06 Identity & adulteration

How to prove a fish protein peptide lot is fish

Technical document 06 · Reviewed 2026-11-19 · Fish Protein Peptides

On this page
  1. The identity layers
  2. The peptide-to-protein ratio and hydroxyproline
  3. X-ray diffraction: what it can and cannot show
  4. What adulteration looks like
  5. Writing identity into the specification
  6. Five questions for the supplier

A fish protein peptide lot is the named material when four measurements agree: the nitrogen figure with its factor, the peptide distribution with its window, the amino acid pattern including hydroxyproline, and the species record. The protein percentage alone cannot prove the source and cannot prove the peptide fraction. A collagen hydrolysate or a blend can be made to show a similar protein number.

In one line

Identity is the agreement between the nitrogen figure, the peptide distribution, the amino acid pattern and the species record, not the protein percentage alone.

The identity layers

Proving identity is cumulative: the document names the material, the nitrogen shows protein, the peptide method shows size, the amino acid data show protein type, and the species record shows the fish. Stopping at the first line describes the label, not the lot.

Six layers of fish protein peptide identity
LayerQuestionTestWhat it proves
DocumentAre the source and species named?Name, species, tissue, originThe label, not the powder
NitrogenIs it protein-rich?Kjeldahl with the factor statedNitrogen alone; says nothing about peptide size
PeptideIs the fraction in the window?HPLC with the chromatogramThe size fraction inside the window
Amino acid patternIs the protein fish, and is it collagen?Amino acid analysis, hydroxyprolineA source and protein-type fingerprint
SpeciesWhich fish?Species PCR or a documented species chainThe species claim, not the tissue
Mass balanceHas it been extended?Protein, ash and moisture togetherWhether the figures add up

The peptide-to-protein ratio and hydroxyproline

Protein is calculated from nitrogen, and peptide is a fraction separated by HPLC. The two numbers describe different aspects of one powder, and peptide should not exceed protein. At the catalog limits and on the same basis, 70.0% peptide against 80.0% protein means at least 87.5% of the protein mass sits in the peptide window. A lot with 80% protein and 45% peptide is a different powder, however strong the protein line looks.

Hydroxyproline is the collagen check. Muscle protein carries little of it; collagen carries 8–12%. A fish protein lot with a collagen-like figure is collagen or a blend, and a collagen lot with a low figure is not collagen. The specification should state the expectation instead of leaving the amino acid pattern to a brochure.

The nitrogen factor belongs to the ratio discussion as well. A general food-protein factor of 6.25 is usual for fish muscle; collagen is calculated at 5.55. Using the collagen factor on a muscle hydrolysate understates the protein figure by about 11%, and using the general factor on collagen overstates it by about 13%. The certificate should name the factor and apply it consistently.

Ash and moisture close the balance. At 80.0% protein, 10.0% ash and 7.0% moisture, about 3% remains for fat, carbohydrate and other material. A certificate showing 80% protein, 12% ash and 10% moisture does not add up before any species question.

X-ray diffraction: what it can and cannot show

Fish protein peptides are amorphous after drying, so X-ray diffraction is not a routine identity test. The pattern is a broad halo, and a bare “conforms” against an amorphous reference says almost nothing. XRD earns its place when the question is a crystalline carrier or a neutralisation salt; a sharp pattern means asking what crystalline material is present.

When XRD is offered as identity evidence, request the pattern, the reference and the detection limit. It measures neither the peptide fraction nor the fish source. Use it as a supporting solid-state check; the nitrogen, peptide, amino acid and species data still carry the identity.

What adulteration looks like

Common fish protein peptide substitutions and the signals
AdulterantWhat it doesSignalTest
Fish collagenRaises protein and changes the protein typeHydroxyproline high; ash low; peptide curve differentAmino acid profile, hydroxyproline, SEC
Other proteinRaises nitrogen with a non-fish sourceAmino acid pattern; allergen cross-contactAmino acid profile, allergen tests
Free amino acidsRaises nitrogen without peptidesPeptide fraction falls while protein holdsHPLC distribution, amino acid analysis
Non-protein nitrogenRaises Kjeldahl without peptide massNitrogen high, peptide low, ammonia detectedAmmonia or urea screen, peptide HPLC
Maltodextrin or starchDilutes the powderProtein and peptide both fall; sugar presentMass balance, sugar profile
WaterLowers the as-is proteinMoisture high; dry basis unchangedLoss on drying
Other fish speciesSpecies claim, not protein identitySpecies result or traceability gapSpecies PCR, origin record

Colour proves the least. The off-white to light tan window covers many powders, blends included, and a fish note is normal for the material. The stronger signals are the peptide-to-protein gap, the hydroxyproline figure and the species record. A certificate that reports protein and appearance but no identity data has left the likeliest substitution unexamined.

Writing identity into the specification

  • “Fish protein peptides; species or species mix, tissue and country of origin named.”
  • “Protein ≥80.0% by Kjeldahl; record the factor used and whether the percentage is as-is or dry.”
  • “Peptide ≥70.0% by HPLC; record the window and how the peak area was integrated.”
  • “Amino acid profile on file, with hydroxyproline reported by a validated method.”
  • “Species supported by a declaration and, where needed, a PCR result.”
  • “Fish allergen declared; ash ≤10.0%; moisture ≤7.0%; ≥95% through 80 mesh.”

Five questions for the supplier

  1. Which species or species mix and which tissue produced this lot, and are they on the certificate?
  2. What are the nitrogen factor, the protein basis and the peptide molecular-weight window?
  3. Will you release the peptide chromatogram and an amino acid profile that reports hydroxyproline?
  4. How do the ash and moisture figures close the mass balance?
  5. If the lot is disputed, will you re-test the retained sample jointly?

Those five answers, in writing, are the identity file. The catalog is on the fish protein peptides page; the COA page maps each figure to its line on the certificate; the grades page covers the peptide and ash options; the fish versus collagen comparison covers the protein-type question; the methods library explains the separation; the release file is set out on the quality page.

Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.

Request a quotation