Cold-pressed or refined perilla seed oil: choosing a grade
Perilla seed oil is sold cold-pressed, refined, or as a powder on a carrier. The two oils can sit inside the same ALA window, while the powder reports ALA on the powder; all three differ in free fatty acid, peroxide value, colour, clarity, flavour and shelf life. The grade is part of the specification, not a word in front of the same oil.
The grade is a processing decision: it moves the free fatty acid, the peroxide value, the colour and the minor fraction, while the ALA window barely moves.
Why the grade changes the oil
Cold-pressed oil is obtained by pressing and filtration, under a temperature ceiling the producer states. The process leaves phospholipids, waxes, pigments and tocopherols in the oil, which is why a cold-pressed lot can be hazy, deeply coloured and full-flavoured. Refining adds degumming, neutralisation, bleaching and deodorisation. Those steps remove free fatty acids, pigments and odours, and they also remove part of the minor fraction that protects the oil.
The fatty-acid profile barely moves. ALA, linoleic and oleic acid sit in the same ranges before and after refining, because the steps do not saturate or isomerise the chain under normal conditions. What moves is the FFA, the PV at release, the colour and the flavour. A buyer who compares the two oil grades on ALA alone has compared the line least likely to differ.
Three grades compared
| Grade | Process | FFA and PV | Colour and flavour | Typical use |
|---|---|---|---|---|
| Cold-pressed | Pressed and filtered; no solvent | ≤0.50% FFA; PV ≤5.0 | Golden, green-grassy, full | Softgels and oil blends where the flavour is part of the product |
| Refined | Degummed, neutralised, bleached, deodorised | FFA lower than a cold press; PV controlled at release | Pale, mild, neutral | Capsules and neutral blends with a long ambient shelf life |
| Powder on carrier | Oil dispersed in a declared carrier | Measured on the extracted oil | Free-flowing, colour from the carrier | Stick packs, capsules and blends that need a dry form |
“Cold-pressed” describes a process, not a composition. The word does not set an FFA limit, a colour or a peroxide value, so the specification still has to carry the numbers. A refined oil sold under a cold-pressed name is a grade substitution even when the ALA result is inside the range. The standard grade in this catalog is cold-pressed; refined is a separate specification with its own limits and should be quoted as such.
What the oil is like to handle
The oil is a liquid at room temperature and pours easily. Its density is below that of water, so a 1 kg bottle holds a little over a litre. Cold storage can produce a haze or a soft solid fraction as waxes and the more saturated triglycerides crystallise; that is reversible on warming and is not a defect in itself. A lot that stays cloudy at room temperature is a different question and should be checked against the clarity line.
Light and oxygen are the handling variables. An amber bottle is a light barrier and a clear one is not; a drum should stay closed, dark and off a warm floor. A nitrogen blanket can be requested for a long storage period. A pump that recirculates air through the drum adds oxygen on every draw, and a half-empty drum is a larger headspace than a full one.
The arithmetic behind a label
At the catalog midpoint the oil is 60% ALA, so one gram delivers about 600 mg. A 500 mg softgel carries about 300 mg of ALA; a 1,000 mg softgel about 600 mg. These are arithmetic on the specification, not a result for a lot, and the batch COA is what confirms a particular fill.
The powder is a different calculation. The ALA figure on a powder is expressed on the powder, and the oil load is the multiplier that connects it to the oil. If a powder carries 50% oil at 60% ALA, the powder is 30% ALA; a 500 mg capsule of it delivers about 150 mg, not 300 mg. Ask which basis the figure uses before comparing a powder with an oil.
What the grade clause should say
- “Perilla frutescens seed oil, cold-pressed and filtered; country of origin declared.”
- “ALA 55.0–65.0% of total fatty acids by GC; linoleic and oleic 12.0–20.0% each.”
- “Free fatty acid ≤0.50% as oleic acid; peroxide value ≤5.0 meq O2/kg.”
- “Moisture ≤0.1%; appearance clear to slightly hazy, light yellow to golden.”
- “Antioxidant: none added, or the name and level declared.”
- “Pack: 1 kg amber bottle or 25 kg HDPE drum; nitrogen blanket on request.”
- “Destination market and grade confirmed before the order.”
When a grade is the wrong choice
Cold-pressed is the wrong choice when the customer expects a neutral taste, when the capsule has to sit on a warm shelf for two years, or when the colour has to be consistent from lot to lot. Refined is the wrong choice when the cold-pressed character is the reason for the product, or when the label names a cold-pressed oil and the specification allows a refined one. The powder is the wrong choice when the dose needs a small capsule or when the carrier is not acceptable on the label.
Name the grade in the purchase order rather than inferring it from the colour or the flavour. The catalog specification is on the perilla seed oil product page. The COA page shows where the grade appears on the certificate, and the stability page explains what the choice does to shelf life. The powder form of the other ALA oil is on the flaxseed oil powder page. The methods index covers the GC and titration work, and the quality page describes the release file.
In this document
Related documents
Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.
Request a quotation