02 Grades & sources

Sialic acid grades: free NANA, source and assay

Technical document 02 · Reviewed 2026-11-19 · Sialic Acid

On this page
  1. Why “sialic acid” is not one grade
  2. The form and the source side by side
  3. Solubility, pH and appearance
  4. The arithmetic behind a label declaration
  5. Writing the grade into the specification
  6. When another grade is the wrong choice

Sialic acid is supplied here as free N-acetylneuraminic acid, a single nine-carbon sugar acid; sialyllactose is a different ingredient in which sialic acid is bound to lactose. Within the free form, the grade decisions are the source (egg yolk, fermentation or dairy), the assay level and the physical form. Source and form both change the allergen statement and the label, so the grade is not only a percentage on the certificate.

In one line

The first grade decision is the form, the second is the source, and the assay percentage only ranks suppliers after both are fixed.

Why “sialic acid” is not one grade

Sialic acid is a family name for a group of nine-carbon acidic sugars. The commercial free form is N-acetylneuraminic acid, also written Neu5Ac or NANA, with CAS 131-48-6 and molecular weight 309.27. Sialyllactose is not a purer or weaker version of that material. It is a disaccharide made of sialic acid and lactose, and its sialic acid is locked in a glycosidic bond until hydrolysis. The two are different label ingredients with different assays.

Even inside the free form, one catalog number does not cover every lot. Egg yolk, fermentation and dairy routes arrive at the same molecule from different starting materials, and they leave different traces behind: egg or milk protein, lactose, other sugars, colour and related substances. The grade combines the form, the source and the assay because those three decide what the certificate can state and what the label may say.

The form and the source side by side

The first table separates the free sugar from the bound one. The second compares the sources that are used to make the free sugar. Neither table is a substitute for the specification of the lot being bought.

Free N-acetylneuraminic acid against bound sialyllactose
PropertyFree NANASialyllactose
Chemical formFree nine-carbon sugar acidSialic acid linked to lactose
CAS number131-48-6A separate CAS number for each isomer and salt
FormulaC11H19NO9C23H39NO19 for the disaccharide
Molecular weight309.27About 633.55
Sialic acid share100% of the moleculeAbout 48.8% by mass
Assay basisHPLC on the free sugarIntact disaccharide, or sialic acid after hydrolysis
SourceEgg yolk, fermentation or dairyDairy oligosaccharides or fermentation
Label nameN-Acetylneuraminic acidThe named sialyllactose, for example 3′-sialyllactose
Source options for the free sugar
SourceAllergen statementWhat to check
Egg yolkEggProtein carryover, colour, bound-sugar hydrolysis step
FermentationDepends on the mediumMedium residues, residual solvents, strain and recovery
DairyMilkLactose, milk protein and N-glycolylneuraminic acid

The allergen line follows the source, not the molecule. A fermentation route is not automatically free of an allergen declaration: the medium, the antifoam and the washing step decide whether an egg or milk protein can carry through. The source also decides whether a vegan claim is available.

Solubility, pH and appearance

Free N-acetylneuraminic acid is a white to off-white powder, freely soluble in water, and the solution is acidic. The catalog pH of a 1% solution is 2.0–3.5, which is what a free sugar acid reads; a sodium salt would sit higher. The powder is hygroscopic, so the water limit of ≤5.0% is a practical handling number, not only a certificate line.

Sialyllactose also dissolves in water, but its solution is not a solution of free sialic acid. The glycosidic bond holds until acid, heat or an enzyme breaks it. A formulator who needs the free sugar in a drink cannot reach it by dissolving sialyllactose, because the ingredient that reaches the label is still the disaccharide.

Appearance is the weakest way to tell the grades apart. Both can be white to off-white, and a spray-dried or diluted powder can look the same as a pure one. Colour and flow belong on the specification, but the identity and the source are settled by analysis and documents.

The arithmetic behind a label declaration

The molecular weights give the conversion. Sialyllactose at about 633.55 g/mol carries 309.27 g/mol of sialic acid, so the free-sugar share is about 48.8%. A formula that declares 50 mg of sialic acid from the disaccharide therefore needs about 50 ÷ 0.488 = 102 mg of sialyllactose. Where the ingredient is the sodium salt, the molecular weight rises by about 22 and the share falls to roughly 47.2%, so the weight needed rises again.

The free form is simpler. Take a 98.0% result on the as-is basis: 100 mg of powder delivers 98 mg of N-acetylneuraminic acid. If the assay is on the dried basis, the as-is figure is lower by the water content, and the weigh-up should use the as-is value. A label that declares 50 mg of free sialic acid therefore needs about 51 mg of a 98.0% powder, adjusted for the basis. None of these figures is a recommended intake. The arithmetic is there to keep the label declaration and the weigh-up in step.

The dose level and the permitted use belong to the destination market and the finished product, not to this page. The buyer's regulatory team confirms both before the label is fixed.

Writing the grade into the specification

  • “N-Acetylneuraminic acid, CAS 131-48-6, C11H19NO9, molecular weight 309.27.”
  • “Source: egg yolk, fermentation or dairy, stated on the certificate and the specification.”
  • “Assay ≥98.0% by HPLC, with the basis and the detection method named.”
  • “Water ≤5.0% by Karl Fischer; pH 2.0–3.5 at 1% w/v.”
  • “Metals and microbiology as listed, with the allergen statement matching the source.”
  • “No bound sialyllactose above the agreed limit, where the free form is claimed.”
  • “Destination and intended use settled before the order.”

We supply the free form. Sialyllactose is a separate purchase with its own specification, assay and label; substituting one for the other requires a written change control.

When another grade is the wrong choice

If the label names sialyllactose, free NANA is not a drop-in: the declared ingredient would change, and the sialic acid figure would no longer describe the same disaccharide. If the label names free N-acetylneuraminic acid, a sialyllactose lot cannot stand in, even if its total sialic acid figure is high after hydrolysis.

If the brand needs an egg-free or milk-free statement, the egg-yolk and dairy routes are excluded unless the purification and the allergen test support the claim. If a vegan statement is needed, check the fermentation medium as well as the organism. And if the destination file covers one source or one form, a switch of grade is a regulatory change, not a purchasing convenience.

Catalog values are on the sialic acid product page. The COA page explains the certificate lines; the sialic acid versus sialyllactose page continues the free-versus-bound comparison; the compliance page covers the allergen and market rules. For another specialty ingredient whose source and structure decide the grade, see the beta-glucan page; the HPLC method note covers the assay.

Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.

Request a quotation