02 Fruit oil vs seed oil

Fruit oil or seed oil: choosing a sea buckthorn grade

Technical document 02 · Reviewed 2026-11-19 · Sea Buckthorn Oil

On this page
  1. Why one berry gives two oils
  2. The two oils side by side
  3. Colour, clarity and handling
  4. Working out the label figure
  5. Specification lines to agree
  6. When the fruit oil is the wrong choice

Sea buckthorn is sold as fruit oil, extracted from the pulp and skin, and as seed oil, from the seeds; the catalog entry here is the fruit oil, with palmitoleic acid at 25.0–35.0%. The two come from one berry and are not interchangeable: the fruit oil is orange-red and palmitoleic-rich, the seed oil is yellow and dominated by linoleic and alpha-linolenic acid. The third choice is the format — neat oil in an amber bottle or a drum, or a powder on a carrier.

In one line

Fruit oil and seed oil are two products from one berry: the part of the plant decides the fatty-acid profile, the colour and the ingredient name before any grade decision.

Why one berry gives two oils

The berry is processed for juice, and the oil comes out of the fractions that remain. The pulp and skin carry an orange-red oil that is rich in palmitoleic acid; the seeds carry a yellow oil in which linoleic and alpha-linolenic acid dominate. The seed is a by-product of the juice line, which is one reason the two oils have separate supply chains and separate specifications.

Extraction adds a second variable. Cold pressing keeps the carotenoids and the colour but leaves more free fatty acid and sediment; supercritical carbon dioxide gives a darker, more concentrated extract; solvent extraction gives a higher yield and brings a residual-solvent question. A refined oil is paler, lower in free fatty acid and lower in colour, and it can no longer be checked by eye.

The name on the purchase order is the first trap. “Sea buckthorn oil” does not say which fraction, and some suppliers sell a whole-berry oil that sits between the two. The fatty-acid profile is the most direct statement of what was extracted.

The two oils side by side

Sea buckthorn fruit oil and seed oil
PropertyFruit oilSeed oil
Raw materialPulp and skin after juice extractionSeeds separated from the pomace
ColourOrange-red to dark redYellow to orange
Palmitoleic acid (C16:1)25.0–35.0% (catalog)A minor fraction, well below the fruit-oil range
Linoleic acid (C18:2)30.0–40.0% (catalog)A major fraction
Alpha-linolenic acid (C18:3 n-3)LowA major fraction
Oleic acid (C18:1)20.0–30.0% (catalog)Present; not the marker
Usual formatSoftgel fill, oil blendSoftgel fill, cosmetic and food oil
Label nameSea buckthorn fruit oilSea buckthorn seed oil

The table is the argument for naming the part of the plant in the specification. A buyer who orders on palmitoleic acid alone will receive a fruit oil; a buyer who orders on alpha-linolenic acid will receive a seed oil. A blend can be made to hit a palmitoleic figure, but it will carry seed-oil alpha-linolenic acid at the same time, and the full profile shows it.

Colour, clarity and handling

The fruit oil is orange-red to dark red because of its carotenoids, and the catalog appearance is clear to slightly hazy. Haze is not automatically a defect: an unrefined oil can hold fine sediment and wax, and a cold store can crystallise part of the glycerides. Warming the container gently and mixing restores a uniform oil, but repeated warming cycles use up shelf life, so bring the whole pack to working temperature once rather than warming a scoop at a time.

Both oils are insoluble in water and soluble in fats and organic solvents. Density is below that of water, near 0.9 g/mL, so a 1 kg bottle holds roughly 1.1 L and a softgel fill quoted in milligrams is not a volume. The oils are light-sensitive, and the fruit oil's colour is the visible part of that sensitivity: carotenoids are consumed as the oil oxidises, so a fading colour is one of the earliest signs that a pack has been open too long or stored too warm.

Working out the label figure

The label figure for an oil is a mass of oil, not a mass of any single fatty acid. If a softgel carries 500 mg of fruit oil and the lot profile is 30% palmitoleic acid, the capsule carries about 150 mg of palmitoleic acid; with a 25% lot it carries 125 mg. The calculation uses the measured lot figure, not the middle of the catalog range, and it is arithmetic rather than a recommended intake.

Format changes the arithmetic. A powder on a carrier is declared by oil load, so 1,000 mg of a 40% powder carries 400 mg of oil; the same oil load in neat form weighs 400 mg. A blend with a neutral oil dilutes every marker in proportion: a 50:50 blend of fruit oil and sunflower oil lands near 15% palmitoleic acid, and the label has to name both oils. None of these conversions repairs a specification that did not state the plant part.

Specification lines to agree

  • “Sea buckthorn (Hippophae rhamnoides L.) fruit oil” — with the botanical name and the part of the plant.
  • “Palmitoleic acid 25.0–35.0%, oleic 20.0–30.0%, linoleic 30.0–40.0% by GC; all major acids reported.”
  • “Free fatty acid ≤1.00% as oleic acid; peroxide value ≤5.0 meq O₂/kg; moisture ≤0.1%.”
  • “Appearance orange-red to dark red, clear to slightly hazy; no added colour.”
  • “Refining status stated; any added tocopherol declared with its level.”
  • “Pack 1 kg amber bottle or 25 kg HDPE drum; nitrogen flush and headspace agreed in writing.”

We supply the fruit oil. The seed oil is a separate purchase with its own profile, and a whole-berry oil is a third specification again; neither should be swapped in without written change control and a fresh label review.

When the fruit oil is the wrong choice

The fruit oil is the wrong choice when the label is built on alpha-linolenic acid, when a pale oil is needed in a clear capsule, or when the specification was written around seed oil. It is also the wrong choice when the colour is treated as a defect rather than a property, because the carotenoids that produce it are part of what the buyer is paying for and refining them out changes the ingredient. If the label is built on GLA rather than on a sea buckthorn acid, the starting point is the evening primrose oil powder, which is specified on GLA and oil load.

The catalog specification is on the sea buckthorn oil product page. The comparison with evening primrose is on the fruit oil versus evening primrose page, the analytical evidence on the identity page, the storage behaviour on the stability page, the chromatographic method in the methods section, and the release workflow on the quality page.

Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.

Request a quotation