How a trypsin lot is proved
A trypsin lot is identified by four pieces of evidence that agree: the document names the enzyme and its species of origin, the BAEE activity assay shows the expected rate, the protein pattern shows a band near 23 kDa, and the chymotrypsin ratio stays inside the agreed limit. No single line proves identity, and the activity figure is the easiest one to produce. The agreement between the lines is what makes the file worth reading.
A trypsin lot is proved by its activity against BAEE, its protein pattern and its chymotrypsin ratio, not by the name on the drum.
The four identity layers
A certificate can carry the right name and still describe a different powder. Each layer below answers a separate question, and a supplier who answers only the activity has described a rate, not a material.
| Layer | Question | Test | What it proves |
|---|---|---|---|
| Document | Is the material named, and from which species? | Name, CAS 9002-07-7, species and tissue statement | Paperwork only |
| Activity | Is the enzyme active against a tryptic substrate? | BAEE assay at 253 nm, pH 7.6, 25 °C | A protease with trypsin-like specificity |
| Protein | Is the protein the expected size? | Gel electrophoresis under reducing conditions | A band near 23 kDa, not a fungal or plant protease |
| Counter-activity | How much chymotrypsin travels with it? | ATEE assay at 237 nm | How far the purification went |
| Mass balance | Is the powder diluted, wet or partly inactive? | Protein, loss on drying, carrier check | Consistency of the other four lines |
The two ratios that matter
The first is chymotrypsin activity against trypsin activity. The two enzymes are extracted from the same tissue and co-purify, so a trypsin lot always carries some chymotrypsin; the ratio records how much. A high ratio points to a pancreas fraction that was separated only roughly, and a low ratio points to a purification step that removed the companion enzyme. Either can be inside the trypsin activity limit, which is why the ratio belongs on the specification.
The second is specific activity: units per milligram of protein. A high protein figure with a normal activity means inactive protein, an incompletely activated precursor or a foreign protein; a low protein figure with a normal activity means a purer preparation. Trypsinogen is the specific case to watch, because it is the inactive precursor of trypsin and it adds mass without adding BAEE activity. An activation step that was cut short shows up here, not in the activity value.
Read the two ratios together and they sort the failure modes. High chymotrypsin with normal trypsin is a separation problem. Normal chymotrypsin with low specific activity is an activation or a handling problem. Both ratios low or both high across several lots says more about the supplier's process than any single certificate.
X-ray diffraction is a weak tool here
Trypsin is supplied as an amorphous powder, so an X-ray diffraction pattern is a broad halo rather than a set of sharp reflections. It cannot identify the enzyme, and a certificate that offers “XRD conforms” as identity evidence for trypsin has offered a method that is not suited to the question.
The technique has one real use in this file: finding a crystalline diluent. Lactose monohydrate, dextrose and sodium chloride all give sharp patterns, so a trypsin powder that was cut with a carrier can show them even when the activity per gram has been adjusted to look normal. Before accepting a match statement, ask which reference pattern was used and how much crystalline material the method can see; a crystalline pattern in a powder sold as carrier-free is a question, not a result.
The identity test in the catalog is the BAEE activity assay together with an infrared spectrum, and the infrared comparison is a similarity check on the protein's amide bands rather than a sequence. For a disputed lot, peptide mass fingerprinting by mass spectrometry or N-terminal sequencing answers the identity question that neither infrared nor diffraction can.
What substitution looks like
| Substitution | What it does | Signal | Test |
|---|---|---|---|
| Chymotrypsin-rich pancreas fraction | Keeps the trypsin activity, adds a companion enzyme | Chymotrypsin ratio above the agreed limit | ATEE assay on the same lot |
| Another protease | Shows activity in a general protease method | No band near 23 kDa; different substrate profile | Gel electrophoresis and a substrate panel |
| Inert carrier | Lowers activity per gram without changing the appearance | Low activity with a high ash or a carrier pattern | Loss on drying, ash, infrared, diffraction |
| Autolysed or heat-damaged powder | Protein present, activity partly gone | Specific activity below the expected range | Protein and BAEE assay on the same sample |
| Undeclared species | Mismatch between the label and the pancreas source | Species statement inconsistent with the file | Supplier documents; species-specific test where needed |
Autolysis leaves a second trace. A gel of a partly autolysed lot shows the main band plus a ladder of lower-molecular-weight fragments, because the enzyme has been cutting itself. That pattern is a useful check on a powder that was held warm or at alkaline pH before drying.
What to write into the specification
- “Trypsin, species and tissue of origin stated, CAS 9002-07-7, EC 3.4.21.4.”
- “Activity ≥250 USP U/mg by the BAEE assay at 253 nm, pH 7.6, 25 °C; basis stated.”
- “Identification by BAEE activity and infrared spectrum compared with a reference.”
- “Chymotrypsin activity limited as a ratio to the trypsin activity, measured on the same lot.”
- “Protein and specific activity reported where agreed, with the method named.”
- “Loss on drying ≤5.0%; carrier declared; no second enzyme unless named.”
- “Species and TSE statement attached to every lot.”
Five questions for the supplier
- Which species and tissue is this lot from, and where is that stated on the certificate?
- What are the trypsin and chymotrypsin results on the same lot, and in which unit systems?
- Can you provide the protein figure, the specific activity and a gel image, not only the activity?
- Was the trypsinogen activation step complete, and how is that shown on the record?
- If the lot is disputed, will you re-test the retained sample with me, using the same method?
Five written answers make an identity file. The catalog entry is on the trypsin product page; the COA page explains how each figure is reported, the grades page compares the powder with a blend, the trypsin versus chymotrypsin page takes the two-enzyme question further, the assay vocabulary is in the methods section, and the quality page describes release.
Related documents
Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.
Request a quotation