Cold-pressed, refined or winterised: choosing a hemp seed oil grade
Hemp seed oil is bought by process grade, not by a single assay number. The catalog material is cold-pressed, unrefined oil with the seed's chlorophyll, colour and flavour intact; a refined grade is the usual alternative when a pale, mild oil matters, and a winterised grade sits between them for clarity. The grade decides the colour, the oxidation behaviour at release and the label wording, while the fatty-acid windows stay the same.
The grade is the press and finishing route: cold-pressed oil keeps the chlorophyll and the flavour, while refining and winterisation trade them for a paler, milder, clearer oil.
Why one seed gives several grades
Cold pressing crushes the seed at a moderate temperature without solvent, then filters the oil. The oil keeps its greenish colour from chlorophyll, its tocopherols and sterols, and its nutty, grassy flavour. The same route leaves a higher free fatty acid figure and a shorter tolerance for warmth than a refined oil, because nothing has been removed to stabilise it.
Refining is a sequence. Neutralisation lowers free fatty acid, bleaching lowers colour and trace metals, and deodorisation strips volatile odour compounds under vacuum and heat. The result is a pale, mild oil with a low peroxide value at release. The same steps remove part of the tocopherol fraction, and a deodorisation run pushed too hard can create trans isomers.
Winterisation is a separate finishing step. The oil is chilled so that waxes crystallise, then filtered; the clear oil that remains stays bright in a cold room. It is not refining, and it does not remove chlorophyll or the flavour. Organic is a certification and segregation question, not a process grade, and the powder on a carrier is a different delivery format with its own specification.
The grades side by side
| Dimension | Cold-pressed, unrefined | Refined | Winterised |
|---|---|---|---|
| Process | Pressed and filtered; no solvent, no deodorisation | Neutralised, bleached and deodorised | Cold-pressed oil chilled and filtered to remove waxes |
| Colour and clarity | Greenish-yellow to golden; clear to slightly hazy | Pale yellow; bright | As the base oil, with less wax haze at low temperature |
| Flavour and odour | Nutty and grassy; the seed note is present | Mild and close to neutral | Close to the base oil; the wax note is reduced |
| Free fatty acid and peroxide | Depend on the seed and the press; catalog limits apply | Usually lower at release | Unchanged by the chill step |
| Minor components | Chlorophyll, tocopherols and sterols retained | Partly reduced by bleaching and deodorisation | Largely retained; some wax fraction removed |
| Label fit | Supports a cold-pressed or unrefined description | Fits a neutral-taste or pale-oil brief | Fits a clarity brief; not a refined claim |
Two quotations can differ by more than the ALA figure. A refined oil and a cold-pressed oil from the same seed lot can land in the same ALA window and behave differently in a softgel, an emulsion and a taste panel.
Colour, chlorophyll and handling
The catalog appearance is a clear to slightly hazy oil, greenish-yellow to golden. The green tone comes from chlorophyll carried through the press, and its intensity depends on the seed, the press temperature and the filtration. Chlorophyll is also a photosensitiser: it absorbs light and passes the energy to oxygen, so a green oil in clear glass ages faster than the same oil in amber glass.
Haze in an unrefined oil is normal. Fine seed particles and waxes pass a coarse filter and settle slowly, and a cold store makes the wax fraction crystallise into a cloud that clears on warming. That cloud is a presentation issue, not a specification failure; winterisation is the grade that reduces it. Warm gently and mix before sampling rather than filtering cold.
Handling belongs to the grade. Oxygen, light and warmth are the three variables, and a nitrogen blanket, an amber bottle and a cool store are part of keeping a cold-pressed oil at its release condition.
Dose arithmetic and the dosage form
The label arithmetic starts from the release profile. At 15.0% ALA, a gram of oil carries 150 mg; at 25.0% it carries 250 mg, so a 500 mg softgel carries 75–125 mg and a 1,000 mg fill carries 150–250 mg. Linoleic acid at 50.0–60.0% of total fatty acids is about 475–570 mg per gram of oil, and GLA at roughly 1–4% adds 10–40 mg. Those are the numbers that decide the fill weight and the servings per capsule.
Declare from the lot result, not from the top of the range. If the certificate reports 18.4% ALA, the declared amount per capsule is based on 18.4%, with any overage decided by the brand's stability data. Declaring the ceiling against a lot near the floor is an error that a comparison of certificate and panel exposes.
The dosage form follows the grade. A softgel fill or an oil blend takes the cold-pressed oil and accepts its colour and flavour; a clear beverage or a taste-sensitive chew needs the refined grade. A dry format needs the powder on a carrier, which is a separate product with its own oil load and ALA basis rather than a grade of the oil. The comparison with flaxseed oil is on the hemp versus flaxseed page.
What to write into the specification
- “Cold-pressed hemp seed oil, Cannabis sativa L. seed, CAS 89958-21-4.”
- “Linoleic acid 50.0–60.0%, ALA 15.0–25.0% and oleic acid 10.0–20.0% by GC-FAME.”
- “GLA reported as part of the profile, with the method that separates it from ALA.”
- “Free fatty acid ≤0.50% as oleic; peroxide value ≤5.0 meq O₂/kg; moisture ≤0.1%.”
- “p-Anisidine value at the limit agreed at order, if the buyer's specification includes it.”
- “Pack: 1 kg amber bottle or 25 kg HDPE drum, sealed and nitrogen-flushed where agreed.”
- “Lot number, production date and retest date on the pack and the certificate.”
Write the grade and the fatty-acid windows as separate clauses. A specification that names only “hemp seed oil” leaves the supplier free to ship a refined oil to a cold-pressed brief, and one that fixes only the ALA figure leaves the oxidation question open. We supply the cold-pressed grade; refined or winterised oil is a separate purchase with its own specification.
When another grade is the right purchase
Cold-pressed is the wrong choice when the oil has to be pale, mild and stable on a warm shelf, or when the formula cannot carry the green note. Refined is the wrong choice when the label leans on a cold-pressed story, or when the tocopherol fraction is part of the nutritional case. Winterised is the wrong choice when the problem is oxidation rather than wax haze; clarity is not stability.
The powder on a carrier is not a grade at all. It is a different specification with a declared oil load, and a switch to it changes the ingredient list and the mass per serving. The switch is a new purchase, not a packing change.
The catalog specification is on the hemp seed oil product page. The release tests are on the COA page, the oxidation behaviour is on the stability page, the analytical methods are indexed under methods, and the release workflow is described on the quality page.
In this document
Related documents
Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.
Request a quotation