What the COA for L-proline actually contains
An L-proline certificate reports appearance, identification by IR and HPLC, assay by HPLC, specific rotation on the dried basis, loss on drying, the pH of a 1% solution, particle size, heavy metals and microbiology. The figures below are the catalog specification; the batch certificate confirms a particular pouch or drum. Two lines carry the identity: the assay says how much proline is present, and the rotation says which proline it is.
The assay gives the amount of proline in the lot; the specific rotation gives the enantiomer, and only the two together describe the powder.
The certificate as an auditable report
A certificate is useful when each line can be checked against a method and a limit. A row that reports “conforms” without the reference, or a figure without its method, cannot be audited.
| Parameter | Method | Release limit |
|---|---|---|
| Appearance | Visual | White crystalline powder |
| Identification | IR and HPLC | Conforms to reference |
| Assay | HPLC | 98.5–101.5% |
| Specific rotation | Polarimetry, dried basis | -84.0° to -86.5° |
| Loss on drying | Gravimetric | ≤0.5% |
| pH (1% solution) | Potentiometry | 5.0–7.0 |
| Parameter | Method | Release limit |
|---|---|---|
| Particle size | Sieve analysis | ≥95% through 40 mesh |
| Heavy metals | ICP-MS | Pb ≤3 · As ≤2 · Cd ≤1 · Hg ≤0.1 mg/kg |
| Microbiology | Plate count and absence tests | APC ≤1,000 cfu/g; yeast and mould ≤100 cfu/g; E. coli and Salmonella absent |
The identity line needs both tests. IR gives a pattern that can be compared with a reference spectrum, and HPLC gives a retention time and a purity profile. Neither is a chiral measurement, so neither can separate the L form from the D form; that is the rotation's job.
The assay basis and the rotation conditions
The assay percentage is a fraction of the powder, and the powder contains water. The catalog range is 98.5–101.5% by HPLC; the certificate should say whether that figure is calculated as-is or on the dried basis. At the loss-on-drying limit of 0.5% the difference is small — 98.5% as-is becomes 99.00% on the dried basis — but the basis is part of the result, not a footnote.
Proline has no aromatic ring and no strong ultraviolet chromophore, so an HPLC method that depends on absorbance at a short wavelength sees very little. Practical methods derivatise the amino acid before separation, or use a detector that responds to the molecule itself. The certificate should name the derivatisation reagent, the column, the detection and the standard, because “by HPLC” on its own does not describe a method.
Specific rotation is the chiral line. The catalog window is -84.0° to -86.5° on the dried basis, and the sign and size of the figure are the enantiomer evidence. Rotation depends on solvent, concentration, path length and temperature; a certificate that omits those conditions cannot be compared with the window or with a second laboratory's result. Ask for the conditions even when the number is inside the window.
Limit and result in separate columns
A limit is the boundary a lot has to meet; a result is what the laboratory measured on that lot. They belong in separate columns, with the method beside them. A result column filled with the specification range is a copy of the gate, not a result.
| Parameter | Release limit | Result column |
|---|---|---|
| Assay | 98.5–101.5% by HPLC | A measured percentage with its basis and method |
| Specific rotation | -84.0° to -86.5°, dried basis | A measured angle with solvent, concentration and temperature |
| Loss on drying | ≤0.5% | A measured percentage |
| Heavy metals | Per element | A measured figure in mg/kg for each element |
| Microbiology | Counts and absence | The count and the absence statement for the lot |
| Particle size | ≥95% through 40 mesh | The measured percentage through the sieve |
A rotation just inside -84.0° is passing but close to the boundary a small amount of D form would cross; a loss on drying near 0.5% leaves little room for moisture pickup in a humid filling room. Neither is a rejection, but each deserves a question before release.
What changes from lot to lot
Moisture moves with the pack and the season. Mesh and colour move with crystallisation, drying and milling. The assay moves with moisture and with the amino-acid profile of the lot. The rotation should not move if the material is the L form; a drift toward zero is the finding that matters, because it points to the D enantiomer rather than to the water.
The arithmetic is simple. If a lot were 95% L-proline and 5% D-proline, the observed rotation would be about 0.95 × (-85.25°) + 0.05 × (+85.25°) = -76.7°, outside the catalog window, while an achiral HPLC assay could still report a figure inside the assay range. A rotation that has moved from about -85° to about -77° across lots is a racemisation finding, not an analytical nuisance.
The route can explain such a shift. L-proline from fermentation or from protein hydrolysis is normally the L form; a synthetic route that builds the racemate has to resolve it, and an incomplete resolution leaves the D form in the lot. The certificate, the batch record and the rotation together show which case applies.
When an outside test is worth ordering
An outside laboratory is worth using for a new source, a first shipment into a regulated market, an enantiomer claim the certificate does not support, or a disputed result. The panel is polarimetry with conditions stated, chiral HPLC for the D form, an amino-acid profile, IR against a reference, loss on drying, ICP-MS and microbiology.
Add a hydroxyproline check if the material could be collagen-derived. Hydroxyproline is the hydroxylated analogue, a different label ingredient with its own CAS number, and a method that does not separate the two can hide it. The rotations of the two are both negative and not far apart, so a blend can land inside the proline window; the chromatogram is the evidence that the two peaks were separated.
Every screen should come with its detection limit; a “not detected” entry without one says more about the method than the lot. Chain of custody matters: the material sent to the laboratory should be the material kept on file, and the report should identify the lot. If a result is disputed, supply the referee with the retained sample, the certificate and the specification, and specify the tests that separate the L form from the D form and the hydroxylated analogue.
Comparing two suppliers
Compare six lines: name and CAS number; assay result and basis; specific rotation with its conditions; loss on drying; heavy metals and microbiology; mesh and pack. If two offers match on assay but not on rotation, they are not offers for the same material.
Traceability is the second layer: the certificate should name the producer, the lot code should match the pack and the retained sample, and the specification should carry a version.
The catalog specification is on the L-proline product page. The tests that separate the L form from the D form and from hydroxyproline are on the identity page; the analytical methods are introduced in the methods library; the release workflow is described on the quality page.
Related documents
Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.
Request a quotation