02 Grade comparison

Cold-pressed, refined or concentrated: black currant seed oil grades

Technical document 02 · Reviewed 2026-11-20 · Black Currant Seed Oil

On this page
  1. Three process decisions, not three brands
  2. The grades side by side
  3. Clarity, sediment and the fill line
  4. Two fatty acids, two label numbers
  5. What to put in the specification
  6. When a grade switch is the wrong move

Black currant seed oil reaches the market in three process states: cold-pressed and unrefined, refined after pressing, and standardized to a higher GLA figure. The catalog item is the first, at GLA 15.0–20.0%, ALA 12.0–15.0% and linoleic acid 40.0–50.0%. The state you buy changes the colour, the free fatty acid, the minor components and the label arithmetic, so it belongs in the purchase specification rather than in a footnote.

In one line

The grade is the process behind the oil: cold-pressed, refined and standardized oils can share a GLA family but not a colour, a free fatty acid limit or a label.

Three process decisions, not three brands

Black currant oil starts with Ribes nigrum seed. The first decision is the seed itself: cultivar, harvest and origin set the GLA and ALA ranges before any machine touches the oil. The second is extraction: a mechanical press at controlled temperature, with no solvent, is what the words cold-pressed describe. The third is finishing: a crude oil can be sold after filtration, or it can be degummed, neutralised, bleached and deodorised.

Those choices are cumulative. A refined oil can start from a cold-pressed crude oil, because pressing is the extraction step and refining is the clean-up. A standardized oil is a further decision: a physical separation step lifts the GLA fraction above the seed's natural range, and the result gets its own specification.

The species check matters. Evening primrose oil and borage oil are different plants with their own fatty acid profiles. They are alternatives, not grades of black currant oil, and a blend of two species is a third material.

The grades side by side

Process states of black currant seed oil, with the catalog item in the first column
PropertyCold-pressed, unrefined (catalog)RefinedGLA-standardized
Extraction and finishingMechanical press, no solvent; filteredPressed, then degummed, neutralised, bleached and deodorisedFeedstock oil taken through a separation step
GLA on the oil15.0–20.0%15.0–20.0%Above the natural range; stated on its own specification
ALA on the oil12.0–15.0%12.0–15.0%Follows the feedstock; declare the result
Free fatty acid≤0.50%Lower than the crude oilFixed on the new specification
Colour and clarityPale yellow to golden; can haze or drop sedimentLighter and brighter; more consistentVaries with the feedstock and the separation
Minor componentsTocopherols and sterols largely retainedPartly reduced by deodorisationChanged by the separation
What the order says“Cold-pressed, unrefined”“Refined”“GLA xx%, standardized”

The rows are not a ladder. Refining is a clean-up, standardization is a concentration, and cold-pressed is an extraction claim. A buyer who needs a pale, mild oil for a softgel may choose refined; a buyer whose label says cold-pressed cannot. The table describes three separate offers, not one product at three quality levels.

Clarity, sediment and the fill line

Cold-pressed black currant oil is clear to slightly hazy and can drop a sediment on standing; cooling can make it cloud. Those are physical behaviours, not signs of oxidation. A softgel line usually filters the fill, and a heavy sediment load means more filter changes and more oil held in the filter.

Refining removes gums and waxes, so the oil is brighter and more consistent, but deodorisation also strips some tocopherols and sterols. Standardization changes the fatty acid balance and can change colour and mouthfeel. Each step trades something away, and the specification should say which step was used.

Viscosity is low in all three states, and the oil is insoluble in water. Clean-up on the fill line needs a solvent or a detergent, not a water rinse. The oil can soften a softgel seam if it migrates into the shell, so the shell formula and the fill weight belong in the encapsulation trial.

Two fatty acids, two label numbers

At 15.0–20.0% GLA, a gram of oil carries 150–200 mg. A 500 mg softgel carries 75–100 mg; a 1,000 mg softgel carries 150–200 mg. At 12.0–15.0% ALA, the same gram carries 120–150 mg of ALA, so a 1,000 mg softgel carries 270–350 mg of the two combined.

The label has to declare the GLA and ALA figures separately, and both come from the oil weight and the profile. A standardized oil changes the weight needed for a fixed GLA figure; it does not change the need to state the basis. A refined oil keeps the natural GLA range, so the capsule weight stays the same while the colour and free fatty acid move.

Do not use the GLA figure alone to choose a grade. The ALA line and the process claim are part of the same purchase, and a softgel built around 500 mg of oil cannot reach a higher GLA figure without changing the oil, the capsule size or the number of capsules per serving.

What to put in the specification

Name the species, the extraction, the finishing and the GLA target in that order: “Black currant (Ribes nigrum) seed oil, cold-pressed, unrefined, GLA 15.0–20.0% of total fatty acids by GC.” Then add ALA 12.0–15.0%, linoleic acid 40.0–50.0%, free fatty acid ≤0.50%, peroxide value ≤5.0 meq O₂/kg, moisture ≤0.1%, the metal and microbiology panels, and the pack.

Add p-anisidine if the shelf life is long, and a sterol and tocopherol profile if the source or the grade is disputed. For a refined or standardized grade, replace the process line and the GLA range with the new values; do not leave the cold-pressed wording in place.

A specification that says only “18% GLA” has not told the supplier whether to press, refine or standardize. The process is part of the product identity, not a manufacturing detail.

When a grade switch is the wrong move

A cold-pressed claim is a promise about the process. If the label, the customer specification or the market file says cold-pressed, a refined lot does not satisfy it, even when the GLA result is identical. Refining also does not stop oxidation: it lowers free fatty acid and some colour, but peroxide value follows the seed, the press, the store and the pack.

Do not move to a standardized oil to shrink a capsule without rebuilding the label, the specification and the certificate. The GLA density changes, the serving weight changes and the ingredient name may change. Do not move to evening primrose oil either; it is a different species with a lower GLA range.

A grade change is a change control. It needs a new specification revision, a new certificate and a label check, not a verbal switch at the order desk.

The catalog item is on the black currant seed oil product page; certificate lines are explained on the COA page; oxidation is covered on the stability page; the alternative species is on the evening primrose oil page; the two-oil comparison is on the level-four page; test methods are indexed under analytical methods; and release is described on the quality page.

Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.

Request a quotation