How we prove a porcine collagen lot is porcine collagen
The name porcine collagen peptides makes a species claim, and a lot has to earn it four times over. The paperwork must name porcine skin and type I collagen; hydroxyproline and the amino acid profile must show collagen; SEC must show a peptide curve rather than gelatin; and a species PCR or a documented pig chain must tie the powder to the animal. A Kjeldahl protein figure on its own identifies none of that.
Hydroxyproline proves collagen and only a species test proves porcine, so the identity file needs both the chemistry and the chain.
The four identity layers
Identity is not a single check. A sheet can print “porcine collagen peptides” and still leave the source unproven, because the paper trail, the amino acid chemistry, the peptide size and the animal itself each need their own evidence.
| Layer | Question | Evidence | What it cannot show |
|---|---|---|---|
| Document | Is the species and tissue named? | Name, CAS number, species and tissue on the COA and specification | Whether the powder matches the paper |
| Composition | Is the material collagen? | Hydroxyproline, with an amino acid profile dominated by glycine and proline | Which animal, which tissue |
| Size | Is it hydrolysed? | SEC fractions, chiefly below 3,000 Da | Animal; whether the collagen is intact |
| Species | Is it porcine? | PCR on the raw skin, or a validated powder method, backed by the documented pig chain | Which tissue; whether the tissue tested is the drum |
The layers stack. A pig-skin powder with the right hydroxyproline but an undeclared bovine blend passes the collagen tests and fails as a porcine product; a genuine porcine hydrolysate with a gelatin-like SEC curve passes the species question and fails as a process.
The ratios that hold the sheet together
Start with peptide against protein. The porcine specification sets protein at ≥90.0% and peptide at ≥80.0%, and the gap between the two is the moisture, ash, free amino acids and salts that the peptide method does not count. A peptide result above the protein result on the same basis is impossible, so one method, one basis or one calculation is wrong. The certificate should also say whether the peptide figure is a share of the powder or a share of the protein.
The second ratio is hydroxyproline against protein. Hydroxyproline appears when proline in the collagen chain is hydroxylated, and a protein that did not come from collagen carries little of it. Read the result against the protein figure and the sheet has its simplest collagen check. It will not tell pig skin from cattle hide, however: porcine, bovine and fish type I all carry hydroxyproline in overlapping ranges, and no ratio separates them.
The nitrogen figure adds a third ratio. Protein is nitrogen × 5.55, and the titration cannot distinguish collagen nitrogen from urea or ammonium nitrogen. A porcine lot that clears 90.0% protein and 80.0% peptide together is internally consistent; a lot that clears the protein line while the peptide sits at its 80.0% floor is the one to hold for an amino acid profile.
What diffraction and infrared do not prove
X-ray diffraction reads crystal packing, and a spray-dried porcine hydrolysate has none to read: the trace is a broad hump, and no reference pattern identifies pig skin. Infrared returns the amide bands that collagen shares with other proteins, and those bands say nothing about the animal. Neither instrument belongs in a porcine file as source evidence.
Both tools earn their place on other raw materials. Diffraction separates polymorphs of mineral salts and crystalline amino acids, and infrared is a quick same-or-different check on an incoming powder. When a porcine lot is disputed, the useful panel is SEC for size, hydroxyproline and the amino acid profile for composition, and a species method plus the raw-material record behind the pig skin for the animal.
The adulteration routes, and the test that finds each
A porcine collagen powder has a defined amino acid signature, and a second protein or a diluent stirred into it usually leaves a mark on the sheet. The routes below are the ones a porcine specification and sampling plan should anticipate; each one moves a different number.
| Route | What it changes | Test that finds it |
|---|---|---|
| Gelatin | Pushes mass above 3,000 Da; a cooled solution can set | SEC curve above the 3,000 Da cut; gel test |
| Other protein | Kjeldahl rises while hydroxyproline falls | Hydroxyproline-to-protein ratio; full amino acid profile |
| Nitrogen spiking | Nitrogen rises without peptide mass | Peptide against protein; total nitrogen against amino nitrogen |
| Bovine or fish collagen | Species changes, collagen chemistry does not | Species-specific PCR; documented species chain |
| Maltodextrin or other diluent | Protein and peptide down; ash or loss on drying shifts | Mass balance; SEC; ash and loss on drying |
No single line covers the table. Hydroxyproline, the amino acid profile, the SEC curve and a species method together give a porcine lot its defence, and the four tests are a small panel against the risk they cover.
Writing the identity into the specification
- “Porcine collagen peptides, type I, porcine skin; CAS 9007-34-5.”
- “Protein ≥90.0% by Kjeldahl with N × 5.55; basis stated.”
- “Peptide content ≥80.0% and ≥80% below 3,000 Da by SEC-HPLC; fractions reported.”
- “Hydroxyproline reported as a supporting collagen marker, with its method, where the buyer's file requires it.”
- “Loss on drying ≤7.0%; ash ≤5.0%; particle size ≥95% through 80 mesh.”
- “Species proof: a signed porcine declaration, plus a species PCR on request.”
- “Metals and microbiology as listed; no porcine-free claim.”
The last line is the one that matters: the material is porcine, and a specification that also demands a porcine-free statement has described a different product.
Five questions for the supplier
- Is the tissue named as porcine skin on the COA, and is the species written in words rather than left to the CAS number?
- Which factor — 5.55 or another — and which basis sit behind the 90.0% protein line, and is the 80.0% peptide measured on the powder or on the protein?
- Will you release the full SEC curve with the column, calibration and fractions, not only the ≥80% below 3,000 Da headline?
- Which evidence backs the pig claim — PCR on the raw skin, a signed porcine declaration, or both?
- Does the drum's lot code agree with the COA and the retained sample, and is the religious-use position stated in the file?
Those five answers make an identity file; a protein percentage on its own does not. The product page carries the catalogue specification; the COA page sets out each figure on the certificate; the grades page covers the particle size; the source comparison sets out the label positions; the methods section explains the techniques.
Related documents
Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.
Request a quotation