06 Identity & adulteration

How we prove an EPO lot is evening primrose oil

Technical document 06 · Reviewed 2026-11-19 · Evening Primrose Oil Powder

On this page
  1. Four layers of identity
  2. The GLA/linoleic ratio and the full profile
  3. What XRD can and cannot show
  4. The routes that matter
  5. Writing identity into the specification
  6. Five questions for a supplier

A GLA figure is not an identity. Several seed oils contain GLA, and a blend can be built to land inside an 8–11% range. Proving that a lot is evening primrose oil means showing the full fatty-acid profile, the oil load, the sterol pattern where needed and the oxidation values, and tying them to the lot on the certificate and the pack.

In one line

A GLA figure can be matched by another oil or a blend; identity rests on the full fatty-acid profile, the oil load and the oxidation values agreeing with the source.

Four layers of identity

Identity is a chain, not a single test. The first layer is documentary: the species, the plant part, the supplier, the lot and the chain from the seed to the powder. The second is physical: appearance, colour, odour, flow and particle size. The third is chemical: the fatty-acid profile by GC, the GLA and linoleic figures, and the sterol pattern where a source is disputed. The fourth is oxidation: PV and p-AV, because a fresh oil and an aged oil can share a fatty-acid profile.

No single layer is sufficient. A certificate can carry the right species name and the wrong oil; a GC profile can be matched by a blend; a physical check can pass on an oxidised powder. The layers have to agree, and they have to belong to the same lot.

The GLA/linoleic ratio and the full profile

Evening primrose oil is linoleic-rich: linoleic acid is about 70–75% of the oil and GLA about 8–11%, a ratio of roughly seven to one. Borage oil is about 35–40% linoleic and 18–23% GLA, a ratio of roughly two to one. Blackcurrant oil sits around 40–45% linoleic and 14–19% GLA, and it carries alpha-linolenic and stearidonic acids that the other two do not.

The ratio is harder to fake than the GLA figure. A borage oil diluted with sunflower oil can be pushed to 10% GLA, but the linoleic and oleic figures move with the diluent, and the sterol pattern changes. An evening primrose oil cut with another GLA oil shows the same kind of shift. The full profile is the evidence; the GLA figure is the headline.

Typical fatty-acid markers that separate the three GLA oils
MarkerEvening primroseBorageBlackcurrant
GLA8–11%18–23%14–19%
Linoleic70–75%35–40%40–45%
Oleic8–12%15–20%10–13%
Alpha-linolenicLowLow12–14%
StearidonicTraceTrace2–4%
Linoleic:GLAAbout 7:1About 2:1About 2.5:1

The ranges are typical, not specifications. The certificate should carry the measured profile for the lot.

What XRD can and cannot show

The powder is mostly carrier. X-ray diffraction sees the crystalline part of the modified starch, not the oil. The oil is amorphous and does not produce the sharp reflections that XRD identifies; the starch does. An XRD pattern can confirm that the carrier is a starch with a particular crystalline type, and it can show that a crystalline foreign phase is absent. It cannot prove that the oil is evening primrose oil.

Read an “XRD identity” line on a powder COA as a carrier check, not an oil identity check. The oil identity belongs to the GC section. If a supplier offers a spectral fingerprint as identity evidence, ask which phase the method measures and which reference it compares against. A method that sees only the carrier cannot answer the source question.

This is not a criticism of XRD. It is the right tool for the crystalline carrier and the wrong tool for a liquid oil dispersed in it. The certificate should say what each method measures.

The routes that matter

Four routes are worth testing. The first is a different GLA oil or a blend: borage or blackcurrant oil, or a blend of either with another oil, used to hit the GLA range. The second is a lower oil load than declared: more carrier, less oil, so the powder carries less GLA than the declaration implies, even when the oil is genuine. The third is oxidised oil: the GLA assay can stay in range while PV and p-AV climb. The fourth is a non-EPO oil with added GLA or a GLA concentrate, which can hit the figure without the evening primrose profile.

The checks follow the routes. Full fatty-acid profile by GC, with the chromatogram; oil load by extraction; PV and p-AV by named methods; the sterol profile where a blend is suspected; and the colour and odour as a first screen. A single GLA result answers none of the four.

Writing identity into the specification

Write the species and the plant part, not only the common name: “evening primrose (Oenothera biennis) seed oil.” Add the oil load, the GLA range and its basis, the fatty-acid profile with typical ranges, the sterol profile if the customer requires it, PV and p-AV, moisture, carrier and mesh. State the identity method: GC-FID of the fatty-acid methyl esters, with peak identification against a certified standard and a column that resolves GLA from alpha-linolenic acid.

A specification that says “GLA 10% powder” or “omega-6 powder” does not name the source. A specification that says “evening primrose oil powder 40%” without a profile does not give the laboratory a way to check the source. The two together do.

The certificate should repeat the species, the oil load and the measured profile, and the lot code should match the pack and the retained sample. A certificate that cannot be tied to the bag is a document, not a trace.

Five questions for a supplier

  1. Which species and which plant part is the oil from, and is the oil single-source or a blend?
  2. What is the GLA on the oil, and what are the linoleic, oleic, palmitic and stearic figures on the same lot?
  3. What is the oil load, the carrier and the microencapsulation route, and is the oil load measured or calculated?
  4. What are the PV and p-AV, with methods, and what is the oil's storage history before encapsulation?
  5. Can you send the chromatogram, the sterol data where available, and the COA for the lot that will ship?

The catalog limits are on the evening primrose oil powder product page. The certificate lines are on the COA page, the source comparison is on the grades page and the EPO versus borage page, and the market rules are on the compliance page. The analytical methods index covers the chromatographic and elemental tests behind the file.

Send the specification you intend to use — grade, quantity and destination market — and we will reply with the batch COA, the technical data sheet and a quotation.

Request a quotation