Choosing a colostrum basic protein grade
Colostrum basic protein is the 80% protein, 10% IgG fraction of bovine colostrum. The same raw material also yields whole colostrum powder at 70% protein and 20% IgG, and a single basic protein such as lactoferrin at 95% protein. The grade decides how much protein and how much IgG arrive in each gram of powder, what the ash limit is, how the powder flows, and which ingredient name goes on the label.
The grade decides whether the formula is buying protein density or IgG density: the basic-protein fraction lifts protein, while whole colostrum keeps more IgG in every gram.
Why the fraction is a grade, not a strength
“Basic protein” names a fractionation, not a strength. At the pH of the loading buffer, the basic proteins in colostrum — lactoferrin, lactoperoxidase and part of the IgG — carry a net positive charge and bind to a cation-exchange resin, while the bulk of the whey proteins and the lactose pass through. The bound fraction is eluted by raising the salt concentration, then concentrated and dried. The result is a powder with more protein and less fat and lactose than the starting material, and with a different IgG-to-protein ratio.
Four variables define a grade: the raw material (colostrum or mature milk), the fractionation target, the release numbers for protein, IgG and ash, and the physical form. A certificate that matches on protein but not on the fraction describes a different product, and the label has to follow the fraction rather than the protein number.
The grades side by side
| Grade | Protein | IgG | Ash | What it is |
|---|---|---|---|---|
| Basic protein powder, 80 mesh (catalog) | ≥80.0% | ≥10.0% | ≤5.0% | The basic-protein fraction; the grade on this page |
| Basic protein, granulated | ≥80.0% | ≥10.0% | ≤5.0% | Same chemistry, coarser particles and less dust |
| Whole colostrum powder | ≥70.0% | ≥20.0% | — | First milking, separated and dried; fat ≤5.0%, lactose ≤5.0% |
| Lactoferrin | ≥95.0% | — | ≤1.5% | One basic protein, not the fraction; iron saturation is its grade |
The last two rows are not substitutes for the first. Whole colostrum carries more IgG per gram but also the fat and lactose that the fraction removes; lactoferrin is a single protein with its own specification and no IgG figure. Two quotations that both say “colostrum protein” can be describing any of these.
Powder behaviour
The catalog grade is an off-white to light tan powder at ≥95% through 80 mesh, which puts most particles below about 177 µm. Colour moves with the season and the drying step; a tan shift within the range is not an identity failure, but a dark or uneven powder is worth a batch record. The powder is hygroscopic and picks up moisture from the air, so the pouch has to be closed between weighings.
It disperses in water to a slightly turbid solution, with some foam under shear. That is normal for a protein fraction and it matters in a stick pack or a drink mix: the powder wets slowly and can clump if it is dumped into water, so the formulator usually needs a dispersion step or a granulated grade. Granulation changes the flow and the dust, not the protein or IgG figures.
Flow also decides the capsule and tablet line. A fine 80 mesh powder can bridge in a hopper and generate static; a granulated grade runs more evenly but dissolves more slowly. The particle size is a line item on the specification because it changes the process, not because it changes the chemistry.
Fill weight and dosage form
The arithmetic is straightforward and it is where grade mistakes show up. A 500 mg capsule of the fraction carries about 400 mg of protein and 50 mg of IgG at the specification minimums; the same fill of whole colostrum carries about 350 mg of protein and 100 mg of IgG. These are label calculations, not a dose. A formula that declares a specific IgG quantity has to size the fill weight from the grade it actually buys.
The dosage form narrows the choice. A capsule or tablet takes the fraction when the fill weight is tight and the protein figure is the claim, and it takes whole colostrum when the IgG figure is the claim. A stick pack or a drink mix suits the fraction when fat and lactose would spoil the mouthfeel, and whole colostrum when a richer, milkier taste is acceptable. A tablet with a high fraction load may need a binder and a lubricant, and the compression trial belongs before the label is written.
A beverage adds heat and pH to the decision. The fraction disperses more cleanly than the whole powder, but neither is a heat-stable ingredient; the process and the hold time have to be validated in the matrix, as the stability page sets out.
Specification lines
- “Colostrum basic protein (bovine), basic-protein fraction of colostrum, not whole colostrum.”
- “Protein ≥80.0% as-is by Kjeldahl, N × 6.38; the basis and the factor are stated on the certificate.”
- “IgG ≥10.0% by radial immunodiffusion; the standard and the dilution are reported.”
- “Ash ≤5.0%; moisture ≤7.0%; particle size ≥95% through 80 mesh.”
- “Milk allergen statement; species, origin and heat treatment declared.”
- “Granulated form on request; granulation does not change the protein or IgG limits.”
- “If fat or lactose must be declared, request the figures: the catalog sets neither.”
When another grade is the better choice
Choose whole colostrum when the IgG figure per gram is the target and the fat and lactose can be declared and tolerated; it is the simpler label when the ingredient is already “colostrum”. Choose lactoferrin when the formula needs one protein at high purity and the iron saturation is part of the story. Choose a granulated basic protein when the line cannot handle a fine, hygroscopic powder and the dissolution step can take a coarser particle.
The fraction is the wrong choice when the label promises an IgG quantity that a 10.0% minimum cannot reach in the fill weight, or when the specification has to carry fat and lactose lines that this catalog does not set. In both cases the answer is a different grade or a larger fill, not an overage invented at the weigh-up.
The catalog range is on the product page; the whole-powder alternative on the colostrum page; the single-protein alternative on the lactoferrin page; the fraction-versus-powder question on the level-four comparison; and the assays in the methods library.
In this document
Related documents
Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.
Request a quotation