02.1 L vs DL

L-phenylalanine vs DL-phenylalanine: the enantiomer, the assay and the label

Technical document 02.1 · Reviewed 2026-11-19 · L-Phenylalanine

On this page
  1. One chiral centre, two molecules, one mixture
  2. The rotation, read as a number
  3. Why the assay cannot answer the question
  4. Solubility, pH and the crystal
  5. What the label has to say
  6. Choosing between them

L-Phenylalanine and DL-phenylalanine share the formula C9H11NO2 and the molecular weight 165.19, and differ in what the drum contains: one enantiomer against a near-equal mixture of both. The racemate delivers about half the L form per gram, reads close to zero on a polarimeter, and cannot be separated from the L material by a conventional HPLC assay. The label has to name the form, and the specification has to carry the rotation.

In one line

Two materials with the same formula, the same assay window and opposite optical behaviour: the rotation is the line that separates them and the label is the line that has to follow it.

One chiral centre, two molecules, one mixture

Phenylalanine has a single chiral centre at the alpha carbon, so it exists as two mirror-image enantiomers. The L form is (S)-2-amino-3-phenylpropanoic acid and the D form is (R). The L form is the one found in dietary protein and the one bought for supplement use; the D form is a small-volume research and synthesis material. DL-Phenylalanine is not a third molecule: it is a mixture of the two, normally close to 1:1, which is why it is optically inactive.

The identifiers are separate. L-Phenylalanine is CAS 63-91-2, DL-phenylalanine is CAS 150-30-1, and D-phenylalanine is CAS 673-06-3. The three have the same formula and the same mass, so a certificate that reports only formula, appearance and assay has said nothing about which of them is in the pack.

The rotation, read as a number

Specific rotation is the observed rotation normalised to unit concentration and path length. The catalog window for the L form is -33.0° to -35.5° on the dried basis; the racemate reads close to zero; the D form reads positive with a similar magnitude. The sign gives the direction; the size gives the distance from racemic.

The value is linear in the enantiomer fraction, so it converts into an enantiomeric excess. Take a pure L reference near -34.25° and a measured -25.7°: 25.7 ÷ 34.25 = 75% excess, which is about 87.5% L and 12.5% D. At the lower edge, -33.0°, the excess is about 96%, or roughly 2% D: the lot passes and is still not fully resolved. The measurement is small and easy to spoil: at 1 g per 100 mL in a 1 dm cell, -34° gives an observed reading of about -0.34°, so temperature, dissolution and cell cleanliness matter. Specific rotation also depends on the solvent, and a certificate that omits the solvent, concentration and temperature cannot be checked. The method notes are collected in the methods library.

Why the assay cannot answer the question

The common assay is reversed-phase HPLC with ultraviolet detection against a phenylalanine standard. Both enantiomers have identical spectra and, on a conventional C18 column, identical retention, so the method counts molecules and ignores handedness. A racemic lot at 99.0% and an L lot at 99.0% produce the same certificate line.

Phenylalanine has a weak chromophore, so many methods read 200–220 nm or derivatise the amino group; neither changes the chiral blindness. To separate the enantiomers, use a chiral stationary phase, a chiral derivatising reagent such as Marfey's reagent, or chiral gas chromatography after esterification. Polarimetry is the routine check and chiral HPLC the quantitative one; a DL certificate with neither has not reported the enantiomer content.

Solubility, pH and the crystal

L-Phenylalanine dissolves to about 27 g per litre of water at 20 °C, so a 1% solution is clear and a 3% stock is difficult at room temperature. Solubility is lowest near the isoelectric point, about pH 5.5, because the molecule carries almost no net charge there; acid or alkali raises it. The catalog pH of 5.0–7.0 for a 1% solution sits across that point, so the powder dissolves slowly without stirring.

The racemate is a distinct solid phase rather than a physical mixture of two crystals, so its melting behaviour, crystal habit and dissolution rate can differ from the L material. For a tablet or a suspension it can change flow and dissolution, so a formulation trial is the reliable test. The hydroxylated analogue, L-tyrosine, is one oxygen heavier, much less soluble and a separate ingredient, not an alternative grade.

What the label has to say

The ingredient name is the first obligation. “L-Phenylalanine” means the L enantiomer and “DL-phenylalanine” means the mixture; the declared amount describes the named ingredient, not a calculated quantity of one enantiomer inside it. In the EU the name sits among the particulars required by Regulation (EU) No 1169/2011 and the supplement rules of Directive 2002/46/EC; in the US it is declared in the Supplement Facts panel under 21 CFR 101.36. There is no Daily Value and no Nutrient Reference Value for the amino acid, so no percentage belongs beside the amount.

Phenylalanine also carries a labelling consequence that most amino acids do not. It is the amino acid that people with phenylketonuria must restrict, and food law provides a declaration for foods that are a source of it. The familiar wording is attached in the EU and the US to foods containing aspartame, so a free amino acid is not automatically covered by the same sentence. The destination's reviewer confirms whether a statement is needed and in which words; this page is not a label text.

The claim wording follows the same rule. A statement written for L-phenylalanine cannot be moved onto a DL product by editing the ingredient list, because the claim would then describe a material that is not in the pack. A claim that names a disease is outside the supplement route in every market discussed here.

Choosing between them

Which phenylalanine form fits which brief
BriefFormReason
Capsule or stick pack labelled L-phenylalanineL form, 40 mesh or milledThe label, the rotation and the file all have to say L
Reformulation of a product already labelled LL formA change of form changes the label and the market file
Racemic reference for a method or a studyDL formThe rotation reads near zero, and the certificate should say so
Peptide synthesis or a research standardD form or the esterDifferent materials with their own certificates
Offer without a rotation or a chiral resultNeitherThe enantiomer is unproven, whatever the assay says

Two rules close the question. Count grams of L delivered, because a kilogram of racemate supplies about half the L of a kilogram of the L grade. Then put the rotation into the specification and check it on the first delivery; one reading settles what a page of assay data cannot.

The wider grade range is on the grade page, the identity layers on the identity page, the certificate lines on the COA page, and the market rules on the compliance page. The same enantiomer question for another amino acid is worked through on the L-tryptophan page, and the catalog specification is on the product page.

Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.

Request a quotation