02 Grade comparison

Evening primrose oil grades: cold-pressed, refined and concentrated

Technical document 02 · Reviewed 2026-11-20 · Evening Primrose Oil

On this page
  1. Why the process is the grade
  2. The grades side by side
  3. Colour, haze, flow and the softgel
  4. The GLA figure behind the label
  5. Writing the grade into the specification
  6. When not to switch grade

Evening primrose oil is graded by the process it has been through, not only by its GLA figure. Cold-pressed oil keeps the seed's colour, odour and native tocopherols; refined oil is lighter, lower in free fatty acid and more consistent in appearance; a concentrated oil lifts the GLA above the 8–11% range by a physical separation step. The catalog item here is the cold-pressed oil, and the other grades are separate specifications rather than upgrades.

In one line

The grade of an evening primrose oil is set by how the seed was pressed and how the crude oil was finished, so colour, free fatty acid and the certificate change even when the GLA range does not.

Why the process is the grade

GLA comes from the seed, but the oil around it is changed by the way the seed is pressed and the way the crude oil is finished. A cold-pressed oil is produced by mechanical pressing at a controlled temperature, without a solvent extraction step. It keeps more of the seed's minor components, so the colour is deeper and the odour stronger than a refined oil's.

Refining is a sequence: degumming, neutralisation, bleaching and deodorisation. Each step removes something. Free fatty acid falls, colour and odour are reduced, and the waxes and gums that make a cold-pressed oil hazy are taken out. Some tocopherols and sterols go with them, so a refined oil is not automatically the more stable one; it is the more consistent one.

A concentrated oil is a different operation again. The GLA fraction is raised by a physical separation step, and the resulting oil is specified on its own GLA figure rather than on the 8–11% range. It is a different raw material with a different label calculation.

The grades side by side

Process grades of evening primrose oil, with the catalog item in the first column
PropertyCold-pressedRefinedConcentrated
ProcessMechanical pressing, no solventDegumming, neutralisation, bleaching, deodorisationPhysical separation to raise the GLA fraction
GLA on the oil8.0–11.0% (catalog)8.0–11.0%Above the catalog range; stated in the specification
Free fatty acidUp to 0.50% (catalog)Usually below 0.10%Set by the specification
Colour and odourPale yellow to golden; characteristic seed odourLighter and milderFollows the feedstock and the separation
Native tocopherolsLargely retainedPartly reduced by deodorisationDepends on the process
Typical useSoftgels and oil blends that name a cold-pressed oilSoftgels where colour and taste are tightFormulas that need a smaller oil weight per GLA figure
Label nameOenothera biennis oilOenothera biennis oilThe concentrate's own name and specification

The table is a comparison of process routes, not a ranking. A refined oil suits a softgel fill that has to be pale and mild; a cold-pressed oil suits a label and a customer specification that name that route. The concentrated oil is a separate purchase with its own GLA figure and label arithmetic.

Colour, haze, flow and the softgel

The catalog appearance is clear to slightly hazy, pale yellow to golden. A cold-pressed oil can throw a sediment on standing, and a haze can appear when the bottle is stored cool; both are physical. The fill line still has to deal with them: a softgel fill is usually filtered, and a hazy oil can blind a filter or leave a deposit in the holding tank.

Viscosity is low at room temperature, and the oil flows readily. That makes it easy to pump and fill, and a leak in a softgel seam shows up quickly. The oil is insoluble in water and soluble in fats and organic solvents, so a water-based cleanup is the wrong approach on the fill line.

Colour is a weak specification line. Two cold-pressed lots can differ visibly and both be inside the catalog window; a refined lot is expected to be lighter.

The GLA figure behind the label

At 8.0–11.0% GLA on the oil, one gram of oil carries 80–110 mg of GLA. A 500 mg softgel therefore carries 40–55 mg and a 1,000 mg softgel carries 80–110 mg, before any overage or filler. To declare 100 mg of GLA per serving, the formulator needs 0.9–1.25 g of oil, which sets the capsule size or the number of capsules per serving.

A concentrated oil changes that arithmetic in proportion: the oil weight for a fixed GLA figure falls as the GLA fraction rises. The label logic does not change: the declared GLA per serving is still the oil weight multiplied by the GLA on the oil, and the certificate still has to state the basis. The ingredient name and the specification do change.

A refined oil keeps the same GLA range, so the capsule weight for a given GLA figure does not move when a cold-pressed oil is replaced by a refined one. The free fatty acid, colour and odour move instead.

Writing the grade into the specification

Start with the species and the process: “Evening primrose (Oenothera biennis) seed oil, cold-pressed.” Then set the GLA range and state the basis: on the oil. Add the linoleic and oleic ranges, free fatty acid, peroxide value, the heavy-metal and microbiology panels, moisture and the pack. Add the p-anisidine value if the customer's shelf life is long, and state the sterol profile if a blend is a concern.

A specification that says “evening primrose oil 10% GLA” names a figure without a process, and a specification that says “cold-pressed” without the profile names a process without a measurement. The grade belongs in the product name and in the specification revision, not only in a marketing line.

For the concentrated grade, the GLA range, the process and the label name all change together. Handle it as a new specification with a new certificate, not as the same oil at a higher figure.

When not to switch grade

Do not switch from cold-pressed to refined if the label, the customer specification or the market file names a cold-pressed oil. The GLA figure may be identical and the ingredient declaration may look the same, but the process claim on the pack is no longer supported. Do not switch to solve an oxidation problem either: refining lowers free fatty acid and some colour, but the peroxide value is set by the seed, the pressing, the storage and the pack, and a refined oil in a clear bottle can still fail.

Do not switch to a concentrate to fit a smaller capsule without rebuilding the label and the specification. The GLA per gram changes, the oil weight per serving changes and the ingredient name may change. A concentrate is the right answer when the formula genuinely needs it, not when a smaller oil load could solve a capsule-size problem.

The cold-pressed specification is on the evening primrose oil product page; the COA page explains the certificate lines, the stability page covers oxidation, the level-four comparison takes the oil-versus-powder question, the powder page covers the powder format, the methods are indexed under analytical methods, and lot release is on the quality page.

Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.

Request a quotation