02.1 Pea vs soy

Pea vs soy protein isolate: protein, allergens and the label

Technical document 02.1 · Reviewed 2026-11-19 · Pea Protein Isolate

On this page
  1. Protein density and the rest of the powder
  2. The allergen difference
  3. In the glass and on the line
  4. How the label names them
  5. What changes with the source
  6. Which source fits

Pea and soy protein isolate are both legume proteins separated to a high-protein powder, and they are not interchangeable. Soy carries about ten points more protein on a dry basis and is a regulated major allergen in the EU, the US and the UK; pea is not on those lists. Those two differences set the dose, the label and the document pack before flavour or supply are discussed.

In one line

Pea and soy isolate differ first in protein density and in allergen status, and only then in the flavour and the label wording that follow from them.

Protein density and the rest of the powder

Soy isolate is specified at ≥90.0% protein on a dry basis, pea at ≥80.0%, both by Kjeldahl with N × 6.25. At their moisture limits the as-is figures are 83.7% for soy and 73.6% for pea. To deliver 20 g, soy needs 23.9 g of powder and pea 27.2 g — 3.3 g more per serving. The difference is small in a 30 g stick and larger in a bar where every gram of powder has to be carried by the matrix.

Pea and soy protein isolate · catalogue limits side by side
PointPea protein isolateSoy protein isolate
Protein, dry basis≥80.0% (N × 6.25)≥90.0% (N × 6.25)
Protein, as-is at the moisture limit73.6% at 8.0%83.7% at 7.0%
Powder for 20 g protein27.2 g23.9 g
Moisture≤8.0%≤7.0%
Ash≤5.0%≤5.0%
Fat≤2.0%≤1.0%
Major allergenNo; pea is a legume but not on the listsYes; soy is on all three lists
IsoflavonesNot a specification linePresent; a line where the customer asks

The rest of the proximate profile runs the same way. Both are capped at 5.0% ash. Soy is capped at 1.0% fat and pea at 2.0%. Soy isolate carries isoflavones, which belong in the specification if the label or the customer asks about them; pea isolate does not carry them at a level that needs a line. Both are 80 mesh powders and both disperse to an opaque suspension, so the physical difference is smaller than the compositional one.

The allergen difference

Soy is one of the 14 allergens in the EU's Regulation (EU) No 1169/2011 Annex II, one of the major food allergens under the US FALCPA, and one of the 14 enforced by the UK's Food Information Regulations 2014. A product that contains soy protein isolate must emphasise soy in the ingredient list and, in the US, carry a “Contains: soy” statement or a parenthetical.

Pea is not on any of those lists. It is still a legume, and legume allergy is real: a pea-sensitive consumer can react to pea protein, and cross-reactivity with other legumes such as peanut and lupin has been reported. The absence of a mandatory declaration is not a statement that the material cannot provoke a reaction. It means the label does not have to highlight pea, while the specification should still name it and the factory should still control cross-contact with the legumes and cereals it also runs.

For a product sold as soy-free, the control is the shared line, not the ingredient name. A pea isolate packed on a line that also handles soy needs a cleaning validation and, where the risk remains, an advisory statement. The Annex II glossary entry lists the 14 allergens, and the compliance page covers the declaration.

In the glass and on the line

Both isolates are spray-dried powders that disperse in water to an opaque, slightly gritty suspension; neither makes a clear drink. Soy isolate is usually the more neutral of the two in taste, with a beany note that most flavours mask; pea isolate carries a greener, earthier note that is harder to hide in a plain shake and easier in a bar or a cocoa system. That is a formulation observation, not a grade ranking.

Heat and pH behave similarly. Both proteins are least soluble near pH 4.5–5.0, both can thicken or gel when a concentrated solution is heated, and both need a heat process designed around the protein. Soy isolate brings isoflavones and a different amino acid balance; pea isolate brings more lysine and less methionine per 100 g of protein. Those are specification facts for a nutrition panel, not claims about what the protein does.

How the label names them

In the EU the ingredient list names the isolate and emphasises the soy: “soy protein isolate”, with “soy” in bold or capitals. Pea appears as “pea protein isolate” with no emphasis. In the US the ingredient statement names the material and the FALCPA declaration follows for soy; pea needs no “Contains” line.

The protein figure on the panel is as-is. A product that declares 20 g of protein from 27.2 g of pea isolate is consistent; one that declares 20 g from 23.9 g of soy isolate is consistent; one that uses the dry-basis figure for either is not. The product name should match the ingredient list: a “pea protein” product made with concentrate is a different label from one made with isolate.

What changes with the source

Both are ordinary food ingredients in the three markets and neither needs pre-market approval. Food supplements fall under Directive 2002/46/EC in the EU, the Food Supplements (England) Regulations 2003 and the devolved equivalents in the UK, and the DSHEA framework with 21 CFR 111 in the US. The contaminant limits apply to the finished product as sold, and they do not change with the protein source. Protein claims do not change either: the EU thresholds are 12% and 20% of energy, the US thresholds 10–19% and at least 20% of the Daily Value.

What changes is the allergen file and the specification line for isoflavones. A soy-containing supplement needs the soy declaration on every pack; a pea-containing one needs the pea statement and the cross-contact record. Neither source carries a disease claim, and neither is a medicine.

Which source fits

Choose soy isolate when the formula needs the highest protein per gram, when a neutral flavour matters more than the allergen status, when the label can carry the soy declaration, and when the supply base for soy isolate fits the market. Choose pea isolate when the product must avoid the soy allergen declaration, when 27 g of powder per 20 g of protein fits the serving, when the earthy note suits the matrix, or when the customer's specification names pea.

Neither choice is a statement about health. It is a statement about protein density, allergen labelling, flavour and supply, and it belongs in the specification as a source, a grade and a protein basis. The pea product page and the soy product page carry the catalogue limits; the pea grade comparison covers isolate against concentrate, and the pea compliance page covers the declaration.

Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.

Request a quotation