What the COA for chicken collagen peptides actually contains
A chicken collagen COA is a release record for a hydrolysate, and it is complete only when the nitrogen factor, the SEC method, the moisture and ash balance, and the chicken species and tissue sit together. The ranges below are the catalogue specification; the certificate reports the lot. Percentages without those anchors cannot be compared across suppliers.
A chicken collagen certificate is readable only when the protein factor, the peptide distribution and the chicken source are stated together with their methods.
Reading the sheet as a chain of evidence
Read the sheet as a chain. Appearance shows what the dryer produced; protein shows the nitrogen once the factor is known; the two SEC lines show how the protein is cut; moisture and ash account for the non-protein mass; the metal and micro panels cover safety. Each row needs a method and a limit as well as a number, or the reader has a conclusion rather than a measurement.
| Parameter | Release limit | Method |
|---|---|---|
| Appearance | Off-white to pale yellow powder | Visual |
| Protein | ≥90.0%, dry basis | Kjeldahl, N × 5.55 |
| Peptide content | ≥80.0% | SEC-HPLC |
| Molecular weight | ≥80% below 3,000 Da | SEC-HPLC |
| Loss on drying | ≤7.0% | Gravimetric |
| Ash | ≤5.0% | Gravimetric, furnace |
| Heavy metals | Pb ≤3; As ≤2; Cd ≤1; Hg ≤0.1 mg/kg | ICP-MS |
| Microbiology | APC ≤1,000 cfu/g · yeast and mould ≤100 cfu/g · E. coli and Salmonella absent | Plate count and absence tests |
| Particle size | ≥95% through 80 mesh | Sieve analysis |
Two items belong in the file even though they are not in the table. The first is the source line: the catalogue does not fix a tissue, and skin, feet and bone each bring their own fat, mineral and odour profile. The second is hydroxyproline, the amino acid that marks collagen; with no catalogue limit, it is a supplementary test rather than a release line. Add pH only if the matrix needs it.
The factor, the moisture and the peptide basis
Kjeldahl gives a nitrogen figure. Turning it into protein needs a factor, and collagen uses 5.55 because the protein carries roughly 18% nitrogen; a general food protein uses 6.25, assuming 16%. Applied to the same digest, 6.25 lifts a 90.0% collagen result to about 101%. The powder has not changed; the arithmetic has. Print the factor beside the figure it produced.
Moisture is the second half of the basis. The catalogue protein limit is on a dry basis. At 7.0% loss on drying and 90.0% protein on the dry basis, the powder as weighed carries about 83.7% protein. That as-is number is what the balance uses. A certificate that omits the basis leaves the reader to guess, and a several-point error can follow.
The SEC lines have their own basis. Peptide content and the molecular-weight distribution are not the Kjeldahl percentage, and they should not be added to it or subtracted from it. One line describes how much material the column recovers as peptide; the other describes where that peptide sits by size. Ask for both, with the fraction bins, so the cut-off is visible.
Limit, result and the gap between them
The limit is the gate; the result is the measurement. A certificate that fills the result column with the specification has published the gate twice. Keep them apart, with the method beside the result.
| Parameter | Specification | Evidence expected |
|---|---|---|
| Protein | ≥90.0% dry basis | Measured percentage; factor and moisture basis stated |
| Peptide content | ≥80.0% | Measured value; SEC method named |
| Molecular weight | ≥80% below 3,000 Da | Fraction table or chromatogram, not only the gate |
| Loss on drying | ≤7.0% | Measured percentage |
| Ash | ≤5.0% | Measured percentage |
| Heavy metals | Per element | Result in mg/kg for each element separately |
A pass can hide a difference on the molecular-weight line. A lot that clears 80% below 3,000 Da with a heavy shoulder just above the line wets out and dissolves differently from a lot with a clean cut, though both pass. The distribution, not the pass mark, predicts behaviour in a stick pack or a drink.
Where lot-to-lot variation enters
Variation starts before the reactor. Skin, feet and bone differ in fat, mineral and collagen density, and a plant running more than one stream will produce lots that differ in ash and colour under the same recipe. Raw material held longer before processing develops a different odour that no protein figure captures.
Inside the reactor, enzyme dose, temperature and time set the chain length. Downstream, filtration decides how much fine fraction survives, and the dryer fixes moisture, mesh and part of the colour. A dryer change can move particle size and bulk density while protein stays flat, so the specification should cover the physical lines too.
Odour belongs in the receiving record. The powder has a mild note by nature; a stronger or different note can follow residual fat, a longer hold or a wetter raw material. A lot can pass every number and still smell unlike the previous drum, and the retained sample is the only fair comparison. The lot code should link certificate, pack and sample.
When to use an outside laboratory
Four situations justify an outside test: a source you have not run, a first commercial shipment into a regulated market, a label that names the species without evidence, and any result you cannot reconcile with the retain. The panel should answer the open question, not repeat the release sheet. A species question needs a species method or raw-tissue PCR; a collagen question needs hydroxyproline and the amino acid profile; a size question needs SEC with the fraction bins.
Ask for the method’s detection limit alongside any “none detected” statement; without it, the reader knows the method found nothing at its own sensitivity, not that the sample contains nothing. Keep the sample chain tight: the material tested should be the retained sample, and the report should name the lot. For a dispute, send certificate, specification and retain to the referee and ask for the test that separates the explanations.
Six lines for a supplier comparison
A comparison should show species and tissue; protein with factor and basis; peptide content and the SEC distribution; moisture, ash and mesh; the metal and micro results; and the allergen, origin and species statements. Two quotations can match on protein and differ on the other five, in which case they describe different powders.
The catalogue ranges are on the chicken collagen peptides product page. The tests that separate chicken collagen from another collagen are on the identity page; the market file is on the compliance page; the chromatographic and Kjeldahl methods are described in the methods notes; and the release file is described on the quality page.
Related documents
Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.
Request a quotation