Calcium gluconate grades: monohydrate, anhydrous and mesh
Calcium gluconate is supplied as the monohydrate, as the anhydrous salt and in several particle sizes. The monohydrate is the standard supplement grade: 98.0–102.0% assay, 8.5–9.5% calcium and 3.0–6.0% water by Karl Fischer. The anhydrous salt carries about 9.3% calcium and much less water. The choice changes the calcium figure per gram, the fill weight and the mass on the balance.
The hydrate state is the grade decision: the monohydrate carries about 4% water, so its calcium figure per gram is lower than the anhydrous salt's.
Why calcium gluconate comes in two hydrates
Calcium gluconate crystallises from water as the monohydrate. The water is held in the crystal lattice, not added as a carrier, and it leaves on drying. The monohydrate is the usual commercial form because the crystal is stable, free-flowing and defined by a water range. The anhydrous salt is made by drying that crystal further; it carries more calcium per gram and is chosen where added water is a problem.
Both are called calcium gluconate on a label, which is why the specification has to name the hydrate and the CAS number. The monohydrate is CAS 18016-24-5; the anhydrous salt is CAS 299-28-5. A purchase order that names only “calcium gluconate” has left the calcium figure, the water limit and the fill weight open.
Monohydrate and anhydrous compared
| Property | Monohydrate | Anhydrous |
|---|---|---|
| CAS number | 18016-24-5 | 299-28-5 |
| Formula | C12H22CaO14·H2O | C12H22CaO14 |
| Molecular weight | 448.39 | 430.37 |
| Calcium, theoretical | 8.94% | 9.31% |
| Water by Karl Fischer | 3.0–6.0% | Low; anhydrous grade |
| Appearance | White crystalline powder | White powder |
| Water solubility | About 3 g per 100 mL at 20 °C | Soluble in water |
| Typical use | Tablets, capsules, sticks | Dry blends and water-sensitive formulas |
The calcium difference is about 4% relative, not a rounding error. A formula that switches from the monohydrate to the anhydrous salt without changing the fill delivers more calcium per tablet and a different label figure. The switch belongs in change control, with a new assay and a new fill calculation.
Solubility, taste and particle size
Calcium gluconate dissolves to about 3 g per 100 mL of water at 20 °C, and much more readily in hot water. The solution is close to neutral, with a pH around 6–8, and the taste is mild. That makes the salt usable in a drink mix as well as in a tablet, although the mass needed for a meaningful calcium dose is large.
The catalogue form is a 40 mesh powder: at least 95% passes a 40 mesh sieve. Granulation is available on request and changes the flow, the dust and the bulk density. A granulated grade can feed a tablet press more evenly, but it is a different particle-size specification and should be qualified as such. The crystal form also affects the tablet: a fine powder compacts differently from a granule.
The powder is not strongly hygroscopic in the sealed pack, but it is not a desiccant either. A broken seal, a humid dose room or a long hold in an open container will move the water figure and can cause caking. The pack and the storage condition are part of the grade decision, not an afterthought.
From calcium claim to dosage form
The label claim is elemental calcium, not calcium gluconate. At 8.94% calcium, a 500 mg calcium claim needs 500 ÷ 0.0894 = 5.59 g of the monohydrate. A 1,000 mg calcium gluconate tablet delivers only 89 mg of calcium. That arithmetic drives the tablet size and the number of tablets per dose, and it is the reason the gluconate is often used in sticks or in multi-tablet regimens.
The same mass is easier to handle in a stick pack than in a capsule. A stick can carry 5–6 g of powder and dissolve in water; a capsule carries about a gram, so a 500 mg calcium dose would need several capsules. A tablet can be made large enough, but the swallowability and the excipient load become part of the design. The gluconate versus lactate comparison works through the tablet arithmetic in detail.
The hydrate state also moves the dose. The anhydrous salt at 9.31% calcium needs 5.37 g for the same 500 mg claim, about 4% less mass. That is a small change in the weigh-up but a real change in the label calculation and the tablet weight.
Clauses for the specification
- “Calcium gluconate monohydrate, CAS 18016-24-5, C12H22CaO14·H2O.”
- “Assay 98.0–102.0% as calcium gluconate by complexometric titration; state the basis.”
- “Calcium 8.5–9.5%; water 3.0–6.0% by Karl Fischer.”
- “Identification by IR and titration; report the gluconate-specific assay where the form is disputed.”
- “Particle size: at least 95% through 40 mesh; contaminants and microbiology per the table above.”
- “Destination market and finished-product calcium claim confirmed before the order.”
We supply the monohydrate. The anhydrous salt is a different purchase with a different calcium figure; a swap needs written change control and a new fill calculation.
When another salt is the better fit
If the tablet has to stay small, calcium gluconate is the wrong starting point. Calcium carbonate carries about 40% calcium, calcium citrate about 21% and calcium lactate about 13%; each delivers more calcium per gram and needs less fill. The gluconate is chosen for its mild taste, its neutral solution and its handling, not for calcium density.
If the formula is water-sensitive, the anhydrous salt is the better gluconate grade; if the formula is a clear drink, the lactate may dissolve more easily. If the label has to name a specific salt, the choice is fixed before the formula is written. The product hub carries the catalogue specification; the calcium lactate page sets out the alternative; the calcium citrate page covers the intermediate calcium figure; the COA page shows how the hydrate is reported.
In this document
Related documents
Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.
Request a quotation