Dosage form note · tablets

Tablets

Compaction begins with particle size and ends with a clean press

The brief

Tablet compression asks for a powder that flows, packs and releases from the die without sticking, and magnesium bisglycinate is specified around those demands rather than around its magnesium figure alone. A bulk density of 0.55–0.90 g/mL, a 40-mesh particle size and a loss on drying of no more than 2.0% set the starting point for a direct-compression or granulated blend. The 5% suspension is alkaline, so the binder, lubricant and coating system have to be checked against pH. The label also fixes the form: a 1:2 chelate cannot be swapped for a buffered blend without changing the ingredient declaration. Rainwood supplies the powder only.

Direct-compression tabletsRoller-compacted (dry-granulated) tabletsWet-granulated tabletsChewable tabletsFilm-coated tablets

Matched ingredients

What changes in this format

Three constraints, one grade decision.

The same powder can pass one constraint and fail another. The trial should test all three.

Compaction needs density and surface area

A powder that is too fine may compress into a hard, slow-disintegrating tablet, while a coarse grade can cap or laminate. Bulk density and particle size distribution should be read together with the compression force used on the press. A bench trial on the grade that will ship is the only way to settle the combination.

Granulation changes the powder, not the assay

Roller compaction and wet granulation improve flow and reduce dust, but they add a process step that has to be validated. A granulated grade may contain a binder that is absent from the certificate's chemistry section. Ask for the granulation aids and the assay on the granulated material, not on the base powder.

Alkaline pH meets tablet excipients

The 5% suspension sits at pH 8.5–11.5, so acidic binders, some colourants and certain coating systems need a compatibility check. Sticking and picking can follow from an alkaline surface and high compression speed. The pH belongs in the excipient compatibility work, not only in the ingredient specification.

Label arithmetic on a fixed tablet weight

At a 14% assay, 100 mg of elemental magnesium occupies about 710 mg of the tablet mass, before filler, binder and lubricant. A 500 mg tablet therefore cannot carry that claim on the chelate alone. The form, the tablet weight and the label claim have to be designed together.

Ingredients for this application

Starting points, not a shortlist limit.

Every grade is quoted against the specification and the process, not against the application label.

Next step

Describe the finished product. We will name the grade.

The dose, the process step, the taste and the destination are enough to start a specification review.