stirring or a different dispersion step. The taste does not change, because the molecule does not.

Both forms are hygroscopic. Keep them in the closed pack, open them in a dry room and close the remainder tightly. A defined particle range for the fill line is a specification item, agreed in writing before the order; it is no longer the catalog powder.

Capsules, sticks and the arithmetic of the label

D-Mannose is not a salt, so no stoichiometric factor converts one form to another. The label declares the mass of D-mannose, and the weigh-up uses the as-is assay and the moisture to deliver it. A 500 mg declaration needs enough powder to contain 500 mg of D-mannose after those two figures are applied; the certificate should state the basis so the arithmetic can be reproduced.

Capsules and tablets can take either the crystalline powder or the granulate. The granulate fills more evenly and raises less dust, but it adds a particle-size specification and slower dissolution. A stick pack or drink mix usually uses the crystalline powder for fast dissolution; moisture protection comes from the foil seal, not the particle size.

When mannitol appears in a formula it is an excipient or a separate ingredient, and it must be declared as mannitol. A mannitol diluent cannot be declared as D-mannose, and a D-mannose declaration cannot be carried by a powder whose active mass is mannitol. The level-four comparison sets out the structural and label differences.

What to write into the specification

  • “D-Mannose, CAS 3458-28-4, C6H12O6, molecular weight 180.16.”
  • “Assay 98.0–101.0% by HPLC; state the detector and the assay basis.”
  • “Specific rotation +14.0° to +16.0° on the dry basis, with solvent, concentration and temperature.”
  • “Loss on drying ≤0.5%; white crystalline powder; freely soluble in water.”
  • “Particle size for the granulated grade, agreed in writing; the crystalline grade carries the catalog profile.”
  • “Source, manufacturing route and pack confirmed before the order.”

We supply the crystalline powder and the granulated form on request. The granulated form is a separate physical specification, not a packing choice, and a substitution needs a written change control.

When the other choice is wrong

For a fast-dissolving stick pack, granulation can be the wrong choice: the granule wets more slowly and may leave a visible dispersion where the crystalline powder would clear. For a low-dust capsule fill or a blend that segregates, the crystalline powder can be the wrong choice for the opposite reason. The dosage form decides, not a preference for “finer” or “coarser”.

Mannitol is the right material when the formula needs a non-reducing, low-hygroscopicity diluent for a moisture-sensitive tablet, or a cooling taste in a chewable. It is the wrong material when the label names D-mannose, because the label and the balance would name different materials. A switch either way needs a new specification, label and route check.

The D-mannose product page publishes the catalog specification; the COA page shows how the grade is reported; the stability page covers caking and moisture; the identity page sets out the tests that distinguish D-mannose from mannitol. D-Ribose is another monosaccharide with its own specification, and it is not a D-mannose grade either.

Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.

Request a quotation