Calcium citrate or calcium carbonate: choosing a calcium salt
Calcium citrate tetrahydrate carries 21.0–22.0% elemental calcium; calcium carbonate carries about 40%. A 500 mg calcium claim therefore needs roughly 2.3 g of the citrate or 1.25 g of the carbonate, which changes the tablet or capsule count, the taste and the acid response before it changes anything else. Both are permitted calcium sources for food supplements; the choice is a dosage-form and label decision, not a purity tier.
Citrate and carbonate are both calcium salts, but each gram carries a different amount of calcium and behaves differently in acid.
Two salts, not two grades of one
These are different materials, not two purities of the same powder. Calcium citrate tetrahydrate is the calcium salt of citric acid, C12H10Ca3O14·4H2O. Calcium carbonate is CaCO3, with one calcium per formula unit instead of three. The carbonate is denser and carries nearly twice the calcium per gram; the citrate carries the citrate anion and four molecules of water.
Both are permitted food supplement sources and are sold as powders for capsules, tablets and sticks. The grade question for the citrate is the hydrate — tetrahydrate or anhydrous — and the particle size; for the carbonate it is the crystal form and the density. “Calcium citrate 21%” and “calcium carbonate 40%” are not competing purities. They are different salts with different arithmetic.
The comparison that matters
| Salt | Elemental Ca | Salt for 500 mg Ca | Acid response | Taste | Fits |
|---|---|---|---|---|---|
| Calcium citrate tetrahydrate | 21.0–22.0% | 2.27–2.38 g | Dissolves in dilute acid, no gas | Saline-sour | Capsules, tablets, sticks |
| Calcium citrate, anhydrous | About 24.1% | About 2.07 g | Dissolves in dilute acid, no gas | Saline-sour | Where mass is tight |
| Calcium carbonate | About 40.0% | About 1.25 g | Effervesces in acid | Chalky | Compact tablets, effervescent |
The middle column converts a label claim into a weight of powder, and the weight decides how many units a serving needs. A unit already at its fill limit cannot take the citrate's larger mass without changing the serving size.
Acid, taste and flow
Acid is where the two salts part company most visibly. Calcium carbonate reacts with hydrochloric acid to give calcium chloride, carbon dioxide and water; in a tablet or a stick the gas is the fizz, and in a sealed container it is pressure. Calcium citrate dissolves in dilute acid without gas, because the carbonate is not there. The practical difference is acid-neutralising capacity: carbonate consumes acid as it dissolves, while citrate contributes citrate and buffers.
Taste follows the same split. Carbonate is chalky and drying; citrate is saline and sour, and the sour note grows with dose. In a capsule neither taste is noticeable; in a chew or a stick the difference decides whether the format works. A flavour system that masks chalk may not mask the citrate note.
Flow and density differ too. The catalog citrate is 80 mesh with a bulk density of 0.60–0.95 g/mL, a window wide enough to cover a light, dusty powder and a denser one. Carbonate is generally denser and flows well, which is why it compresses into small tablets. The citrate's lower calcium content per gram means more powder per unit, so hopper volume and tablet thickness move with the salt.
What the dosage form does with the difference
Start with 500 mg of calcium, a common single-serving figure. At 21.5% calcium the citrate needs about 2.33 g; at 40.0% the carbonate needs 1.25 g. A size 00 capsule holds roughly 600–700 mg of a mineral powder, so the citrate claim runs to three or four capsules while the carbonate claim runs to two. A 1,000 mg tablet of citrate carries about 215 mg calcium; the same weight of carbonate carries about 400 mg.
The format then constrains the choice. Effervescent tablets need the carbonate, because the fizz is the carbonate-acid reaction; citrate cannot supply it. A clear or lightly cloudy drink can use citrate if the pH is managed, but its solubility is low and the acidulant has to be part of the trial. A gummy with an acidulant will react with carbonate during cooking, so the gas has to be managed or the salt changed. A stick can carry 2.3 g of citrate, which makes it the natural home for a high-dose citrate claim.
None of this is a statement about what the mineral does in the body. It is a statement about mass, gas and taste in the unit the consumer opens.
Naming the source on the label
EU rules require the ingredient list to name the source as listed in Annex II to Directive 2002/46/EC, where “calcium citrate” and “calcium carbonate” are separate entries. The nutrition declaration gives calcium in milligrams and as a percentage of the 800 mg reference intake. In the United States the Supplement Facts panel gives elemental calcium against a 1,300 mg Daily Value, and the ingredient list names the salt. The United Kingdom uses the same 800 mg reference intake in its retained nutrition labelling.
Switching salts at a fixed powder weight moves the calcium figure by nearly a factor of two. Switching at a fixed calcium claim moves the powder weight instead. Either way the label, the batch record and the specification change together; a new salt is a new label, not a substitution.
What changes when you switch
Six things move with the salt: the mass per serving; the number of capsules or tablets; the tablet size or stick weight; the taste; the acid response and any gas; and the source name on the label. A seventh, less obvious change is the certificate. Citrate carries a loss on drying near 12% from its water of crystallisation, carbonate has none, so a specification copied across will fail at the first lot.
Run a small trial before the label is printed: compress the new mass, taste the new stick, and check the pH and gas in the matrix. A salt swap that looks neutral on paper is a new formulation in the press. The citrate versus carbonate page takes the arithmetic and the acid reaction further.
Writing the specification
Write the citrate specification with the hydrate in the name: “Calcium citrate tetrahydrate, 21.0–22.0% Ca by complexometric EDTA; assay not less than 97.5% on the dried basis; loss on drying not more than 13.0%; citrate identification by reaction and IR; not less than 95% through 80 mesh; bulk density 0.60–0.95 g/mL; Pb ≤3, As ≤2, Cd ≤1, Hg ≤0.1 mg/kg.” Add “no added calcium carbonate, calcium oxide or citric acid” when the citrate identity is the point of the purchase.
For the carbonate, write its own calcium window and its own loss on drying, and do not borrow the citrate lines. A specification is a description of one material; a line that fits both is a line that specifies neither.
The catalog figures are on the product hub. The certificate lines are explained on the COA page; the market rules that follow the source name are on the compliance page; the hydrate arithmetic is defined in the elemental assay entry.
In this document
Related documents
Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.
Request a quotation