06 Identity & adulteration

How we prove a lot is colostrum basic protein

Technical document 06 · Reviewed 2026-11-19 · Colostrum Basic Protein

On this page
  1. The five identity layers
  2. The ratios that carry the identity
  3. X-ray diffraction: what it can and cannot prove
  4. How substitutions show up
  5. Identity lines for the specification
  6. Six questions to put in writing

A powder is colostrum basic protein when the measurements describe a basic-protein fraction of bovine colostrum, not merely a powder with 80% protein. Four lines have to agree: the declared name and species, protein by Kjeldahl with the dairy factor, IgG by a specific immunoassay, and the ash and moisture that close the mass balance. A lactoferrin figure by HPLC is the marker that shows a fraction rather than a blend.

In one line

Identity here is a profile, not a single number: total protein, a specific IgG assay, the ash left by the salt step and the basic-protein markers have to describe the same powder.

The five identity layers

A name on a certificate is a claim, not a test. Each layer below asks something different and needs its own evidence; an answer at the first layer alone describes the paperwork, not the powder.

Five layers of colostrum basic protein identity
LayerWhat it asksMethodEvidence
DocumentAre the material, the fraction and the species named?Name, species, fraction, originPaperwork only
NitrogenIs the protein figure real?Kjeldahl, N × 6.38; amino-acid analysisProtein quantity, not the fraction
IgGIs the antibody present?Radial immunodiffusionOne protein, not the whole fraction
Fraction markersIs it the basic fraction?Lactoferrin and lactoperoxidase by HPLCThe fractionation step
Mass balanceIs it diluted or salted?Ash, moisture, proteinConsistency of the numbers

The ratios that carry the identity

Two ratios are worth calculating on every certificate. The first is IgG per 100 g of protein: at the specification minimums it is 12.5 g for the fraction and 28.6 g for whole colostrum. The second is ash against protein: the fraction caps ash at 5.0%, so an ash figure close to the cap with a protein at the floor describes a lot carrying salt from the elution rather than a lot that is mostly protein.

The ratio is not a purity grade. A powder with a higher IgG share is not automatically better; it is closer to the whole powder in composition. The question is whether the ratio matches the ingredient name and the specification. A powder sold as the basic-protein fraction with a whole-colostrum ratio and no lactoferrin marker is a blend or a different fraction until the supplier shows otherwise.

The nitrogen factor belongs here too. Protein equals nitrogen multiplied by 6.38 for milk proteins. A certificate that multiplies by 6.25 reports a lower figure for the same powder, and a certificate that does not state the factor has not defined its protein. Ask for the nitrogen figure as well as the protein percentage: the arithmetic should close.

X-ray diffraction: what it can and cannot prove

X-ray diffraction is the wrong primary test for this powder. A spray-dried protein is amorphous, and its diffractogram is a broad halo rather than a set of sharp reflections; the pattern cannot distinguish the basic-protein fraction from whole colostrum or from a whey blend. What XRD can do is show a crystalline diluent or a mineral salt — crystalline lactose, sodium chloride from the elution or a mineral carrier — when the level is above the detection limit.

Read “XRD conforms” as a question, not an answer: request the pattern and the reference it was compared with. An unreferenced halo says something about the instrument, not about the fraction. The solid-state question that matters here is whether a crystalline diluent is present, and that belongs to the adulteration review rather than the release panel.

How substitutions show up

Common substitutions and the signals to test
SubstitutionWhat it doesSignalTest
Whole colostrumProtein falls, IgG share risesIgG per 100 g protein above the fraction's range; fat and lactose presentIgG-to-protein ratio, fat and lactose, lactoferrin HPLC
Whey or milk proteinProtein stays high, IgG fallsNo IgG response at the 10% claim; lactoferrin missingRadial immunodiffusion, lactoferrin HPLC, amino-acid profile
Lactoferrin spikeProtein and lactoferrin rise, IgG does notLactoferrin high, IgG low for a “fraction” claimLactoferrin HPLC, radial immunodiffusion
Non-protein nitrogenKjeldahl protein rises without proteinIgG and amino-acid protein do not match the nitrogenAmino-acid analysis, true-protein calculation
Carbohydrate carrierProtein and IgG are dilutedProtein below the floor; ash or moisture shiftsMass balance, XRD for crystalline lactose

The non-protein nitrogen route is the safety one: a nitrogen-rich additive inflates the Kjeldahl figure and the powder can pass the protein gate without containing the protein it claims. The other routes are substitutions rather than contaminants, and each one leaves a ratio that does not fit the declared fraction. Colour is a weak signal on its own, because the fraction varies from off-white to light tan from lot to lot.

Identity lines for the specification

  • “Colostrum basic protein (bovine), the basic-protein fraction of colostrum, not whole colostrum.”
  • “Protein ≥80.0% as-is by Kjeldahl, N × 6.38; the factor and the basis are stated.”
  • “IgG ≥10.0% by radial immunodiffusion; the standard and the dilution are reported.”
  • “Ash ≤5.0%; moisture ≤7.0%; particle size ≥95% through 80 mesh.”
  • “Lactoferrin by HPLC reported where the fraction identity is to be demonstrated.”
  • “Milk allergen statement; species and origin declared; no added carrier and no added protein.”
  • “No non-protein nitrogen source; amino-acid analysis on request.”

Six questions to put in writing

  1. Which fraction is this lot, and which proteins does the certificate identify?
  2. What is the nitrogen factor, and is the protein figure as-is or dry basis?
  3. Which IgG method was used, with which standard and dilution?
  4. What are the ash, moisture and lactoferrin figures for this lot?
  5. Can you provide the chromatogram and the amino-acid analysis if the lot is disputed?
  6. Would you re-test the retained sample jointly if a result is disputed?

Six direct answers make an identity file; a protein percentage on its own does not. For the full picture, the product page holds the catalog spec, the COA page shows where each figure appears on the certificate, the grade page sets out the neighbouring grades, the level-four comparison puts the fraction against the whole powder, and the compliance page covers the milk allergen and the market file.

Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.

Request a quotation