What the COA for fish oil powder actually contains
A fish oil powder COA has to describe three things at once: the oil, the starch matrix around it and the lot itself. The useful lines are EPA+DHA by GC, EPA and DHA separately, moisture, PV, p-AV, carrier, particle size, heavy metals and microbiology, each with a method and a limit. The catalog numbers are the gate; the certificate records what one lot actually measured.
The 10% total hides more than it shows: the EPA/DHA split, the oxidation values and the carrier decide what the powder is.
Reading a certificate line by line
A certificate can be checked only when each line carries a method and a limit. Without a method, the number cannot be reproduced; without a limit, the reader cannot see what the lot was released against. The header should carry the lot code and CAS 8002-50-4.
| Parameter | Method | Limit for release |
|---|---|---|
| Appearance | Visual | White to light yellow, free-flowing powder |
| EPA + DHA | GC-FID, fatty acid methyl esters | ≥10.0% |
| EPA | GC-FID, fatty acid methyl esters | Reported |
| DHA | GC-FID, fatty acid methyl esters | Reported |
| Moisture | Gravimetric, vacuum oven | ≤5.0% |
| Carrier and antioxidant | Declaration and starch identification | Modified starch and antioxidant, both named |
| Particle size | Sieve analysis | ≥95% through 40 mesh |
| Parameter | Method | Limit for release |
|---|---|---|
| Peroxide value | AOCS Cd 8b-90 or ISO 3960 | ≤5.0 meq/kg |
| p-Anisidine value | AOCS Cd 18-90 or ISO 6885 | ≤20.0 |
| Heavy metals | ICP-MS | Pb ≤3 · As ≤2 · Cd ≤1 · Hg ≤0.1 mg/kg |
| Microbiology | Plate count and absence tests | APC ≤1,000 cfu/g; yeast and mould ≤100 cfu/g; E. coli and Salmonella absent |
The assay is a fatty acid methyl ester GC: the oil is transesterified, the methyl esters are separated on a capillary column and quantified against a standard. AOAC 991.39 is the usual reference for encapsulated fish oils. The certificate should name the column, the standard and the quantification method; without that, two laboratories can disagree about one lot.
EPA and DHA are reported separately because a total hides the profile. A powder at 10% with 8% EPA and 2% DHA is not the same material as one at 5% and 5%, even though the sum is identical. DPA and other n-3 fatty acids sit outside the total, and the powder's fish oil content is a separate figure.
Where the 10% is measured
Ten percent means 100 mg of EPA+DHA in every gram of powder as sold. It is not the fish oil content. The oil is held in a modified starch wall, so antioxidant, moisture and starch make up the rest. A 10% powder built on a natural oil carrying about 30% EPA+DHA needs roughly one third oil; a concentrate needs less. The oil load belongs on the technical data sheet, not inferred from the assay.
The basis matters. A result on a dried basis reads higher than one as sold, because moisture may reach 5%. State the basis once and use the same one in the specification. Build the label dose on the release floor, not the highest result seen.
Limit, result and the oxidation arithmetic
A release limit is the gate a lot has to pass; the batch result is the number the laboratory found. They belong in separate columns. A column that simply restates the limit has reported no measurement at all.
Peroxide value and p-anisidine value measure different stages. PV counts hydroperoxides, the first products of oxidation; p-AV counts the aldehydes that follow. Neither is complete alone. TOTOX is twice PV plus p-AV, and it belongs beside the raw results.
The catalog limits of 5.0 meq/kg and 20.0 allow a TOTOX of 30. The GOED voluntary monograph caps the same calculation at 26, so a lot can meet both lines and still sit above the benchmark. A buyer who wants the 26 ceiling should write it into the purchase specification as a third line.
PV is also not monotonic. Hydroperoxides decompose as an oil ages, so the value can fall while p-AV rises. A low PV on an old lot is not proof of freshness; read the pair against the production date. Moisture belongs in the same review: water in the matrix speeds the decay of both wall and oil.
Why two lots are not identical
The fatty acid profile moves with species, fishing ground and season. Anchovy, sardine and menhaden do not deliver the same EPA/DHA ratio, so a species change without a specification change is a material change. The ratio is the quickest check: a natural oil keeps close to its source; a concentrate can be cut to almost any ratio.
The oil load moves with the target assay and the dryer. Carrier, antioxidant or solids changes alter the emulsion, the particle size and the surface oil, and surface oil is the part most exposed to oxygen.
Oxidation moves with all of the above plus time and temperature. A lot released at 2 meq/kg can reach the ceiling during a warm transit if the pack lets oxygen through.
When independent testing earns its place
Bring in an outside laboratory for a new supplier, a first entry into a regulated market, a carrier change or a disputed result. The panel should close the gaps left by the certificate: a full fatty acid profile with chromatogram, PV and p-AV by a named method, TOTOX, moisture, heavy metals by ICP-MS and the microbiology set.
Two identity questions need more than a FAME run. The form of the oil, triglyceride or ethyl ester, is lost when the fatty acids are methylated for GC; it needs an intact lipid analysis, such as HPLC or GC of the intact esters. The carrier needs a starch identification and a named antioxidant. The fish allergen position is a file and label question, not a protein assay on a refined oil.
Six checks before ordering
Six checks, read together, show whether two offers describe one powder. A match on 10% alone proves very little.
| Check | Ask the supplier | What it reveals |
|---|---|---|
| Source | Species, origin and form of the oil | Two oils with the same total and a different label |
| Profile | EPA and DHA separately, with the chromatogram | A measured lot from a copied 10% line |
| Oxidation | PV, p-AV and TOTOX, with methods and dates | A fresh lot from one near the ceiling |
| Carrier | Modified starch identity and antioxidant name | A declared matrix from an undisclosed blend |
| Allergen | Fish declaration and species statement | A file that can support the pack from one that cannot |
| Traceability | One lot code across certificate, pack label and retained sample | A certificate from a different lot |
The catalog specification is on the fish oil powder product page. The oil form is set out on the grade page, and the tests that separate one oil from another are on the identity page. The COA glossary defines the certificate terms.
Related documents
Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.
Request a quotation